Olympus C-3000 Zoom vs. Kodak EasyShare Z1015 IS

Comparison

change cameras »
C-3000 Zoom image
vs
EasyShare Z1015 IS image
Olympus C-3000 Zoom Kodak EasyShare Z1015 IS
check price » check price »
Megapixels
3.10
10.00
Max. image resolution
2048 x 1536
3648 x 2736

Sensor

Sensor type
CCD
CCD
Sensor size
1/1.8" (~ 7.11 x 5.33 mm)
1/2.33" (~ 6.08 x 4.56 mm)
Sensor resolution
2031 x 1527
3647 x 2742
Diagonal
8.89 mm
7.60 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1.37 : 1
(ratio)
Olympus C-3000 Zoom Kodak EasyShare Z1015 IS
Surface area:
37.90 mm² vs 27.72 mm²
Difference: 10.18 mm² (37%)
C-3000 Zoom sensor is approx. 1.37x bigger than Z1015 IS sensor.
Note: You are comparing sensors of very different generations. There is a gap of 8 years between Olympus C-3000 Zoom (2000) and Kodak Z1015 IS (2008). Eight years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.
Pixel pitch
3.5 µm
1.67 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 1.83 µm (110%)
Pixel pitch of C-3000 Zoom is approx. 110% higher than pixel pitch of Z1015 IS.
Pixel area
12.25 µm²
2.79 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 9.46 µm² (339%)
A pixel on Olympus C-3000 Zoom sensor is approx. 339% bigger than a pixel on Kodak Z1015 IS.
Pixel density
8.16 MP/cm²
35.98 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 27.82 µm (341%)
Kodak Z1015 IS has approx. 341% higher pixel density than Olympus C-3000 Zoom.
To learn about the accuracy of these numbers, click here.



Specs

Olympus C-3000 Zoom
Kodak Z1015 IS
Crop factor
4.87
5.69
Total megapixels
3.30
Effective megapixels
3.10
10.00
Optical zoom
3x
15x
Digital zoom
Yes
Yes
ISO sensitivity
100, 200, 400
Auto, 80, 100, 200, 400, 800, 1600, 3200, 6400
RAW
Manual focus
Normal focus range
80 cm
60 cm
Macro focus range
20 cm
20 cm
Focal length (35mm equiv.)
32 - 96 mm
28 - 420 mm
Aperture priority
Yes
Yes
Max. aperture
f2.8 - f2.8
f3.5 - f5.4
Max. aperture (35mm equiv.)
f13.6 - f13.6
f19.9 - f30.7
Metering
ESP Digital, Spot
Centre weighted, Multi-pattern, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
16 sec
16 sec
Max. shutter speed
1/800 sec
1/1000 sec
Built-in flash
External flash
Viewfinder
Optical (tunnel)
Electronic
White balance presets
5
5
Screen size
1.8"
3"
Screen resolution
114,000 dots
230,000 dots
Video capture
Max. video resolution
Storage types
SmartMedia
SDHC, Secure Digital
USB
USB 1.0
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
AA (4) batteries (NiMH recommended)
Kodak KLIC-8000 Lithium-Ion,
Weight
380 g
375 g
Dimensions
110 x 76 x 66 mm
118 x 83 x 78 mm
Year
2000
2008




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Olympus C-3000 Zoom diagonal

The diagonal of C-3000 Zoom sensor is not 1/1.8 or 0.56" (14.1 mm) as you might expect, but approximately two thirds of that value - 8.89 mm. If you want to know why, see sensor sizes.

w = 7.11 mm
h = 5.33 mm
Diagonal =  7.11² + 5.33²   = 8.89 mm

Kodak Z1015 IS diagonal

The diagonal of Z1015 IS sensor is not 1/2.33 or 0.43" (10.9 mm) as you might expect, but approximately two thirds of that value - 7.6 mm. If you want to know why, see sensor sizes.

w = 6.08 mm
h = 4.56 mm
Diagonal =  6.08² + 4.56²   = 7.60 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

C-3000 Zoom sensor area

Width = 7.11 mm
Height = 5.33 mm

Surface area = 7.11 × 5.33 = 37.90 mm²

Z1015 IS sensor area

Width = 6.08 mm
Height = 4.56 mm

Surface area = 6.08 × 4.56 = 27.72 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

C-3000 Zoom pixel pitch

Sensor width = 7.11 mm
Sensor resolution width = 2031 pixels
Pixel pitch =   7.11  × 1000  = 3.5 µm
2031

Z1015 IS pixel pitch

Sensor width = 6.08 mm
Sensor resolution width = 3647 pixels
Pixel pitch =   6.08  × 1000  = 1.67 µm
3647


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

C-3000 Zoom pixel area

Pixel pitch = 3.5 µm

Pixel area = 3.5² = 12.25 µm²

Z1015 IS pixel area

Pixel pitch = 1.67 µm

Pixel area = 1.67² = 2.79 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

C-3000 Zoom pixel density

Sensor resolution width = 2031 pixels
Sensor width = 0.711 cm

Pixel density = (2031 / 0.711)² / 1000000 = 8.16 MP/cm²

Z1015 IS pixel density

Sensor resolution width = 3647 pixels
Sensor width = 0.608 cm

Pixel density = (3647 / 0.608)² / 1000000 = 35.98 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

C-3000 Zoom sensor resolution

Sensor width = 7.11 mm
Sensor height = 5.33 mm
Effective megapixels = 3.10
r = 7.11/5.33 = 1.33
X =  3.10 × 1000000  = 1527
1.33
Resolution horizontal: X × r = 1527 × 1.33 = 2031
Resolution vertical: X = 1527

Sensor resolution = 2031 x 1527

Z1015 IS sensor resolution

Sensor width = 6.08 mm
Sensor height = 4.56 mm
Effective megapixels = 10.00
r = 6.08/4.56 = 1.33
X =  10.00 × 1000000  = 2742
1.33
Resolution horizontal: X × r = 2742 × 1.33 = 3647
Resolution vertical: X = 2742

Sensor resolution = 3647 x 2742


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


C-3000 Zoom crop factor

Sensor diagonal in mm = 8.89 mm
Crop factor =   43.27  = 4.87
8.89

Z1015 IS crop factor

Sensor diagonal in mm = 7.60 mm
Crop factor =   43.27  = 5.69
7.60

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

C-3000 Zoom equivalent aperture

Crop factor = 4.87
Aperture = f2.8 - f2.8

35-mm equivalent aperture = (f2.8 - f2.8) × 4.87 = f13.6 - f13.6

Z1015 IS equivalent aperture

Crop factor = 5.69
Aperture = f3.5 - f5.4

35-mm equivalent aperture = (f3.5 - f5.4) × 5.69 = f19.9 - f30.7

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.