Panasonic Lumix DC-S1H vs. Fujifilm FinePix F660EXR

Comparison

change cameras »
Lumix DC-S1H image
vs
FinePix F660EXR image
Panasonic Lumix DC-S1H Fujifilm FinePix F660EXR
check price » check price »
Megapixels
24.20
16.00
Max. image resolution
6000 x 4000
4608 x 3456

Sensor

Sensor type
CMOS
CMOS
Sensor size
35.6 x 23.8 mm
1/2" (~ 6.4 x 4.8 mm)
Sensor resolution
6026 x 4017
4612 x 3468
Diagonal
42.82 mm
8.00 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
27.58 : 1
(ratio)
Panasonic Lumix DC-S1H Fujifilm FinePix F660EXR
Surface area:
847.28 mm² vs 30.72 mm²
Difference: 816.56 mm² (2658%)
Lumix DC-S1H sensor is approx. 27.58x bigger than F660EXR sensor.
Note: You are comparing sensors of very different generations. There is a gap of 7 years between Panasonic Lumix DC-S1H (2019) and Fujifilm F660EXR (2012). Seven years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.
Pixel pitch
5.91 µm
1.39 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 4.52 µm (325%)
Pixel pitch of Lumix DC-S1H is approx. 325% higher than pixel pitch of F660EXR.
Pixel area
34.93 µm²
1.93 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 33 µm² (1710%)
A pixel on Panasonic Lumix DC-S1H sensor is approx. 1710% bigger than a pixel on Fujifilm F660EXR.
Pixel density
2.87 MP/cm²
51.93 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 49.06 µm (1709%)
Fujifilm F660EXR has approx. 1709% higher pixel density than Panasonic Lumix DC-S1H.
To learn about the accuracy of these numbers, click here.



Specs

Panasonic Lumix DC-S1H
Fujifilm F660EXR
Crop factor
1.01
5.41
Total megapixels
25.28
Effective megapixels
24.20
16.00
Optical zoom
 
15x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 100-51200 (expandable to 50-204800)
Auto, 100, 200, 400, 800, 1600, 3200 (6400 and 12800 with boost)
RAW
Manual focus
Normal focus range
45 cm
Macro focus range
5 cm
Focal length (35mm equiv.)
24 - 360 mm
Aperture priority
Yes
Yes
Max. aperture
f3.5 - f5.3
Max. aperture (35mm equiv.)
n/a
f18.9 - f28.7
Metering
Multi, Center-weighted, Highlight-weighted, Spot
Multi, Average, Spot
Exposure compensation
±5 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
60 sec
8 sec
Max. shutter speed
1/8000 sec
1/2000 sec
Built-in flash
External flash
Viewfinder
Electronic
None
White balance presets
5
7
Screen size
3.2"
3"
Screen resolution
2,330,000 dots
460,000 dots
Video capture
Max. video resolution
5952x3968 (24p)
Storage types
SD/SDHC/SDXC
SD/SDHC/SDXC
USB
USB 3.0 (5 GBit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Lithium-ion battery
Lithium-ion NP-50A rechargeable battery
Weight
1164 g
217 g
Dimensions
151 x 114.2 x 110.4 mm
104 x 59 x 33 mm
Year
2019
2012




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Panasonic Lumix DC-S1H diagonal

w = 35.60 mm
h = 23.80 mm
Diagonal =  35.60² + 23.80²   = 42.82 mm

Fujifilm F660EXR diagonal

The diagonal of F660EXR sensor is not 1/2 or 0.5" (12.7 mm) as you might expect, but approximately two thirds of that value - 8 mm. If you want to know why, see sensor sizes.

w = 6.40 mm
h = 4.80 mm
Diagonal =  6.40² + 4.80²   = 8.00 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

Lumix DC-S1H sensor area

Width = 35.60 mm
Height = 23.80 mm

Surface area = 35.60 × 23.80 = 847.28 mm²

F660EXR sensor area

Width = 6.40 mm
Height = 4.80 mm

Surface area = 6.40 × 4.80 = 30.72 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

Lumix DC-S1H pixel pitch

Sensor width = 35.60 mm
Sensor resolution width = 6026 pixels
Pixel pitch =   35.60  × 1000  = 5.91 µm
6026

F660EXR pixel pitch

Sensor width = 6.40 mm
Sensor resolution width = 4612 pixels
Pixel pitch =   6.40  × 1000  = 1.39 µm
4612


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

Lumix DC-S1H pixel area

Pixel pitch = 5.91 µm

Pixel area = 5.91² = 34.93 µm²

F660EXR pixel area

Pixel pitch = 1.39 µm

Pixel area = 1.39² = 1.93 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

Lumix DC-S1H pixel density

Sensor resolution width = 6026 pixels
Sensor width = 3.56 cm

Pixel density = (6026 / 3.56)² / 1000000 = 2.87 MP/cm²

F660EXR pixel density

Sensor resolution width = 4612 pixels
Sensor width = 0.64 cm

Pixel density = (4612 / 0.64)² / 1000000 = 51.93 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

Lumix DC-S1H sensor resolution

Sensor width = 35.60 mm
Sensor height = 23.80 mm
Effective megapixels = 24.20
r = 35.60/23.80 = 1.5
X =  24.20 × 1000000  = 4017
1.5
Resolution horizontal: X × r = 4017 × 1.5 = 6026
Resolution vertical: X = 4017

Sensor resolution = 6026 x 4017

F660EXR sensor resolution

Sensor width = 6.40 mm
Sensor height = 4.80 mm
Effective megapixels = 16.00
r = 6.40/4.80 = 1.33
X =  16.00 × 1000000  = 3468
1.33
Resolution horizontal: X × r = 3468 × 1.33 = 4612
Resolution vertical: X = 3468

Sensor resolution = 4612 x 3468


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


Lumix DC-S1H crop factor

Sensor diagonal in mm = 42.82 mm
Crop factor =   43.27  = 1.01
42.82

F660EXR crop factor

Sensor diagonal in mm = 8.00 mm
Crop factor =   43.27  = 5.41
8.00

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

Lumix DC-S1H equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Panasonic Lumix DC-S1H, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Panasonic Lumix DC-S1H is 1.01

F660EXR equivalent aperture

Crop factor = 5.41
Aperture = f3.5 - f5.3

35-mm equivalent aperture = (f3.5 - f5.3) × 5.41 = f18.9 - f28.7

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.