Fujifilm FinePix S9800 vs. Canon PowerShot SX710 HS

Comparison

change cameras »
FinePix S9800 image
vs
PowerShot SX710 HS image
Fujifilm FinePix S9800 Canon PowerShot SX710 HS
check price » check price »
Megapixels
16.20
20.30
Max. image resolution
4608 x 3456
5184 x 3888

Sensor

Sensor type
CMOS
CMOS
Sensor size
1/2.3" (~ 6.16 x 4.62 mm)
1/2.3" (~ 6.16 x 4.62 mm)
Sensor resolution
4642 x 3490
5196 x 3907
Diagonal
7.70 mm
7.70 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1
(ratio)
Fujifilm FinePix S9800 Canon PowerShot SX710 HS
Surface area:
28.46 mm² vs 28.46 mm²
Difference: 0 mm² (0%)
S9800 and SX710 HS sensors are the same size.
Pixel pitch
1.33 µm
1.19 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.14 µm (12%)
Pixel pitch of S9800 is approx. 12% higher than pixel pitch of SX710 HS.
Pixel area
1.77 µm²
1.42 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 0.35 µm² (25%)
A pixel on Fujifilm S9800 sensor is approx. 25% bigger than a pixel on Canon SX710 HS.
Pixel density
56.79 MP/cm²
71.15 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 14.36 µm (25%)
Canon SX710 HS has approx. 25% higher pixel density than Fujifilm S9800.
To learn about the accuracy of these numbers, click here.



Specs

Fujifilm S9800
Canon SX710 HS
Crop factor
5.62
5.62
Total megapixels
16.79
21.10
Effective megapixels
16.20
20.30
Optical zoom
50x
30x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 100-12800
Auto, 80-3200
RAW
Manual focus
Normal focus range
40 cm
5 cm
Macro focus range
7 cm
1 cm
Focal length (35mm equiv.)
24 - 1200 mm
25 - 750 mm
Aperture priority
Yes
Yes
Max. aperture
f2.9 - f6.5
f3.2 - f6.9
Max. aperture (35mm equiv.)
f16.3 - f36.5
f18 - f38.8
Metering
Multi, Spot, Average
Multi, Center-weighted, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
8 sec
15 sec
Max. shutter speed
1/1700 sec
1/3200 sec
Built-in flash
External flash
Viewfinder
Electronic
None
White balance presets
6
5
Screen size
3"
3"
Screen resolution
460,000 dots
922,000 dots
Video capture
Max. video resolution
1920x1080 (60i)
1920x1080 (60p/30p)
Storage types
SD/SDHC/SDXC
SD/SDHC/SDXC
USB
USB 2.0 (480 Mbit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
4xAA type batteries
Battery Pack NB-6LH
Weight
670 g
269 g
Dimensions
122.6 x 86.9 x 116.2 mm
112.7 x 65.8 x 34.8 mm
Year
2015
2015




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Fujifilm S9800 diagonal

The diagonal of S9800 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm
Diagonal =  6.16² + 4.62²   = 7.70 mm

Canon SX710 HS diagonal

The diagonal of SX710 HS sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm
Diagonal =  6.16² + 4.62²   = 7.70 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

S9800 sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²

SX710 HS sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

S9800 pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 4642 pixels
Pixel pitch =   6.16  × 1000  = 1.33 µm
4642

SX710 HS pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 5196 pixels
Pixel pitch =   6.16  × 1000  = 1.19 µm
5196


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

S9800 pixel area

Pixel pitch = 1.33 µm

Pixel area = 1.33² = 1.77 µm²

SX710 HS pixel area

Pixel pitch = 1.19 µm

Pixel area = 1.19² = 1.42 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

S9800 pixel density

Sensor resolution width = 4642 pixels
Sensor width = 0.616 cm

Pixel density = (4642 / 0.616)² / 1000000 = 56.79 MP/cm²

SX710 HS pixel density

Sensor resolution width = 5196 pixels
Sensor width = 0.616 cm

Pixel density = (5196 / 0.616)² / 1000000 = 71.15 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

S9800 sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 16.20
r = 6.16/4.62 = 1.33
X =  16.20 × 1000000  = 3490
1.33
Resolution horizontal: X × r = 3490 × 1.33 = 4642
Resolution vertical: X = 3490

Sensor resolution = 4642 x 3490

SX710 HS sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 20.30
r = 6.16/4.62 = 1.33
X =  20.30 × 1000000  = 3907
1.33
Resolution horizontal: X × r = 3907 × 1.33 = 5196
Resolution vertical: X = 3907

Sensor resolution = 5196 x 3907


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


S9800 crop factor

Sensor diagonal in mm = 7.70 mm
Crop factor =   43.27  = 5.62
7.70

SX710 HS crop factor

Sensor diagonal in mm = 7.70 mm
Crop factor =   43.27  = 5.62
7.70

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

S9800 equivalent aperture

Crop factor = 5.62
Aperture = f2.9 - f6.5

35-mm equivalent aperture = (f2.9 - f6.5) × 5.62 = f16.3 - f36.5

SX710 HS equivalent aperture

Crop factor = 5.62
Aperture = f3.2 - f6.9

35-mm equivalent aperture = (f3.2 - f6.9) × 5.62 = f18 - f38.8

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.