Canon IXY DIGITAL 3000 IS vs. Fujifilm X-T200

Comparison

change cameras »
IXY DIGITAL 3000 IS image
vs
X-T200 image
Canon IXY DIGITAL 3000 IS Fujifilm X-T200
check price » check price »
Megapixels
14.70
24.20
Max. image resolution
4416 x 3312
6000 x 4000

Sensor

Sensor type
CCD
CMOS
Sensor size
1/1.7" (~ 7.53 x 5.64 mm)
23.5 x 15.7 mm
Sensor resolution
4438 x 3312
6026 x 4017
Diagonal
9.41 mm
28.26 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 8.69
(ratio)
Canon IXY DIGITAL 3000 IS Fujifilm X-T200
Surface area:
42.47 mm² vs 368.95 mm²
Difference: 326.48 mm² (769%)
X-T200 sensor is approx. 8.69x bigger than IXY DIGITAL 3000 IS sensor.
Note: You are comparing sensors of vastly different generations. There is a gap of 12 years between Canon IXY DIGITAL 3000 IS (2008) and Fujifilm X-T200 (2020). Twelve years is a huge amount of time, technology wise, resulting in newer sensor being much more efficient than the older one.
Pixel pitch
1.7 µm
3.9 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 2.2 µm (129%)
Pixel pitch of X-T200 is approx. 129% higher than pixel pitch of IXY DIGITAL 3000 IS.
Pixel area
2.89 µm²
15.21 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 12.32 µm² (426%)
A pixel on Fujifilm X-T200 sensor is approx. 426% bigger than a pixel on Canon IXY DIGITAL 3000 IS.
Pixel density
34.74 MP/cm²
6.58 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 28.16 µm (428%)
Canon IXY DIGITAL 3000 IS has approx. 428% higher pixel density than Fujifilm X-T200.
To learn about the accuracy of these numbers, click here.



Specs

Canon IXY DIGITAL 3000 IS
Fujifilm X-T200
Crop factor
4.6
1.53
Total megapixels
Effective megapixels
14.70
24.20
Optical zoom
3.7x
Digital zoom
Yes
No
ISO sensitivity
Auto, 80 ,100, 200, 400, 800, 1600
Auto, 200-12800 (extends to 100-51200)
RAW
Manual focus
Normal focus range
50 cm
Macro focus range
5 cm
Focal length (35mm equiv.)
36 - 133 mm
Aperture priority
No
Yes
Max. aperture
f2.8 - f5.8
Max. aperture (35mm equiv.)
f12.9 - f26.7
n/a
Metering
Multi, Center-weighted, Spot
Multi, Average, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±5 EV (in 1/3 EV steps)
Shutter priority
No
Yes
Min. shutter speed
15 sec
30 sec
Max. shutter speed
1/1600 sec
1/32000 sec
Built-in flash
External flash
Viewfinder
Optical (tunnel)
Electronic
White balance presets
5
7
Screen size
2.5"
3.5"
Screen resolution
230,000 dots
2,760,000 dots
Video capture
Max. video resolution
3840x2160 (30p/​25p/​24p/​23.98p)
Storage types
SD/SDHC/MMC card
SD/SDHC/SDXC
USB
USB 2.0 (480 Mbit/sec)
USB 3.0 (5 GBit/sec)
HDMI
Wireless
GPS
Battery
Lithium-Ion NB-5L battery
NP-W126S lithium-ion battery
Weight
205 g
370 g
Dimensions
98 x 62 x 28 mm
121 x 83.7 x 55.1 mm
Year
2008
2020




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Canon IXY DIGITAL 3000 IS diagonal

The diagonal of IXY DIGITAL 3000 IS sensor is not 1/1.7 or 0.59" (14.9 mm) as you might expect, but approximately two thirds of that value - 9.41 mm. If you want to know why, see sensor sizes.

w = 7.53 mm
h = 5.64 mm
Diagonal =  7.53² + 5.64²   = 9.41 mm

Fujifilm X-T200 diagonal

w = 23.50 mm
h = 15.70 mm
Diagonal =  23.50² + 15.70²   = 28.26 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

IXY DIGITAL 3000 IS sensor area

Width = 7.53 mm
Height = 5.64 mm

Surface area = 7.53 × 5.64 = 42.47 mm²

X-T200 sensor area

Width = 23.50 mm
Height = 15.70 mm

Surface area = 23.50 × 15.70 = 368.95 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

IXY DIGITAL 3000 IS pixel pitch

Sensor width = 7.53 mm
Sensor resolution width = 4438 pixels
Pixel pitch =   7.53  × 1000  = 1.7 µm
4438

X-T200 pixel pitch

Sensor width = 23.50 mm
Sensor resolution width = 6026 pixels
Pixel pitch =   23.50  × 1000  = 3.9 µm
6026


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

IXY DIGITAL 3000 IS pixel area

Pixel pitch = 1.7 µm

Pixel area = 1.7² = 2.89 µm²

X-T200 pixel area

Pixel pitch = 3.9 µm

Pixel area = 3.9² = 15.21 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

IXY DIGITAL 3000 IS pixel density

Sensor resolution width = 4438 pixels
Sensor width = 0.753 cm

Pixel density = (4438 / 0.753)² / 1000000 = 34.74 MP/cm²

X-T200 pixel density

Sensor resolution width = 6026 pixels
Sensor width = 2.35 cm

Pixel density = (6026 / 2.35)² / 1000000 = 6.58 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

IXY DIGITAL 3000 IS sensor resolution

Sensor width = 7.53 mm
Sensor height = 5.64 mm
Effective megapixels = 14.70
r = 7.53/5.64 = 1.34
X =  14.70 × 1000000  = 3312
1.34
Resolution horizontal: X × r = 3312 × 1.34 = 4438
Resolution vertical: X = 3312

Sensor resolution = 4438 x 3312

X-T200 sensor resolution

Sensor width = 23.50 mm
Sensor height = 15.70 mm
Effective megapixels = 24.20
r = 23.50/15.70 = 1.5
X =  24.20 × 1000000  = 4017
1.5
Resolution horizontal: X × r = 4017 × 1.5 = 6026
Resolution vertical: X = 4017

Sensor resolution = 6026 x 4017


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


IXY DIGITAL 3000 IS crop factor

Sensor diagonal in mm = 9.41 mm
Crop factor =   43.27  = 4.6
9.41

X-T200 crop factor

Sensor diagonal in mm = 28.26 mm
Crop factor =   43.27  = 1.53
28.26

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

IXY DIGITAL 3000 IS equivalent aperture

Crop factor = 4.6
Aperture = f2.8 - f5.8

35-mm equivalent aperture = (f2.8 - f5.8) × 4.6 = f12.9 - f26.7

X-T200 equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Fujifilm X-T200, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Fujifilm X-T200 is 1.53

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.