Kodak EasyShare C195 vs. Nikon Coolpix L1

Comparison

change cameras »
EasyShare C195 image
vs
Coolpix L1 image
Kodak EasyShare C195 Nikon Coolpix L1
check price » check price »
Megapixels
14.50
6.00
Max. image resolution
4288 x 3216
2816 x 2112

Sensor

Sensor type
CCD
CCD
Sensor size
1/2.3" (~ 6.16 x 4.62 mm)
1/2.5" (~ 5.75 x 4.32 mm)
Sensor resolution
4392 x 3302
2825 x 2124
Diagonal
7.70 mm
7.19 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1.15 : 1
(ratio)
Kodak EasyShare C195 Nikon Coolpix L1
Surface area:
28.46 mm² vs 24.84 mm²
Difference: 3.62 mm² (15%)
C195 sensor is approx. 1.15x bigger than L1 sensor.
Note: You are comparing cameras of different generations. There is a 5 year gap between Kodak C195 (2010) and Nikon L1 (2005). All things being equal, newer sensor generations generally outperform the older.
Pixel pitch
1.4 µm
2.04 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.64 µm (46%)
Pixel pitch of L1 is approx. 46% higher than pixel pitch of C195.
Pixel area
1.96 µm²
4.16 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 2.2 µm² (112%)
A pixel on Nikon L1 sensor is approx. 112% bigger than a pixel on Kodak C195.
Pixel density
50.84 MP/cm²
24.14 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 26.7 µm (111%)
Kodak C195 has approx. 111% higher pixel density than Nikon L1.
To learn about the accuracy of these numbers, click here.



Specs

Kodak C195
Nikon L1
Crop factor
5.62
6.02
Total megapixels
6.20
Effective megapixels
6.00
Optical zoom
Yes
5x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 64, 100, 200, 400, 800, 1000
RAW
Manual focus
Normal focus range
50 cm
50 cm
Macro focus range
10 cm
4 cm
Focal length (35mm equiv.)
33 - 165 mm
38 - 190 mm
Aperture priority
No
No
Max. aperture
f2.9 - f5
Max. aperture (35mm equiv.)
n/a
f17.5 - f30.1
Metering
Centre weighted, Multi-segment
Multi, Center-weighted, Average
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
No
Min. shutter speed
1/4 sec
30 sec
Max. shutter speed
1/1400 sec
1/8000 sec
Built-in flash
External flash
Viewfinder
None
None
White balance presets
5
7
Screen size
3"
2.5"
Screen resolution
230,000 dots
115,000 dots
Video capture
Max. video resolution
Storage types
SDHC, Secure Digital
Secure Digital
USB
USB 2.0 (480 Mbit/sec)
USB 1.0
HDMI
Wireless
GPS
Battery
2x AA
AA (2) batteries (NiMH recommended)
Weight
177 g
180 g
Dimensions
96.3 x 61.7 x 30.1 mm
89.5 x 60.5 x 47 mm
Year
2010
2005




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Kodak C195 diagonal

The diagonal of C195 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm
Diagonal =  6.16² + 4.62²   = 7.70 mm

Nikon L1 diagonal

The diagonal of L1 sensor is not 1/2.5 or 0.4" (10.2 mm) as you might expect, but approximately two thirds of that value - 7.19 mm. If you want to know why, see sensor sizes.

w = 5.75 mm
h = 4.32 mm
Diagonal =  5.75² + 4.32²   = 7.19 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

C195 sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²

L1 sensor area

Width = 5.75 mm
Height = 4.32 mm

Surface area = 5.75 × 4.32 = 24.84 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

C195 pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 4392 pixels
Pixel pitch =   6.16  × 1000  = 1.4 µm
4392

L1 pixel pitch

Sensor width = 5.75 mm
Sensor resolution width = 2825 pixels
Pixel pitch =   5.75  × 1000  = 2.04 µm
2825


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

C195 pixel area

Pixel pitch = 1.4 µm

Pixel area = 1.4² = 1.96 µm²

L1 pixel area

Pixel pitch = 2.04 µm

Pixel area = 2.04² = 4.16 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

C195 pixel density

Sensor resolution width = 4392 pixels
Sensor width = 0.616 cm

Pixel density = (4392 / 0.616)² / 1000000 = 50.84 MP/cm²

L1 pixel density

Sensor resolution width = 2825 pixels
Sensor width = 0.575 cm

Pixel density = (2825 / 0.575)² / 1000000 = 24.14 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

C195 sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 14.50
r = 6.16/4.62 = 1.33
X =  14.50 × 1000000  = 3302
1.33
Resolution horizontal: X × r = 3302 × 1.33 = 4392
Resolution vertical: X = 3302

Sensor resolution = 4392 x 3302

L1 sensor resolution

Sensor width = 5.75 mm
Sensor height = 4.32 mm
Effective megapixels = 6.00
r = 5.75/4.32 = 1.33
X =  6.00 × 1000000  = 2124
1.33
Resolution horizontal: X × r = 2124 × 1.33 = 2825
Resolution vertical: X = 2124

Sensor resolution = 2825 x 2124


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


C195 crop factor

Sensor diagonal in mm = 7.70 mm
Crop factor =   43.27  = 5.62
7.70

L1 crop factor

Sensor diagonal in mm = 7.19 mm
Crop factor =   43.27  = 6.02
7.19

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

C195 equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Kodak C195, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Kodak C195 is 5.62

L1 equivalent aperture

Crop factor = 6.02
Aperture = f2.9 - f5

35-mm equivalent aperture = (f2.9 - f5) × 6.02 = f17.5 - f30.1

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.