Panasonic Lumix DMC-FS10 vs. Fujifilm FinePix S5000 Zoom

Comparison

change cameras »
Lumix DMC-FS10 image
vs
FinePix S5000 Zoom image
Panasonic Lumix DMC-FS10 Fujifilm FinePix S5000 Zoom
check price » check price »
Megapixels
12.10
3.10
Max. image resolution
4000 x 3000
2816 x 2120

Sensor

Sensor type
CCD
CCD
Sensor size
1/2.33" (~ 6.08 x 4.56 mm)
1/2.7" (~ 5.33 x 4 mm)
Sensor resolution
4011 x 3016
2031 x 1527
Diagonal
7.60 mm
6.66 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1.3 : 1
(ratio)
Panasonic Lumix DMC-FS10 Fujifilm FinePix S5000 Zoom
Surface area:
27.72 mm² vs 21.32 mm²
Difference: 6.4 mm² (30%)
FS10 sensor is approx. 1.3x bigger than S5000 Zoom sensor.
Note: You are comparing sensors of very different generations. There is a gap of 7 years between Panasonic FS10 (2010) and Fujifilm S5000 Zoom (2003). Seven years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.
Pixel pitch
1.52 µm
2.62 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 1.1 µm (72%)
Pixel pitch of S5000 Zoom is approx. 72% higher than pixel pitch of FS10.
Pixel area
2.31 µm²
6.86 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 4.55 µm² (197%)
A pixel on Fujifilm S5000 Zoom sensor is approx. 197% bigger than a pixel on Panasonic FS10.
Pixel density
43.52 MP/cm²
14.52 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 29 µm (200%)
Panasonic FS10 has approx. 200% higher pixel density than Fujifilm S5000 Zoom.
To learn about the accuracy of these numbers, click here.



Specs

Panasonic FS10
Fujifilm S5000 Zoom
Crop factor
5.69
6.5
Total megapixels
12.70
3.10
Effective megapixels
12.10
3.10
Optical zoom
5x
10x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 80, 100, 200, 400, 800, 1600 - 6400
Auto, (160-200), 200, 400, 800 (1MP only)
RAW
Manual focus
Normal focus range
50 cm
90 cm
Macro focus range
5 cm
10 cm
Focal length (35mm equiv.)
28 - 140 mm
37 - 370 mm
Aperture priority
No
Yes
Max. aperture
f2.8 - f6.9
f2.8 - f8.0
Max. aperture (35mm equiv.)
f15.9 - f39.3
f18.2 - f52
Metering
Intelligent Multiple
Multi, Average, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
Yes
Min. shutter speed
60 sec
2 sec
Max. shutter speed
1/1600 sec
1/2000 sec
Built-in flash
External flash
Viewfinder
None
Electronic
White balance presets
6
7
Screen size
2.7"
1.5"
Screen resolution
230,000 dots
114,000 dots
Video capture
Max. video resolution
Storage types
SDHC, Secure Digital
xD Picture Card
USB
USB 2.0 (480 Mbit/sec)
USB 1.0
HDMI
Wireless
GPS
Battery
Lithium-Ion rechargeable battery
AA (4) batteries (NiMH recommended)
Weight
163 g
430 g
Dimensions
98.4 x 55.2 x 23.4 mm
113 x 81 x 79 mm
Year
2010
2003




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Panasonic FS10 diagonal

The diagonal of FS10 sensor is not 1/2.33 or 0.43" (10.9 mm) as you might expect, but approximately two thirds of that value - 7.6 mm. If you want to know why, see sensor sizes.

w = 6.08 mm
h = 4.56 mm
Diagonal =  6.08² + 4.56²   = 7.60 mm

Fujifilm S5000 Zoom diagonal

The diagonal of S5000 Zoom sensor is not 1/2.7 or 0.37" (9.4 mm) as you might expect, but approximately two thirds of that value - 6.66 mm. If you want to know why, see sensor sizes.

w = 5.33 mm
h = 4.00 mm
Diagonal =  5.33² + 4.00²   = 6.66 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

FS10 sensor area

Width = 6.08 mm
Height = 4.56 mm

Surface area = 6.08 × 4.56 = 27.72 mm²

S5000 Zoom sensor area

Width = 5.33 mm
Height = 4.00 mm

Surface area = 5.33 × 4.00 = 21.32 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

FS10 pixel pitch

Sensor width = 6.08 mm
Sensor resolution width = 4011 pixels
Pixel pitch =   6.08  × 1000  = 1.52 µm
4011

S5000 Zoom pixel pitch

Sensor width = 5.33 mm
Sensor resolution width = 2031 pixels
Pixel pitch =   5.33  × 1000  = 2.62 µm
2031


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

FS10 pixel area

Pixel pitch = 1.52 µm

Pixel area = 1.52² = 2.31 µm²

S5000 Zoom pixel area

Pixel pitch = 2.62 µm

Pixel area = 2.62² = 6.86 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

FS10 pixel density

Sensor resolution width = 4011 pixels
Sensor width = 0.608 cm

Pixel density = (4011 / 0.608)² / 1000000 = 43.52 MP/cm²

S5000 Zoom pixel density

Sensor resolution width = 2031 pixels
Sensor width = 0.533 cm

Pixel density = (2031 / 0.533)² / 1000000 = 14.52 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

FS10 sensor resolution

Sensor width = 6.08 mm
Sensor height = 4.56 mm
Effective megapixels = 12.10
r = 6.08/4.56 = 1.33
X =  12.10 × 1000000  = 3016
1.33
Resolution horizontal: X × r = 3016 × 1.33 = 4011
Resolution vertical: X = 3016

Sensor resolution = 4011 x 3016

S5000 Zoom sensor resolution

Sensor width = 5.33 mm
Sensor height = 4.00 mm
Effective megapixels = 3.10
r = 5.33/4.00 = 1.33
X =  3.10 × 1000000  = 1527
1.33
Resolution horizontal: X × r = 1527 × 1.33 = 2031
Resolution vertical: X = 1527

Sensor resolution = 2031 x 1527


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


FS10 crop factor

Sensor diagonal in mm = 7.60 mm
Crop factor =   43.27  = 5.69
7.60

S5000 Zoom crop factor

Sensor diagonal in mm = 6.66 mm
Crop factor =   43.27  = 6.5
6.66

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

FS10 equivalent aperture

Crop factor = 5.69
Aperture = f2.8 - f6.9

35-mm equivalent aperture = (f2.8 - f6.9) × 5.69 = f15.9 - f39.3

S5000 Zoom equivalent aperture

Crop factor = 6.5
Aperture = f2.8 - f8.0

35-mm equivalent aperture = (f2.8 - f8.0) × 6.5 = f18.2 - f52

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.