Fujifilm FinePix F610 vs. Canon PowerShot A495

Comparison

change cameras »

Fujifilm FinePix F610

Canon PowerShot A495

check price »

Megapixels

6.00

10.00

Max. image resolution

4048 x 3040

3648 x 2736

Sensor

Sensor type

CCD

Sensor size

1/1.7" (~ 7.53 x 5.64 mm)

1/2.3" (~ 6.16 x 4.62 mm)

Sensor resolution

2835 x 2116

3647 x 2742

Diagonal

9.41 mm

7.70 mm

Sensor size comparison

Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »

	vs
1.49	:	1
(ratio)

Fujifilm FinePix F610		Canon PowerShot A495

Surface area:

42.47 mm²

28.46 mm²

Difference: 14.01 mm² (49%)

F610 sensor is approx. 1.49x bigger than A495 sensor.

Note: You are comparing sensors of very different generations. There is a gap of 7 years between Fujifilm F610 (2003) and Canon A495 (2010). Seven years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.

Pixel pitch

2.66 µm

1.69 µm

Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.

Difference: 0.97 µm (57%)

Pixel pitch of F610 is approx. 57% higher than pixel pitch of A495.

Pixel area

7.08 µm²

2.86 µm²

Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.

Relative pixel sizes:

Pixel area difference: 4.22 µm² (148%)

A pixel on Fujifilm F610 sensor is approx. 148% bigger than a pixel on Canon A495.

Pixel density

14.17 MP/cm²

35.05 MP/cm²

Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.

Difference: 20.88 µm (147%)

Canon A495 has approx. 147% higher pixel density than Fujifilm F610.

To learn about the accuracy of these numbers, click here.

Specs

Fujifilm F610

Canon A495

Crop factor

4.6

5.62

Total megapixels

6.30

Effective megapixels

6.00

10.00

Optical zoom

3.3x

Digital zoom

Yes

ISO sensitivity

Auto, 125, 200, 400, 800

Auto, 100, 200, 400, 800, 1600

RAW

Manual focus

Normal focus range

60 cm

35 cm

Macro focus range

9 cm

1 cm

Focal length (35mm equiv.)

35 - 105 mm

37 - 122 mm

Aperture priority

Yes

Max. aperture

f2.8 - f4.9

f3.0 - f5.8

Max. aperture (35mm equiv.)

f12.9 - f22.5

f16.9 - f32.6

Metering

64-segment, Evaluative, Spot

Centre weighted, Evaluative, Spot

Exposure compensation

±2 EV (in 1/3 EV steps)

Shutter priority

Yes

Min. shutter speed

3 sec

15 sec

Max. shutter speed

1/2000 sec

Built-in flash

External flash

Viewfinder

Optical (tunnel)

None

White balance presets

Screen size

1.8"

2.5"

Screen resolution

134,000 dots

115,000 dots

Video capture

Max. video resolution

Storage types

xD Picture card

SDHC, Secure Digital

USB

USB 1.0

USB 2.0 (480 Mbit/sec)

HDMI

Wireless

GPS

Battery

Lithium-Ion (NP-40)

2 x AA batteries (Alkaline or NiMH)

Weight

195 g

135 g

Dimensions

71.9 x 93 x 31.3 mm

94 x 62 x 31 mm

Year

2003

2010

Choose cameras to compare

Popular comparisons:

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:

Diagonal = √

w² + h²

where w = sensor width and h = sensor height

Fujifilm F610 diagonal

The diagonal of F610 sensor is not 1/1.7 or 0.59" (14.9 mm) as you might expect, but approximately two thirds of that value - 9.41 mm. If you want to know why, see sensor sizes.

w = 7.53 mm
h = 5.64 mm

Diagonal = √

7.53² + 5.64²

= 9.41 mm

Canon A495 diagonal

The diagonal of A495 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm

Diagonal = √

6.16² + 4.62²

= 7.70 mm

Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

F610 sensor area

Width = 7.53 mm
Height = 5.64 mm

Surface area = 7.53 × 5.64 = 42.47 mm²

A495 sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²

Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:

Pixel pitch =	sensor width in mm	× 1000
	sensor resolution width in pixels

F610 pixel pitch

Sensor width = 7.53 mm
Sensor resolution width = 2835 pixels

Pixel pitch =	7.53	× 1000	= 2.66 µm
	2835

A495 pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 3647 pixels

Pixel pitch =	6.16	× 1000	= 1.69 µm
	3647

Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:

Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:

Pixel area =	sensor surface area in mm²
	effective megapixels

F610 pixel area

Pixel pitch = 2.66 µm

Pixel area = 2.66² = 7.08 µm²

A495 pixel area

Pixel pitch = 1.69 µm

Pixel area = 1.69² = 2.86 µm²

Pixel density

Pixel density can be calculated with the following formula:

Pixel density = (	sensor resolution width in pixels	)² / 1000000
	sensor width in cm

One could also use this formula:

Pixel density =	effective megapixels × 1000000	/ 10000
	sensor surface area in mm²

F610 pixel density

Sensor resolution width = 2835 pixels
Sensor width = 0.753 cm

Pixel density = (2835 / 0.753)² / 1000000 = 14.17 MP/cm²

A495 pixel density

Sensor resolution width = 3647 pixels
Sensor width = 0.616 cm

Pixel density = (3647 / 0.616)² / 1000000 = 35.05 MP/cm²

Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:

(X × r) × X = effective megapixels × 1000000 →

X = √	effective megapixels × 1000000
	r

3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

F610 sensor resolution

Sensor width = 7.53 mm
Sensor height = 5.64 mm
Effective megapixels = 6.00

r = 7.53/5.64 = 1.34

X = √	6.00 × 1000000	= 2116
	1.34

Resolution horizontal: X × r = 2116 × 1.34 = 2835
Resolution vertical: X = 2116

Sensor resolution = 2835 x 2116

A495 sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 10.00

r = 6.16/4.62 = 1.33

X = √	10.00 × 1000000	= 2742
	1.33

Resolution horizontal: X × r = 2742 × 1.33 = 3647
Resolution vertical: X = 2742

Sensor resolution = 3647 x 2742

Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.

Crop factor =	43.27 mm
	sensor diagonal in mm

F610 crop factor

Sensor diagonal in mm = 9.41 mm

Crop factor =	43.27	= 4.6
	9.41

A495 crop factor

Sensor diagonal in mm = 7.70 mm

Crop factor =	43.27	= 5.62
	7.70

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

F610 equivalent aperture

Crop factor = 4.6
Aperture = f2.8 - f4.9

35-mm equivalent aperture = (f2.8 - f4.9) × 4.6 = f12.9 - f22.5

A495 equivalent aperture

Crop factor = 5.62
Aperture = f3.0 - f5.8

35-mm equivalent aperture = (f3.0 - f5.8) × 5.62 = f16.9 - f32.6

More comparisons of Fujifilm F610:

Enter your screen size (diagonal)

My screen size is inches

Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.