Minolta DiMAGE F200 vs. Kodak EasyShare M550

Comparison

change cameras »

Minolta DiMAGE F200

Kodak EasyShare M550

check price »

Megapixels

4.10

12.30

Max. image resolution

2272 x 1704

4000 x 3000

Sensor

Sensor type

CCD

Sensor size

1/1.8" (~ 7.11 x 5.33 mm)

1/2.3" (~ 6.16 x 4.62 mm)

Sensor resolution

2335 x 1756

4045 x 3041

Diagonal

8.89 mm

7.70 mm

Sensor size comparison

Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »

	vs
1.33	:	1
(ratio)

Minolta DiMAGE F200		Kodak EasyShare M550

Surface area:

37.90 mm²

28.46 mm²

Difference: 9.44 mm² (33%)

DiMAGE F200 sensor is approx. 1.33x bigger than M550 sensor.

Note: You are comparing sensors of very different generations. There is a gap of 7 years between Minolta DiMAGE F200 (2003) and Kodak M550 (2010). Seven years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.

Pixel pitch

3.04 µm

1.52 µm

Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.

Difference: 1.52 µm (100%)

Pixel pitch of DiMAGE F200 is approx. 100% higher than pixel pitch of M550.

Pixel area

9.24 µm²

2.31 µm²

Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.

Relative pixel sizes:

Pixel area difference: 6.93 µm² (300%)

A pixel on Minolta DiMAGE F200 sensor is approx. 300% bigger than a pixel on Kodak M550.

Pixel density

10.79 MP/cm²

43.12 MP/cm²

Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.

Difference: 32.33 µm (300%)

Kodak M550 has approx. 300% higher pixel density than Minolta DiMAGE F200.

To learn about the accuracy of these numbers, click here.

Specs

Minolta DiMAGE F200

Kodak M550

Crop factor

4.87

5.62

Total megapixels

12.70

Effective megapixels

12.30

Optical zoom

Digital zoom

Yes

ISO sensitivity

Auto, 100, 200, 400, 800

Auto, 100 - 1600

RAW

Manual focus

Normal focus range

50 cm

Macro focus range

20 cm

10 cm

Focal length (35mm equiv.)

38 - 114 mm

28 - 140 mm

Aperture priority

Yes

Max. aperture

f2.8 - f4.7

f2.8 - f5.0

Max. aperture (35mm equiv.)

f13.6 - f22.9

f15.7 - f28.1

Metering

Centre weighted, Multi-segment, Spot

Multi, Center-weighted, Spot

Exposure compensation

±2 EV (in 1/3 EV steps)

Shutter priority

Yes

Min. shutter speed

15 sec

30 sec

Max. shutter speed

1/1000 sec

1/1400 sec

Built-in flash

External flash

Viewfinder

Optical (tunnel)

None

White balance presets

Screen size

1.5"

2.7"

Screen resolution

110,000 dots

230,000 dots

Video capture

Max. video resolution

Storage types

MultiMedia, Secure Digital

SDHC, Secure Digital

USB

USB 1.0

USB 2.0 (480 Mbit/sec)

HDMI

Wireless

GPS

Battery

AA (2) batteries (NiMH recommended)

Rechargeable Battery KLIC-7006

Weight

245 g

125 g

Dimensions

111 x 52 x 32 mm

98 x 58 x 23 mm

Year

2003

2010

Choose cameras to compare

Popular comparisons:

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:

Diagonal = √

w² + h²

where w = sensor width and h = sensor height

Minolta DiMAGE F200 diagonal

The diagonal of DiMAGE F200 sensor is not 1/1.8 or 0.56" (14.1 mm) as you might expect, but approximately two thirds of that value - 8.89 mm. If you want to know why, see sensor sizes.

w = 7.11 mm
h = 5.33 mm

Diagonal = √

7.11² + 5.33²

= 8.89 mm

Kodak M550 diagonal

The diagonal of M550 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm

Diagonal = √

6.16² + 4.62²

= 7.70 mm

Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

DiMAGE F200 sensor area

Width = 7.11 mm
Height = 5.33 mm

Surface area = 7.11 × 5.33 = 37.90 mm²

M550 sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²

Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:

Pixel pitch =	sensor width in mm	× 1000
	sensor resolution width in pixels

DiMAGE F200 pixel pitch

Sensor width = 7.11 mm
Sensor resolution width = 2335 pixels

Pixel pitch =	7.11	× 1000	= 3.04 µm
	2335

M550 pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 4045 pixels

Pixel pitch =	6.16	× 1000	= 1.52 µm
	4045

Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:

Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:

Pixel area =	sensor surface area in mm²
	effective megapixels

DiMAGE F200 pixel area

Pixel pitch = 3.04 µm

Pixel area = 3.04² = 9.24 µm²

M550 pixel area

Pixel pitch = 1.52 µm

Pixel area = 1.52² = 2.31 µm²

Pixel density

Pixel density can be calculated with the following formula:

Pixel density = (	sensor resolution width in pixels	)² / 1000000
	sensor width in cm

One could also use this formula:

Pixel density =	effective megapixels × 1000000	/ 10000
	sensor surface area in mm²

DiMAGE F200 pixel density

Sensor resolution width = 2335 pixels
Sensor width = 0.711 cm

Pixel density = (2335 / 0.711)² / 1000000 = 10.79 MP/cm²

M550 pixel density

Sensor resolution width = 4045 pixels
Sensor width = 0.616 cm

Pixel density = (4045 / 0.616)² / 1000000 = 43.12 MP/cm²

Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:

(X × r) × X = effective megapixels × 1000000 →

X = √	effective megapixels × 1000000
	r

3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

DiMAGE F200 sensor resolution

Sensor width = 7.11 mm
Sensor height = 5.33 mm
Effective megapixels = 4.10

r = 7.11/5.33 = 1.33

X = √	4.10 × 1000000	= 1756
	1.33

Resolution horizontal: X × r = 1756 × 1.33 = 2335
Resolution vertical: X = 1756

Sensor resolution = 2335 x 1756

M550 sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 12.30

r = 6.16/4.62 = 1.33

X = √	12.30 × 1000000	= 3041
	1.33

Resolution horizontal: X × r = 3041 × 1.33 = 4045
Resolution vertical: X = 3041

Sensor resolution = 4045 x 3041

Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.

Crop factor =	43.27 mm
	sensor diagonal in mm

DiMAGE F200 crop factor

Sensor diagonal in mm = 8.89 mm

Crop factor =	43.27	= 4.87
	8.89

M550 crop factor

Sensor diagonal in mm = 7.70 mm

Crop factor =	43.27	= 5.62
	7.70

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

DiMAGE F200 equivalent aperture

Crop factor = 4.87
Aperture = f2.8 - f4.7

35-mm equivalent aperture = (f2.8 - f4.7) × 4.87 = f13.6 - f22.9

M550 equivalent aperture

Crop factor = 5.62
Aperture = f2.8 - f5.0

35-mm equivalent aperture = (f2.8 - f5.0) × 5.62 = f15.7 - f28.1

Enter your screen size (diagonal)

My screen size is inches

Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.