Fujifilm DS-300 vs. Canon EOS Rebel T4i
Comparison
| change cameras » | |||||
|
vs |
|
|||
| Fujifilm DS-300 | Canon EOS Rebel T4i | ||||
| check price » | check price » | ||||
Megapixels
1.20
18.00
Max. image resolution
1280 x 1000
5184 x 3456
Sensor
Sensor type
CCD
CMOS
Sensor size
2/3" (~ 8.8 x 6.6 mm)
22.3 x 14.9 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera.
Sensors can vary greatly in size. As a general rule, the bigger the
sensor, the better the image quality.
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Actual sensor size
Note: Actual size is set to screen → change »
|
|
vs |
|
| 1 | : | 5.72 |
| (ratio) | ||
| Fujifilm DS-300 | Canon EOS Rebel T4i | |
Surface area:
| 58.08 mm² | vs | 332.27 mm² |
Difference: 274.19 mm² (472%)
Rebel T4i sensor is approx. 5.72x bigger than DS-300 sensor.
Note: You are comparing sensors of vastly different generations.
There is a gap of 15 years between Fujifilm DS-300 (1997) and
Canon Rebel T4i (2012).
Fifteen years is a huge amount of time,
technology wise, resulting in newer sensor being much more
efficient than the older one.
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Pixel or photosite area affects how much light per pixel can be gathered.
The larger it is the more light can be collected by a single pixel.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 30.04 µm² (163%)
A pixel on Fujifilm DS-300 sensor is approx. 163% bigger than a pixel on Canon Rebel T4i.
Pixel density tells you how many million pixels fit or would fit in one
square cm of the sensor.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
To learn about the accuracy of these numbers,
click here.
Specs
Fujifilm DS-300
Canon Rebel T4i
Total megapixels
1.30
18.50
Effective megapixels
1.20
18.00
Optical zoom
3x
Digital zoom
Yes
No
ISO sensitivity
100, 400
Auto, 100, 200, 400, 800, 1600, 3200, 6400, 12800 (25600 with boost)
RAW
Manual focus
Normal focus range
20 cm
Macro focus range
20 cm
Focal length (35mm equiv.)
35 - 105 mm
Aperture priority
Yes
Yes
Max. aperture
f3.5 - f5.0
Metering
Multi, Average, Spot
Multi, Center-weighted, Spot, Partial
Exposure compensation
-0.9 - +1.8 EV (in 1/3 EV steps)
±5 EV (in 1/3 EV, 1/2 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
1/4 sec
30 sec
Max. shutter speed
1/1000 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
Optical (tunnel)
Optical (pentamirror)
White balance presets
3
6
Screen size
2"
3"
Screen resolution
130,000 dots
1,040,000 dots
Video capture
Max. video resolution
1920x1080 (30/25/24)
Storage types
PCMCIA (type I or II)
SD/SDHC/SDXC
USB
USB 1.0
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Lithium-Ion (NP-510)
Lithium-Ion LP-E8 rechargeable battery
Weight
700 g
575 g
Dimensions
153 x 96 x 78 mm
133 x 100 x 79 mm
Year
1997
2012
Choose cameras to compare
Popular comparisons:
- Fujifilm DS-300 vs. Canon EOS Rebel T4i
- Fujifilm DS-300 vs. Canon EOS Rebel T3i
- Fujifilm DS-300 vs. Panasonic Lumix DMC-GX8
- Fujifilm DS-300 vs. Nikon D5200
- Fujifilm DS-300 vs. Kodak DC3200
- Fujifilm DS-300 vs. Canon Digital IXUS 300
- Fujifilm DS-300 vs. Fujifilm X-S1
- Fujifilm DS-300 vs. Fujifilm X-Pro1
- Fujifilm DS-300 vs. Fujifilm X30
- Fujifilm DS-300 vs. Nikon Z6
- Fujifilm DS-300 vs. Nikon D750
Diagonal
Diagonal is calculated by the use of Pythagorean theorem:
where w = sensor width and h = sensor height
| Diagonal = √ | w² + h² |
Fujifilm DS-300 diagonal
The diagonal of DS-300 sensor is not 2/3 or 0.67" (16.9 mm) as you might expect, but approximately two thirds of
that value - 11 mm. If you want to know why, see
sensor sizes.
w = 8.80 mm
h = 6.60 mm
w = 8.80 mm
h = 6.60 mm
| Diagonal = √ | 8.80² + 6.60² | = 11.00 mm |
Canon Rebel T4i diagonal
w = 22.30 mm
h = 14.90 mm
h = 14.90 mm
| Diagonal = √ | 22.30² + 14.90² | = 26.82 mm |
Surface area
Surface area is calculated by multiplying the width and the height of a sensor.
DS-300 sensor area
Width = 8.80 mm
Height = 6.60 mm
Surface area = 8.80 × 6.60 = 58.08 mm²
Height = 6.60 mm
Surface area = 8.80 × 6.60 = 58.08 mm²
Rebel T4i sensor area
Width = 22.30 mm
Height = 14.90 mm
Surface area = 22.30 × 14.90 = 332.27 mm²
Height = 14.90 mm
Surface area = 22.30 × 14.90 = 332.27 mm²
Pixel pitch
Pixel pitch is the distance from the center of one pixel to the center of the
next measured in micrometers (µm). It can be calculated with the following formula:
| Pixel pitch = | sensor width in mm | × 1000 |
| sensor resolution width in pixels |
DS-300 pixel pitch
Sensor width = 8.80 mm
Sensor resolution width = 1264 pixels
Sensor resolution width = 1264 pixels
| Pixel pitch = | 8.80 | × 1000 | = 6.96 µm |
| 1264 |
Rebel T4i pixel pitch
Sensor width = 22.30 mm
Sensor resolution width = 5196 pixels
Sensor resolution width = 5196 pixels
| Pixel pitch = | 22.30 | × 1000 | = 4.29 µm |
| 5196 |
Pixel area
The area of one pixel can be calculated by simply squaring the pixel pitch:
You could also divide sensor surface area with effective megapixels:
Pixel area = pixel pitch²
You could also divide sensor surface area with effective megapixels:
| Pixel area = | sensor surface area in mm² |
| effective megapixels |
DS-300 pixel area
Pixel pitch = 6.96 µm
Pixel area = 6.96² = 48.44 µm²
Pixel area = 6.96² = 48.44 µm²
Rebel T4i pixel area
Pixel pitch = 4.29 µm
Pixel area = 4.29² = 18.4 µm²
Pixel area = 4.29² = 18.4 µm²
Pixel density
Pixel density can be calculated with the following formula:
One could also use this formula:
| Pixel density = ( | sensor resolution width in pixels | )² / 1000000 |
| sensor width in cm |
One could also use this formula:
| Pixel density = | effective megapixels × 1000000 | / 10000 |
| sensor surface area in mm² |
DS-300 pixel density
Sensor resolution width = 1264 pixels
Sensor width = 0.88 cm
Pixel density = (1264 / 0.88)² / 1000000 = 2.06 MP/cm²
Sensor width = 0.88 cm
Pixel density = (1264 / 0.88)² / 1000000 = 2.06 MP/cm²
Rebel T4i pixel density
Sensor resolution width = 5196 pixels
Sensor width = 2.23 cm
Pixel density = (5196 / 2.23)² / 1000000 = 5.43 MP/cm²
Sensor width = 2.23 cm
Pixel density = (5196 / 2.23)² / 1000000 = 5.43 MP/cm²
Sensor resolution
Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher
than maximum (not interpolated) image resolution which is usually stated on camera specifications.
Sensor resolution is used in pixel pitch, pixel area, and pixel density formula.
For sake of simplicity, we're going to calculate it in 3 stages.
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
3. To get sensor resolution we then multiply X with the corresponding ratio:
Resolution horizontal: X × r
Resolution vertical: X
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
| (X × r) × X = effective megapixels × 1000000 → |
|
Resolution horizontal: X × r
Resolution vertical: X
DS-300 sensor resolution
Sensor width = 8.80 mm
Sensor height = 6.60 mm
Effective megapixels = 1.20
Resolution horizontal: X × r = 950 × 1.33 = 1264
Resolution vertical: X = 950
Sensor resolution = 1264 x 950
Sensor height = 6.60 mm
Effective megapixels = 1.20
| r = 8.80/6.60 = 1.33 |
|
Resolution vertical: X = 950
Sensor resolution = 1264 x 950
Rebel T4i sensor resolution
Sensor width = 22.30 mm
Sensor height = 14.90 mm
Effective megapixels = 18.00
Resolution horizontal: X × r = 3464 × 1.5 = 5196
Resolution vertical: X = 3464
Sensor resolution = 5196 x 3464
Sensor height = 14.90 mm
Effective megapixels = 18.00
| r = 22.30/14.90 = 1.5 |
|
Resolution vertical: X = 3464
Sensor resolution = 5196 x 3464
Crop factor
Crop factor or focal length multiplier is calculated by dividing the diagonal
of 35 mm film (43.27 mm) with the diagonal of the sensor.
| Crop factor = | 43.27 mm |
| sensor diagonal in mm |
DS-300 crop factor
Sensor diagonal in mm = 11.00 mm
| Crop factor = | 43.27 | = 3.93 |
| 11.00 |
Rebel T4i crop factor
Sensor diagonal in mm = 26.82 mm
| Crop factor = | 43.27 | = 1.61 |
| 26.82 |
35 mm equivalent aperture
Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture
with crop factor (a.k.a. focal length multiplier).
DS-300 equivalent aperture
Crop factor = 3.93
Aperture = f3.5 - f5.0
35-mm equivalent aperture = (f3.5 - f5.0) × 3.93 = f13.8 - f19.7
Aperture = f3.5 - f5.0
35-mm equivalent aperture = (f3.5 - f5.0) × 3.93 = f13.8 - f19.7
Rebel T4i equivalent aperture
Aperture is a lens characteristic, so it's calculated only for
fixed lens cameras. If you want to know the equivalent aperture for
Canon Rebel T4i, take the aperture of the lens
you're using and multiply it with crop factor.
Crop factor for Canon Rebel T4i is 1.61
Crop factor for Canon Rebel T4i is 1.61
More comparisons of Fujifilm DS-300:
Enter your screen size (diagonal)
My screen size is
inches
Actual size is currently adjusted to screen.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.