Fujifilm FinePix Z3 vs. Fujifilm FinePix Z5fd
Comparison
| change cameras » | |||||
|
vs |
|
|||
| Fujifilm FinePix Z3 | Fujifilm FinePix Z5fd | ||||
| check price » | check price » | ||||
Megapixels
5.10
6.30
Max. image resolution
2592 x 1944
2848 x 2136
Sensor
Sensor type
CCD
CCD
Sensor size
1/2.5" (~ 5.75 x 4.32 mm)
1/2.5" (~ 5.75 x 4.32 mm)
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera.
Sensors can vary greatly in size. As a general rule, the bigger the
sensor, the better the image quality.
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Actual sensor size
Note: Actual size is set to screen → change »
|
|
vs |
|
| 1 | : | 1 |
| (ratio) | ||
| Fujifilm FinePix Z3 | Fujifilm FinePix Z5fd | |
Surface area:
| 24.84 mm² | vs | 24.84 mm² |
Difference: 0 mm² (0%)
Z3 and Z5fd sensors are the same size.
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Pixel or photosite area affects how much light per pixel can be gathered.
The larger it is the more light can be collected by a single pixel.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 0.92 µm² (23%)
A pixel on Fujifilm Z3 sensor is approx. 23% bigger than a pixel on Fujifilm Z5fd.
Pixel density tells you how many million pixels fit or would fit in one
square cm of the sensor.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
To learn about the accuracy of these numbers,
click here.
Specs
Fujifilm Z3
Fujifilm Z5fd
Total megapixels
5.10
Effective megapixels
5.10
Optical zoom
3x
Yes
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 64, 100, 200, 400, 800, 1600
Auto, 100, 200, 400, 800, 1600
RAW
Manual focus
Normal focus range
60 cm
60 cm
Macro focus range
8 cm
8 cm
Focal length (35mm equiv.)
36 - 108 mm
36 - 108 mm
Aperture priority
No
No
Max. aperture
f3.5 - f4.2
f3.5 - f4.2
Metering
256-segment Matrix
256-segment Matrix
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
No
Min. shutter speed
4 sec
4 sec
Max. shutter speed
1/1000 sec
1/1000 sec
Built-in flash
External flash
Viewfinder
None
None
White balance presets
6
7
Screen size
2.5"
2.5"
Screen resolution
230,000 dots
230,000 dots
Video capture
Max. video resolution
Storage types
xD Picture card
xD Picture card
USB
USB 2.0 (480 Mbit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Lithium-Ion (NP-40)
Li-Ion
Weight
130 g
130 g
Dimensions
90 x 55 x 20 mm
92.8 x 55.0 x 19.4 mm
Year
2006
2007
Choose cameras to compare
Popular comparisons:
- Fujifilm FinePix Z3 vs. Fujifilm FinePix Z2
- Fujifilm FinePix Z3 vs. Fujifilm FinePix Z1
- Fujifilm FinePix Z3 vs. Fujifilm FinePix Z5fd
- Fujifilm FinePix Z3 vs. Canon IXUS 135
- Fujifilm FinePix Z3 vs. Nikon D5100
- Fujifilm FinePix Z3 vs. Canon EOS 5D Mark II
- Fujifilm FinePix Z3 vs. Sony Cyber-shot DSC-T30
- Fujifilm FinePix Z3 vs. Nikon Coolpix L28
- Fujifilm FinePix Z3 vs. Canon EOS 5D Mark III
- Fujifilm FinePix Z3 vs. Sony Cyber-shot DSC-S2100
- Fujifilm FinePix Z3 vs. Sony Cyber-shot DSC-T900
Diagonal
Diagonal is calculated by the use of Pythagorean theorem:
where w = sensor width and h = sensor height
| Diagonal = √ | w² + h² |
Fujifilm Z3 diagonal
The diagonal of Z3 sensor is not 1/2.5 or 0.4" (10.2 mm) as you might expect, but approximately two thirds of
that value - 7.19 mm. If you want to know why, see
sensor sizes.
w = 5.75 mm
h = 4.32 mm
w = 5.75 mm
h = 4.32 mm
| Diagonal = √ | 5.75² + 4.32² | = 7.19 mm |
Fujifilm Z5fd diagonal
The diagonal of Z5fd sensor is not 1/2.5 or 0.4" (10.2 mm) as you might expect, but approximately two thirds of
that value - 7.19 mm. If you want to know why, see
sensor sizes.
w = 5.75 mm
h = 4.32 mm
w = 5.75 mm
h = 4.32 mm
| Diagonal = √ | 5.75² + 4.32² | = 7.19 mm |
Surface area
Surface area is calculated by multiplying the width and the height of a sensor.
Z3 sensor area
Width = 5.75 mm
Height = 4.32 mm
Surface area = 5.75 × 4.32 = 24.84 mm²
Height = 4.32 mm
Surface area = 5.75 × 4.32 = 24.84 mm²
Z5fd sensor area
Width = 5.75 mm
Height = 4.32 mm
Surface area = 5.75 × 4.32 = 24.84 mm²
Height = 4.32 mm
Surface area = 5.75 × 4.32 = 24.84 mm²
Pixel pitch
Pixel pitch is the distance from the center of one pixel to the center of the
next measured in micrometers (µm). It can be calculated with the following formula:
| Pixel pitch = | sensor width in mm | × 1000 |
| sensor resolution width in pixels |
Z3 pixel pitch
Sensor width = 5.75 mm
Sensor resolution width = 2604 pixels
Sensor resolution width = 2604 pixels
| Pixel pitch = | 5.75 | × 1000 | = 2.21 µm |
| 2604 |
Z5fd pixel pitch
Sensor width = 5.75 mm
Sensor resolution width = 2894 pixels
Sensor resolution width = 2894 pixels
| Pixel pitch = | 5.75 | × 1000 | = 1.99 µm |
| 2894 |
Pixel area
The area of one pixel can be calculated by simply squaring the pixel pitch:
You could also divide sensor surface area with effective megapixels:
Pixel area = pixel pitch²
You could also divide sensor surface area with effective megapixels:
| Pixel area = | sensor surface area in mm² |
| effective megapixels |
Z3 pixel area
Pixel pitch = 2.21 µm
Pixel area = 2.21² = 4.88 µm²
Pixel area = 2.21² = 4.88 µm²
Z5fd pixel area
Pixel pitch = 1.99 µm
Pixel area = 1.99² = 3.96 µm²
Pixel area = 1.99² = 3.96 µm²
Pixel density
Pixel density can be calculated with the following formula:
One could also use this formula:
| Pixel density = ( | sensor resolution width in pixels | )² / 1000000 |
| sensor width in cm |
One could also use this formula:
| Pixel density = | effective megapixels × 1000000 | / 10000 |
| sensor surface area in mm² |
Z3 pixel density
Sensor resolution width = 2604 pixels
Sensor width = 0.575 cm
Pixel density = (2604 / 0.575)² / 1000000 = 20.51 MP/cm²
Sensor width = 0.575 cm
Pixel density = (2604 / 0.575)² / 1000000 = 20.51 MP/cm²
Z5fd pixel density
Sensor resolution width = 2894 pixels
Sensor width = 0.575 cm
Pixel density = (2894 / 0.575)² / 1000000 = 25.33 MP/cm²
Sensor width = 0.575 cm
Pixel density = (2894 / 0.575)² / 1000000 = 25.33 MP/cm²
Sensor resolution
Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher
than maximum (not interpolated) image resolution which is usually stated on camera specifications.
Sensor resolution is used in pixel pitch, pixel area, and pixel density formula.
For sake of simplicity, we're going to calculate it in 3 stages.
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
3. To get sensor resolution we then multiply X with the corresponding ratio:
Resolution horizontal: X × r
Resolution vertical: X
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
| (X × r) × X = effective megapixels × 1000000 → |
|
Resolution horizontal: X × r
Resolution vertical: X
Z3 sensor resolution
Sensor width = 5.75 mm
Sensor height = 4.32 mm
Effective megapixels = 5.10
Resolution horizontal: X × r = 1958 × 1.33 = 2604
Resolution vertical: X = 1958
Sensor resolution = 2604 x 1958
Sensor height = 4.32 mm
Effective megapixels = 5.10
| r = 5.75/4.32 = 1.33 |
|
Resolution vertical: X = 1958
Sensor resolution = 2604 x 1958
Z5fd sensor resolution
Sensor width = 5.75 mm
Sensor height = 4.32 mm
Effective megapixels = 6.30
Resolution horizontal: X × r = 2176 × 1.33 = 2894
Resolution vertical: X = 2176
Sensor resolution = 2894 x 2176
Sensor height = 4.32 mm
Effective megapixels = 6.30
| r = 5.75/4.32 = 1.33 |
|
Resolution vertical: X = 2176
Sensor resolution = 2894 x 2176
Crop factor
Crop factor or focal length multiplier is calculated by dividing the diagonal
of 35 mm film (43.27 mm) with the diagonal of the sensor.
| Crop factor = | 43.27 mm |
| sensor diagonal in mm |
Z3 crop factor
Sensor diagonal in mm = 7.19 mm
| Crop factor = | 43.27 | = 6.02 |
| 7.19 |
Z5fd crop factor
Sensor diagonal in mm = 7.19 mm
| Crop factor = | 43.27 | = 6.02 |
| 7.19 |
35 mm equivalent aperture
Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture
with crop factor (a.k.a. focal length multiplier).
Z3 equivalent aperture
Crop factor = 6.02
Aperture = f3.5 - f4.2
35-mm equivalent aperture = (f3.5 - f4.2) × 6.02 = f21.1 - f25.3
Aperture = f3.5 - f4.2
35-mm equivalent aperture = (f3.5 - f4.2) × 6.02 = f21.1 - f25.3
Z5fd equivalent aperture
Crop factor = 6.02
Aperture = f3.5 - f4.2
35-mm equivalent aperture = (f3.5 - f4.2) × 6.02 = f21.1 - f25.3
Aperture = f3.5 - f4.2
35-mm equivalent aperture = (f3.5 - f4.2) × 6.02 = f21.1 - f25.3
More comparisons of Fujifilm Z3:
Enter your screen size (diagonal)
My screen size is
inches
Actual size is currently adjusted to screen.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.