Nikon Coolpix P1000 vs. Canon PowerShot G1 X Mark III

Comparison

change cameras »
Coolpix P1000 image
vs
PowerShot G1 X Mark III image
Nikon Coolpix P1000 Canon PowerShot G1 X Mark III
check price » check price »
Megapixels
16.00
24.20
Max. image resolution
4608 x 3456
6000 x 4000

Sensor

Sensor type
CMOS
CMOS
Sensor size
1/2.3" (~ 6.16 x 4.62 mm)
22.3 x 14.9 mm
Sensor resolution
4612 x 3468
6026 x 4017
Diagonal
7.70 mm
26.82 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 11.67
(ratio)
Nikon Coolpix P1000 Canon PowerShot G1 X Mark III
Surface area:
28.46 mm² vs 332.27 mm²
Difference: 303.81 mm² (1067%)
G1 X Mark III sensor is approx. 11.67x bigger than P1000 sensor.
Pixel pitch
1.34 µm
3.7 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 2.36 µm (176%)
Pixel pitch of G1 X Mark III is approx. 176% higher than pixel pitch of P1000.
Pixel area
1.8 µm²
13.69 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 11.89 µm² (661%)
A pixel on Canon G1 X Mark III sensor is approx. 661% bigger than a pixel on Nikon P1000.
Pixel density
56.06 MP/cm²
7.3 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 48.76 µm (668%)
Nikon P1000 has approx. 668% higher pixel density than Canon G1 X Mark III.
To learn about the accuracy of these numbers, click here.



Specs

Nikon P1000
Canon G1 X Mark III
Crop factor
5.62
1.61
Total megapixels
16.79
25.80
Effective megapixels
16.00
24.20
Optical zoom
125x
3x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 100-6400
Auto, 100-25600
RAW
Manual focus
Normal focus range
30 cm
10 cm
Macro focus range
1 cm
10 cm
Focal length (35mm equiv.)
24 - 3000 mm
24 - 72 mm
Aperture priority
Yes
Yes
Max. aperture
f2.8 - f8
f2.8 - f5.6
Max. aperture (35mm equiv.)
f15.7 - f45
f4.5 - f9
Metering
Multi, Center-weighted, Spot
Multi, Center-weighted, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±3 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
30 sec
30 sec
Max. shutter speed
1/4000 sec
1/2000 sec
Built-in flash
External flash
Viewfinder
Electronic
Electronic
White balance presets
5
7
Screen size
3.2"
3"
Screen resolution
921,600 dots
1,040,000 dots
Video capture
Max. video resolution
3840x2160 (30p/25p)
1920x1080 (60p/50p/30p/25p/24p)
Storage types
SD/SDHC/SDXC
SD/SDHC/SDXC
USB
USB 2.0 (480 Mbit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
EN-EL20a lithium-ion battery
NB-13L lithium-ion battery
Weight
1415 g
399 g
Dimensions
146.3 x 118.8 x 181.3 mm
115 x 77.9 x 51.4 mm
Year
2018
2017




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Nikon P1000 diagonal

The diagonal of P1000 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm
Diagonal =  6.16² + 4.62²   = 7.70 mm

Canon G1 X Mark III diagonal

w = 22.30 mm
h = 14.90 mm
Diagonal =  22.30² + 14.90²   = 26.82 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

P1000 sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²

G1 X Mark III sensor area

Width = 22.30 mm
Height = 14.90 mm

Surface area = 22.30 × 14.90 = 332.27 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

P1000 pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 4612 pixels
Pixel pitch =   6.16  × 1000  = 1.34 µm
4612

G1 X Mark III pixel pitch

Sensor width = 22.30 mm
Sensor resolution width = 6026 pixels
Pixel pitch =   22.30  × 1000  = 3.7 µm
6026


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

P1000 pixel area

Pixel pitch = 1.34 µm

Pixel area = 1.34² = 1.8 µm²

G1 X Mark III pixel area

Pixel pitch = 3.7 µm

Pixel area = 3.7² = 13.69 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

P1000 pixel density

Sensor resolution width = 4612 pixels
Sensor width = 0.616 cm

Pixel density = (4612 / 0.616)² / 1000000 = 56.06 MP/cm²

G1 X Mark III pixel density

Sensor resolution width = 6026 pixels
Sensor width = 2.23 cm

Pixel density = (6026 / 2.23)² / 1000000 = 7.3 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

P1000 sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 16.00
r = 6.16/4.62 = 1.33
X =  16.00 × 1000000  = 3468
1.33
Resolution horizontal: X × r = 3468 × 1.33 = 4612
Resolution vertical: X = 3468

Sensor resolution = 4612 x 3468

G1 X Mark III sensor resolution

Sensor width = 22.30 mm
Sensor height = 14.90 mm
Effective megapixels = 24.20
r = 22.30/14.90 = 1.5
X =  24.20 × 1000000  = 4017
1.5
Resolution horizontal: X × r = 4017 × 1.5 = 6026
Resolution vertical: X = 4017

Sensor resolution = 6026 x 4017


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


P1000 crop factor

Sensor diagonal in mm = 7.70 mm
Crop factor =   43.27  = 5.62
7.70

G1 X Mark III crop factor

Sensor diagonal in mm = 26.82 mm
Crop factor =   43.27  = 1.61
26.82

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

P1000 equivalent aperture

Crop factor = 5.62
Aperture = f2.8 - f8

35-mm equivalent aperture = (f2.8 - f8) × 5.62 = f15.7 - f45

G1 X Mark III equivalent aperture

Crop factor = 1.61
Aperture = f2.8 - f5.6

35-mm equivalent aperture = (f2.8 - f5.6) × 1.61 = f4.5 - f9

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.