Canon Digital IXUS v3 vs. Sony Cyber-shot DSC-WX50

Comparison

change cameras »
Digital IXUS v3 image
vs
Cyber-shot DSC-WX50 image
Canon Digital IXUS v3 Sony Cyber-shot DSC-WX50
check price » check price »
Megapixels
3.20
16.80
Max. image resolution
2048 x 1536
4608 x 3456

Sensor

Sensor type
CCD
CMOS
Sensor size
1/2.7" (~ 5.33 x 4 mm)
1/2.3" (~ 6.16 x 4.62 mm)
Sensor resolution
2063 x 1551
4727 x 3554
Diagonal
6.66 mm
7.70 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1.33
(ratio)
Canon Digital IXUS v3 Sony Cyber-shot DSC-WX50
Surface area:
21.32 mm² vs 28.46 mm²
Difference: 7.14 mm² (33%)
WX50 sensor is approx. 1.33x bigger than IXUS v3 sensor.
Note: You are comparing sensors of very different generations. There is a gap of 10 years between Canon IXUS v3 (2002) and Sony WX50 (2012). Ten years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.
Pixel pitch
2.58 µm
1.3 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 1.28 µm (98%)
Pixel pitch of IXUS v3 is approx. 98% higher than pixel pitch of WX50.
Pixel area
6.66 µm²
1.69 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 4.97 µm² (294%)
A pixel on Canon IXUS v3 sensor is approx. 294% bigger than a pixel on Sony WX50.
Pixel density
14.98 MP/cm²
58.89 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 43.91 µm (293%)
Sony WX50 has approx. 293% higher pixel density than Canon IXUS v3.
To learn about the accuracy of these numbers, click here.



Specs

Canon IXUS v3
Sony WX50
Crop factor
6.5
5.62
Total megapixels
3.30
Effective megapixels
3.20
Optical zoom
2x
5x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 50, 100, 200, 400
Auto, 100, 200, 400, 800, 1600, 3200, 6400, 12800
RAW
Manual focus
Normal focus range
47 cm
60 cm
Macro focus range
10 cm
3 cm
Focal length (35mm equiv.)
35 - 70 mm
25 - 125 mm
Aperture priority
No
No
Max. aperture
f2.8 - f4.0
f2.6 - f6.3
Max. aperture (35mm equiv.)
f18.2 - f26
f14.6 - f35.4
Metering
Multi, Center-weighted, Spot
Centre weighted, Multi-segment, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
No
Min. shutter speed
15 sec
4 sec
Max. shutter speed
1/1500 sec
1/1600 sec
Built-in flash
External flash
Viewfinder
Optical (tunnel)
None
White balance presets
6
7
Screen size
1.5"
2.7"
Screen resolution
120,000 dots
460,800 dots
Video capture
Max. video resolution
Storage types
Compact Flash (Type I)
Memory Stick Duo, Memory Stick Pro Duo, SDHC, SDXC, Secure Digital
USB
USB 1.0
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Canon Lithium-Ion
Lithium-Ion NP-BN battery
Weight
250 g
117 g
Dimensions
87 x 57 x 27 mm
92 x 52 x 19 mm
Year
2002
2012




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Canon IXUS v3 diagonal

The diagonal of IXUS v3 sensor is not 1/2.7 or 0.37" (9.4 mm) as you might expect, but approximately two thirds of that value - 6.66 mm. If you want to know why, see sensor sizes.

w = 5.33 mm
h = 4.00 mm
Diagonal =  5.33² + 4.00²   = 6.66 mm

Sony WX50 diagonal

The diagonal of WX50 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm
Diagonal =  6.16² + 4.62²   = 7.70 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

IXUS v3 sensor area

Width = 5.33 mm
Height = 4.00 mm

Surface area = 5.33 × 4.00 = 21.32 mm²

WX50 sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

IXUS v3 pixel pitch

Sensor width = 5.33 mm
Sensor resolution width = 2063 pixels
Pixel pitch =   5.33  × 1000  = 2.58 µm
2063

WX50 pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 4727 pixels
Pixel pitch =   6.16  × 1000  = 1.3 µm
4727


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

IXUS v3 pixel area

Pixel pitch = 2.58 µm

Pixel area = 2.58² = 6.66 µm²

WX50 pixel area

Pixel pitch = 1.3 µm

Pixel area = 1.3² = 1.69 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

IXUS v3 pixel density

Sensor resolution width = 2063 pixels
Sensor width = 0.533 cm

Pixel density = (2063 / 0.533)² / 1000000 = 14.98 MP/cm²

WX50 pixel density

Sensor resolution width = 4727 pixels
Sensor width = 0.616 cm

Pixel density = (4727 / 0.616)² / 1000000 = 58.89 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

IXUS v3 sensor resolution

Sensor width = 5.33 mm
Sensor height = 4.00 mm
Effective megapixels = 3.20
r = 5.33/4.00 = 1.33
X =  3.20 × 1000000  = 1551
1.33
Resolution horizontal: X × r = 1551 × 1.33 = 2063
Resolution vertical: X = 1551

Sensor resolution = 2063 x 1551

WX50 sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 16.80
r = 6.16/4.62 = 1.33
X =  16.80 × 1000000  = 3554
1.33
Resolution horizontal: X × r = 3554 × 1.33 = 4727
Resolution vertical: X = 3554

Sensor resolution = 4727 x 3554


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


IXUS v3 crop factor

Sensor diagonal in mm = 6.66 mm
Crop factor =   43.27  = 6.5
6.66

WX50 crop factor

Sensor diagonal in mm = 7.70 mm
Crop factor =   43.27  = 5.62
7.70

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

IXUS v3 equivalent aperture

Crop factor = 6.5
Aperture = f2.8 - f4.0

35-mm equivalent aperture = (f2.8 - f4.0) × 6.5 = f18.2 - f26

WX50 equivalent aperture

Crop factor = 5.62
Aperture = f2.6 - f6.3

35-mm equivalent aperture = (f2.6 - f6.3) × 5.62 = f14.6 - f35.4

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.