Canon EOS-1D X Mark II vs. Canon EOS 5DS R
Comparison
change cameras » | |||||
|
vs |
|
|||
Canon EOS-1D X Mark II | Canon EOS 5DS R | ||||
check price » | check price » |
Megapixels
20.20
50.60
Max. image resolution
5472 x 3648
8688 x 5792
Sensor
Sensor type
CMOS
CMOS
Sensor size
36 x 24 mm
36 x 24 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera.
Sensors can vary greatly in size. As a general rule, the bigger the
sensor, the better the image quality.
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Actual sensor size
Note: Actual size is set to screen → change »
|
vs |
|
1 | : | 1 |
(ratio) | ||
Canon EOS-1D X Mark II | Canon EOS 5DS R |
Surface area:
864.00 mm² | vs | 864.00 mm² |
Difference: 0 mm² (0%)
-1D X Mark II and 5DS R sensors are the same size.
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Pixel or photosite area affects how much light per pixel can be gathered.
The larger it is the more light can be collected by a single pixel.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 25.71 µm² (151%)
A pixel on Canon -1D X Mark II sensor is approx. 151% bigger than a pixel on Canon 5DS R.
Pixel density tells you how many million pixels fit or would fit in one
square cm of the sensor.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
To learn about the accuracy of these numbers,
click here.
Specs
Canon -1D X Mark II
Canon 5DS R
Total megapixels
21.50
53.00
Effective megapixels
20.20
50.60
Optical zoom
Digital zoom
ISO sensitivity
Auto, 100-51200 (expands to 50-409600)
Auto, 100 - 6400 (expands to 12800)
RAW
Manual focus
Normal focus range
Macro focus range
Focal length (35mm equiv.)
Aperture priority
Yes
Yes
Max. aperture
Metering
Multi, Center-weighted, Spot
Multi, Center-weighted, Spot, Partial
Exposure compensation
±5 EV (in 1/3 EV, 1/2 EV steps)
±5 EV (in 1/3 EV, 1/2 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
30 sec
30 sec
Max. shutter speed
1/8000 sec
1/8000 sec
Built-in flash
External flash
Viewfinder
Optical (pentaprism)
Optical (pentaprism)
White balance presets
6
8
Screen size
3.2"
3.2"
Screen resolution
1,620,000 dots
1,040,000 dots
Video capture
Max. video resolution
4096x2160 (60p/50p/30p/25p/24p)
1920x1080 (30p/25p/24p)
Storage types
CF/CFast
SD/SDHC/SDXC, CompactFlash
USB
USB 3.0 (5 GBit/sec)
USB 3.0 (5 GBit/sec)
HDMI
Wireless
GPS
Battery
LP-E19 lithium-ion battery
Battery Pack LP-E6
Weight
1530 g
930 g
Dimensions
158 x 167.6 x 82.6 mm
152 x 116.4 x 76.4 mm
Year
2016
2015
Choose cameras to compare
Popular comparisons:
- Canon EOS-1D X Mark II vs. Canon EOS 5D Mark IV
- Canon EOS-1D X Mark II vs. Canon EOS 1300D
- Canon EOS-1D X Mark II vs. Nikon D5
- Canon EOS-1D X Mark II vs. Canon EOS-1D X
- Canon EOS-1D X Mark II vs. Canon EOS 5DS R
- Canon EOS-1D X Mark II vs. Canon EOS 6D
- Canon EOS-1D X Mark II vs. Nikon D850
- Canon EOS-1D X Mark II vs. Canon EOS 80D
- Canon EOS-1D X Mark II vs. Canon EOS 7D Mark II
- Canon EOS-1D X Mark II vs. Canon EOS 200D
- Canon EOS-1D X Mark II vs. Canon EOS 5D Mark III
Diagonal
Diagonal is calculated by the use of Pythagorean theorem:
where w = sensor width and h = sensor height
Diagonal = √ | w² + h² |
Canon -1D X Mark II diagonal
w = 36.00 mm
h = 24.00 mm
h = 24.00 mm
Diagonal = √ | 36.00² + 24.00² | = 43.27 mm |
Canon 5DS R diagonal
w = 36.00 mm
h = 24.00 mm
h = 24.00 mm
Diagonal = √ | 36.00² + 24.00² | = 43.27 mm |
Surface area
Surface area is calculated by multiplying the width and the height of a sensor.
-1D X Mark II sensor area
Width = 36.00 mm
Height = 24.00 mm
Surface area = 36.00 × 24.00 = 864.00 mm²
Height = 24.00 mm
Surface area = 36.00 × 24.00 = 864.00 mm²
5DS R sensor area
Width = 36.00 mm
Height = 24.00 mm
Surface area = 36.00 × 24.00 = 864.00 mm²
Height = 24.00 mm
Surface area = 36.00 × 24.00 = 864.00 mm²
Pixel pitch
Pixel pitch is the distance from the center of one pixel to the center of the
next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch = | sensor width in mm | × 1000 |
sensor resolution width in pixels |
-1D X Mark II pixel pitch
Sensor width = 36.00 mm
Sensor resolution width = 5505 pixels
Sensor resolution width = 5505 pixels
Pixel pitch = | 36.00 | × 1000 | = 6.54 µm |
5505 |
5DS R pixel pitch
Sensor width = 36.00 mm
Sensor resolution width = 8712 pixels
Sensor resolution width = 8712 pixels
Pixel pitch = | 36.00 | × 1000 | = 4.13 µm |
8712 |
Pixel area
The area of one pixel can be calculated by simply squaring the pixel pitch:
You could also divide sensor surface area with effective megapixels:
Pixel area = pixel pitch²
You could also divide sensor surface area with effective megapixels:
Pixel area = | sensor surface area in mm² |
effective megapixels |
-1D X Mark II pixel area
Pixel pitch = 6.54 µm
Pixel area = 6.54² = 42.77 µm²
Pixel area = 6.54² = 42.77 µm²
5DS R pixel area
Pixel pitch = 4.13 µm
Pixel area = 4.13² = 17.06 µm²
Pixel area = 4.13² = 17.06 µm²
Pixel density
Pixel density can be calculated with the following formula:
One could also use this formula:
Pixel density = ( | sensor resolution width in pixels | )² / 1000000 |
sensor width in cm |
One could also use this formula:
Pixel density = | effective megapixels × 1000000 | / 10000 |
sensor surface area in mm² |
-1D X Mark II pixel density
Sensor resolution width = 5505 pixels
Sensor width = 3.6 cm
Pixel density = (5505 / 3.6)² / 1000000 = 2.34 MP/cm²
Sensor width = 3.6 cm
Pixel density = (5505 / 3.6)² / 1000000 = 2.34 MP/cm²
5DS R pixel density
Sensor resolution width = 8712 pixels
Sensor width = 3.6 cm
Pixel density = (8712 / 3.6)² / 1000000 = 5.86 MP/cm²
Sensor width = 3.6 cm
Pixel density = (8712 / 3.6)² / 1000000 = 5.86 MP/cm²
Sensor resolution
Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher
than maximum (not interpolated) image resolution which is usually stated on camera specifications.
Sensor resolution is used in pixel pitch, pixel area, and pixel density formula.
For sake of simplicity, we're going to calculate it in 3 stages.
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
3. To get sensor resolution we then multiply X with the corresponding ratio:
Resolution horizontal: X × r
Resolution vertical: X
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000 → |
|
Resolution horizontal: X × r
Resolution vertical: X
-1D X Mark II sensor resolution
Sensor width = 36.00 mm
Sensor height = 24.00 mm
Effective megapixels = 20.20
Resolution horizontal: X × r = 3670 × 1.5 = 5505
Resolution vertical: X = 3670
Sensor resolution = 5505 x 3670
Sensor height = 24.00 mm
Effective megapixels = 20.20
r = 36.00/24.00 = 1.5 |
|
Resolution vertical: X = 3670
Sensor resolution = 5505 x 3670
5DS R sensor resolution
Sensor width = 36.00 mm
Sensor height = 24.00 mm
Effective megapixels = 50.60
Resolution horizontal: X × r = 5808 × 1.5 = 8712
Resolution vertical: X = 5808
Sensor resolution = 8712 x 5808
Sensor height = 24.00 mm
Effective megapixels = 50.60
r = 36.00/24.00 = 1.5 |
|
Resolution vertical: X = 5808
Sensor resolution = 8712 x 5808
Crop factor
Crop factor or focal length multiplier is calculated by dividing the diagonal
of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor = | 43.27 mm |
sensor diagonal in mm |
-1D X Mark II crop factor
Sensor diagonal in mm = 43.27 mm
Crop factor = | 43.27 | = 1 |
43.27 |
5DS R crop factor
Sensor diagonal in mm = 43.27 mm
Crop factor = | 43.27 | = 1 |
43.27 |
35 mm equivalent aperture
Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture
with crop factor (a.k.a. focal length multiplier).
-1D X Mark II equivalent aperture
Aperture is a lens characteristic, so it's calculated only for
fixed lens cameras. If you want to know the equivalent aperture for
Canon -1D X Mark II, take the aperture of the lens
you're using and multiply it with crop factor.
Since crop factor for Canon -1D X Mark II is 1, the equivalent aperture is aperture.
Since crop factor for Canon -1D X Mark II is 1, the equivalent aperture is aperture.
5DS R equivalent aperture
Aperture is a lens characteristic, so it's calculated only for
fixed lens cameras. If you want to know the equivalent aperture for
Canon 5DS R, take the aperture of the lens
you're using and multiply it with crop factor.
Since crop factor for Canon 5DS R is 1, the equivalent aperture is aperture.
Since crop factor for Canon 5DS R is 1, the equivalent aperture is aperture.
Enter your screen size (diagonal)
My screen size is
inches
Actual size is currently adjusted to screen.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.