Nikon Coolpix S1 vs. Sony Cyber-shot DSC-W620

Comparison

change cameras »
Coolpix S1 image
vs
Cyber-shot DSC-W620 image
Nikon Coolpix S1 Sony Cyber-shot DSC-W620
check price » check price »
Megapixels
5.00
14.50
Max. image resolution
2592 x 1944
4320 x 3240

Sensor

Sensor type
CCD
CCD
Sensor size
1/2.5" (~ 5.75 x 4.32 mm)
1/2.3" (~ 6.16 x 4.62 mm)
Sensor resolution
2579 x 1939
4392 x 3302
Diagonal
7.19 mm
7.70 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1.15
(ratio)
Nikon Coolpix S1 Sony Cyber-shot DSC-W620
Surface area:
24.84 mm² vs 28.46 mm²
Difference: 3.62 mm² (15%)
W620 sensor is approx. 1.15x bigger than S1 sensor.
Note: You are comparing sensors of very different generations. There is a gap of 7 years between Nikon S1 (2005) and Sony W620 (2012). Seven years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.
Pixel pitch
2.23 µm
1.4 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.83 µm (59%)
Pixel pitch of S1 is approx. 59% higher than pixel pitch of W620.
Pixel area
4.97 µm²
1.96 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 3.01 µm² (154%)
A pixel on Nikon S1 sensor is approx. 154% bigger than a pixel on Sony W620.
Pixel density
20.12 MP/cm²
50.84 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 30.72 µm (153%)
Sony W620 has approx. 153% higher pixel density than Nikon S1.
To learn about the accuracy of these numbers, click here.



Specs

Nikon S1
Sony W620
Crop factor
6.02
5.62
Total megapixels
5.20
Effective megapixels
5.00
Optical zoom
3x
5x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 50, 100, 200, 400
Auto, 100, 200, 400, 800, 1600, 3200
RAW
Manual focus
Normal focus range
30 cm
45 cm
Macro focus range
4 cm
5 cm
Focal length (35mm equiv.)
35 - 105 mm
28 - 140 mm
Aperture priority
No
No
Max. aperture
f3 - f5.4
f3.2 - f6.5
Max. aperture (35mm equiv.)
f18.1 - f32.5
f18 - f36.5
Metering
256-segment Matrix, Centre weighted, Spot, Spot-AF
Centre weighted, Multi-segment, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
No
Min. shutter speed
2 sec
2 sec
Max. shutter speed
1/350 sec
1/1600 sec
Built-in flash
External flash
Viewfinder
None
None
White balance presets
7
6
Screen size
2.5"
2.7"
Screen resolution
110,000 dots
230,400 dots
Video capture
Max. video resolution
Storage types
MultiMedia, Secure Digital
Memory Stick Duo, Memory Stick Pro Duo, SDHC, SDXC, Secure Digital
USB
USB 1.0
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Nikon EN-EL8 Lithium-Ion
Lithium-Ion NP-BN battery
Weight
118 g
116 g
Dimensions
89.9 x 57.5 x 19.7 mm
98 x 56 x 20 mm
Year
2005
2012




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Nikon S1 diagonal

The diagonal of S1 sensor is not 1/2.5 or 0.4" (10.2 mm) as you might expect, but approximately two thirds of that value - 7.19 mm. If you want to know why, see sensor sizes.

w = 5.75 mm
h = 4.32 mm
Diagonal =  5.75² + 4.32²   = 7.19 mm

Sony W620 diagonal

The diagonal of W620 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm
Diagonal =  6.16² + 4.62²   = 7.70 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

S1 sensor area

Width = 5.75 mm
Height = 4.32 mm

Surface area = 5.75 × 4.32 = 24.84 mm²

W620 sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

S1 pixel pitch

Sensor width = 5.75 mm
Sensor resolution width = 2579 pixels
Pixel pitch =   5.75  × 1000  = 2.23 µm
2579

W620 pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 4392 pixels
Pixel pitch =   6.16  × 1000  = 1.4 µm
4392


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

S1 pixel area

Pixel pitch = 2.23 µm

Pixel area = 2.23² = 4.97 µm²

W620 pixel area

Pixel pitch = 1.4 µm

Pixel area = 1.4² = 1.96 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

S1 pixel density

Sensor resolution width = 2579 pixels
Sensor width = 0.575 cm

Pixel density = (2579 / 0.575)² / 1000000 = 20.12 MP/cm²

W620 pixel density

Sensor resolution width = 4392 pixels
Sensor width = 0.616 cm

Pixel density = (4392 / 0.616)² / 1000000 = 50.84 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

S1 sensor resolution

Sensor width = 5.75 mm
Sensor height = 4.32 mm
Effective megapixels = 5.00
r = 5.75/4.32 = 1.33
X =  5.00 × 1000000  = 1939
1.33
Resolution horizontal: X × r = 1939 × 1.33 = 2579
Resolution vertical: X = 1939

Sensor resolution = 2579 x 1939

W620 sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 14.50
r = 6.16/4.62 = 1.33
X =  14.50 × 1000000  = 3302
1.33
Resolution horizontal: X × r = 3302 × 1.33 = 4392
Resolution vertical: X = 3302

Sensor resolution = 4392 x 3302


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


S1 crop factor

Sensor diagonal in mm = 7.19 mm
Crop factor =   43.27  = 6.02
7.19

W620 crop factor

Sensor diagonal in mm = 7.70 mm
Crop factor =   43.27  = 5.62
7.70

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

S1 equivalent aperture

Crop factor = 6.02
Aperture = f3 - f5.4

35-mm equivalent aperture = (f3 - f5.4) × 6.02 = f18.1 - f32.5

W620 equivalent aperture

Crop factor = 5.62
Aperture = f3.2 - f6.5

35-mm equivalent aperture = (f3.2 - f6.5) × 5.62 = f18 - f36.5

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.