Canon EOS Digital Rebel vs. Canon EOS 6D Mark II

Comparison

change cameras »
EOS Digital Rebel image
vs
EOS 6D Mark II image
Canon EOS Digital Rebel Canon EOS 6D Mark II
check price » check price »
Megapixels
6.30
26.20
Max. image resolution
3072 x 2048
6240 x 4160

Sensor

Sensor type
CMOS
CMOS
Sensor size
22.7 x 15.1 mm
35.9 x 24 mm
Sensor resolution
3074 x 2049
6269 x 4179
Diagonal
27.26 mm
43.18 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 2.51
(ratio)
Canon EOS Digital Rebel Canon EOS 6D Mark II
Surface area:
342.77 mm² vs 861.60 mm²
Difference: 518.83 mm² (151%)
6D Mark II sensor is approx. 2.51x bigger than Digital Rebel sensor.
Note: You are comparing sensors of vastly different generations. There is a gap of 14 years between Canon Digital Rebel (2003) and Canon 6D Mark II (2017). Fourteen years is a huge amount of time, technology wise, resulting in newer sensor being much more efficient than the older one.
Pixel pitch
7.38 µm
5.73 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 1.65 µm (29%)
Pixel pitch of Digital Rebel is approx. 29% higher than pixel pitch of 6D Mark II.
Pixel area
54.46 µm²
32.83 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 21.63 µm² (66%)
A pixel on Canon Digital Rebel sensor is approx. 66% bigger than a pixel on Canon 6D Mark II.
Pixel density
1.83 MP/cm²
3.05 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 1.22 µm (67%)
Canon 6D Mark II has approx. 67% higher pixel density than Canon Digital Rebel.
To learn about the accuracy of these numbers, click here.



Specs

Canon Digital Rebel
Canon 6D Mark II
Crop factor
1.59
1
Total megapixels
6.34
27.10
Effective megapixels
6.30
26.20
Optical zoom
 
Digital zoom
No
ISO sensitivity
Auto, 100, 200, 400, 800, 1600
Auto, 100-40000 (expandable to 50-102400)
RAW
Manual focus
Normal focus range
Macro focus range
Focal length (35mm equiv.)
Aperture priority
Yes
Yes
Max. aperture
Max. aperture (35mm equiv.)
n/a
n/a
Metering
Centre weighted, Matrix, Spot
Multi, Center-weighted, Spot, Partial
Exposure compensation
±2 EV (in 1/3 EV steps)
±5 EV (in 1/3 EV, 1/2 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
30 sec
30 sec
Max. shutter speed
1/4000 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
Optical (pentamirror)
Optical (pentaprism)
White balance presets
6
6
Screen size
1.8"
3"
Screen resolution
118,000 dots
1,040,000 dots
Video capture
Max. video resolution
1920x1080 (60p/50p/30p/25p/24p)
Storage types
CompactFlash type I, CompactFlash type II, Microdrive
SD/SDHC/SDXC
USB
USB 1.0
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Canon 1100mAh Li-Ion
LP-E6N lithium-ion battery
Weight
645 g
765 g
Dimensions
142 x 99 x 73 mm
144 x 110.5 x 74.8 mm
Year
2003
2017




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Canon Digital Rebel diagonal

w = 22.70 mm
h = 15.10 mm
Diagonal =  22.70² + 15.10²   = 27.26 mm

Canon 6D Mark II diagonal

w = 35.90 mm
h = 24.00 mm
Diagonal =  35.90² + 24.00²   = 43.18 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

Digital Rebel sensor area

Width = 22.70 mm
Height = 15.10 mm

Surface area = 22.70 × 15.10 = 342.77 mm²

6D Mark II sensor area

Width = 35.90 mm
Height = 24.00 mm

Surface area = 35.90 × 24.00 = 861.60 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

Digital Rebel pixel pitch

Sensor width = 22.70 mm
Sensor resolution width = 3074 pixels
Pixel pitch =   22.70  × 1000  = 7.38 µm
3074

6D Mark II pixel pitch

Sensor width = 35.90 mm
Sensor resolution width = 6269 pixels
Pixel pitch =   35.90  × 1000  = 5.73 µm
6269


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

Digital Rebel pixel area

Pixel pitch = 7.38 µm

Pixel area = 7.38² = 54.46 µm²

6D Mark II pixel area

Pixel pitch = 5.73 µm

Pixel area = 5.73² = 32.83 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

Digital Rebel pixel density

Sensor resolution width = 3074 pixels
Sensor width = 2.27 cm

Pixel density = (3074 / 2.27)² / 1000000 = 1.83 MP/cm²

6D Mark II pixel density

Sensor resolution width = 6269 pixels
Sensor width = 3.59 cm

Pixel density = (6269 / 3.59)² / 1000000 = 3.05 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

Digital Rebel sensor resolution

Sensor width = 22.70 mm
Sensor height = 15.10 mm
Effective megapixels = 6.30
r = 22.70/15.10 = 1.5
X =  6.30 × 1000000  = 2049
1.5
Resolution horizontal: X × r = 2049 × 1.5 = 3074
Resolution vertical: X = 2049

Sensor resolution = 3074 x 2049

6D Mark II sensor resolution

Sensor width = 35.90 mm
Sensor height = 24.00 mm
Effective megapixels = 26.20
r = 35.90/24.00 = 1.5
X =  26.20 × 1000000  = 4179
1.5
Resolution horizontal: X × r = 4179 × 1.5 = 6269
Resolution vertical: X = 4179

Sensor resolution = 6269 x 4179


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


Digital Rebel crop factor

Sensor diagonal in mm = 27.26 mm
Crop factor =   43.27  = 1.59
27.26

6D Mark II crop factor

Sensor diagonal in mm = 43.18 mm
Crop factor =   43.27  = 1
43.18

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

Digital Rebel equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Canon Digital Rebel, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Canon Digital Rebel is 1.59

6D Mark II equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Canon 6D Mark II, take the aperture of the lens you're using and multiply it with crop factor.

Since crop factor for Canon 6D Mark II is 1, the equivalent aperture is aperture.

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.