Kodak EasyShare DX3215 vs. Canon PowerShot S110

Comparison

change cameras »

Kodak EasyShare DX3215

Canon PowerShot S110

check price »

Megapixels

1.20

12.10

Max. image resolution

1280 x 960

4000 x 3000

Sensor

Sensor type

CCD

CMOS

Sensor size

1/2.7" (~ 5.33 x 4 mm)

1/1.7" (~ 7.53 x 5.64 mm)

Sensor resolution

1264 x 950

4027 x 3005

Diagonal

6.66 mm

9.41 mm

Sensor size comparison

Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »

	vs
1	:	1.99
(ratio)

Kodak EasyShare DX3215		Canon PowerShot S110

Surface area:

21.32 mm²

42.47 mm²

Difference: 21.15 mm² (99%)

S110 sensor is approx. 1.99x bigger than DX3215 sensor.

Note: You are comparing sensors of vastly different generations. There is a gap of 11 years between Kodak DX3215 (2001) and Canon S110 (2012). Eleven years is a huge amount of time, technology wise, resulting in newer sensor being much more efficient than the older one.

Pixel pitch

4.22 µm

1.87 µm

Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.

Difference: 2.35 µm (126%)

Pixel pitch of DX3215 is approx. 126% higher than pixel pitch of S110.

Pixel area

17.81 µm²

3.5 µm²

Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.

Relative pixel sizes:

Pixel area difference: 14.31 µm² (409%)

A pixel on Kodak DX3215 sensor is approx. 409% bigger than a pixel on Canon S110.

Pixel density

5.62 MP/cm²

28.6 MP/cm²

Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.

Difference: 22.98 µm (409%)

Canon S110 has approx. 409% higher pixel density than Kodak DX3215.

To learn about the accuracy of these numbers, click here.

Specs

Kodak DX3215

Canon S110

Crop factor

6.5

4.6

Total megapixels

1.30

13.30

Effective megapixels

1.20

12.10

Optical zoom

Digital zoom

Yes

ISO sensitivity

Auto, (100 - 200)

Auto, 80 - 12800

RAW

Manual focus

Normal focus range

75 cm

30 cm

Macro focus range

22 cm

3 cm

Focal length (35mm equiv.)

30 - 60 mm

24 - 120 mm

Aperture priority

Yes

Max. aperture

f4.5 - f9.0

f2.0 - f5.9

Max. aperture (35mm equiv.)

f29.3 - f58.5

f9.2 - f27.1

Metering

Multi, Center-weighted, Spot

Exposure compensation

±2 EV (in 1/2 EV steps)

±3 EV (in 1/3 EV steps)

Shutter priority

Yes

Min. shutter speed

1/4 sec

15 sec

Max. shutter speed

1/1000 sec

1/2000 sec

Built-in flash

External flash

Viewfinder

Optical (tunnel)

None

White balance presets

Screen size

1.6"

Screen resolution

72,000 dots

461,000 dots

Video capture

Max. video resolution

1920x1080 (24p)

Storage types

SD/MMC card, Internal

SD/SDHC/SDXC

USB

USB 1.0

USB 2.0 (480 Mbit/sec)

HDMI

Wireless

GPS

Battery

AA (2) batteries (NiMH recommended)

Lithium-Ion NB-5L rechargeable battery

Weight

260 g

198 g

Dimensions

121 x 70 x 46 mm

98.8 x 59 x 26.9 mm

Year

2001

2012

Choose cameras to compare

Popular comparisons:

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:

Diagonal = √

w² + h²

where w = sensor width and h = sensor height

Kodak DX3215 diagonal

The diagonal of DX3215 sensor is not 1/2.7 or 0.37" (9.4 mm) as you might expect, but approximately two thirds of that value - 6.66 mm. If you want to know why, see sensor sizes.

w = 5.33 mm
h = 4.00 mm

Diagonal = √

5.33² + 4.00²

= 6.66 mm

Canon S110 diagonal

The diagonal of S110 sensor is not 1/1.7 or 0.59" (14.9 mm) as you might expect, but approximately two thirds of that value - 9.41 mm. If you want to know why, see sensor sizes.

w = 7.53 mm
h = 5.64 mm

Diagonal = √

7.53² + 5.64²

= 9.41 mm

Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

DX3215 sensor area

Width = 5.33 mm
Height = 4.00 mm

Surface area = 5.33 × 4.00 = 21.32 mm²

S110 sensor area

Width = 7.53 mm
Height = 5.64 mm

Surface area = 7.53 × 5.64 = 42.47 mm²

Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:

Pixel pitch =	sensor width in mm	× 1000
	sensor resolution width in pixels

DX3215 pixel pitch

Sensor width = 5.33 mm
Sensor resolution width = 1264 pixels

Pixel pitch =	5.33	× 1000	= 4.22 µm
	1264

S110 pixel pitch

Sensor width = 7.53 mm
Sensor resolution width = 4027 pixels

Pixel pitch =	7.53	× 1000	= 1.87 µm
	4027

Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:

Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:

Pixel area =	sensor surface area in mm²
	effective megapixels

DX3215 pixel area

Pixel pitch = 4.22 µm

Pixel area = 4.22² = 17.81 µm²

S110 pixel area

Pixel pitch = 1.87 µm

Pixel area = 1.87² = 3.5 µm²

Pixel density

Pixel density can be calculated with the following formula:

Pixel density = (	sensor resolution width in pixels	)² / 1000000
	sensor width in cm

One could also use this formula:

Pixel density =	effective megapixels × 1000000	/ 10000
	sensor surface area in mm²

DX3215 pixel density

Sensor resolution width = 1264 pixels
Sensor width = 0.533 cm

Pixel density = (1264 / 0.533)² / 1000000 = 5.62 MP/cm²

S110 pixel density

Sensor resolution width = 4027 pixels
Sensor width = 0.753 cm

Pixel density = (4027 / 0.753)² / 1000000 = 28.6 MP/cm²

Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:

(X × r) × X = effective megapixels × 1000000 →

X = √	effective megapixels × 1000000
	r

3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

DX3215 sensor resolution

Sensor width = 5.33 mm
Sensor height = 4.00 mm
Effective megapixels = 1.20

r = 5.33/4.00 = 1.33

X = √	1.20 × 1000000	= 950
	1.33

Resolution horizontal: X × r = 950 × 1.33 = 1264
Resolution vertical: X = 950

Sensor resolution = 1264 x 950

S110 sensor resolution

Sensor width = 7.53 mm
Sensor height = 5.64 mm
Effective megapixels = 12.10

r = 7.53/5.64 = 1.34

X = √	12.10 × 1000000	= 3005
	1.34

Resolution horizontal: X × r = 3005 × 1.34 = 4027
Resolution vertical: X = 3005

Sensor resolution = 4027 x 3005

Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.

Crop factor =	43.27 mm
	sensor diagonal in mm

DX3215 crop factor

Sensor diagonal in mm = 6.66 mm

Crop factor =	43.27	= 6.5
	6.66

S110 crop factor

Sensor diagonal in mm = 9.41 mm

Crop factor =	43.27	= 4.6
	9.41

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

DX3215 equivalent aperture

Crop factor = 6.5
Aperture = f4.5 - f9.0

35-mm equivalent aperture = (f4.5 - f9.0) × 6.5 = f29.3 - f58.5

S110 equivalent aperture

Crop factor = 4.6
Aperture = f2.0 - f5.9

35-mm equivalent aperture = (f2.0 - f5.9) × 4.6 = f9.2 - f27.1

Enter your screen size (diagonal)

My screen size is inches

Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.