Kodak EasyShare DX3500 vs. Nikon Coolpix P330

Comparison

change cameras »
EasyShare DX3500 image
vs
Coolpix P330 image
Kodak EasyShare DX3500 Nikon Coolpix P330
check price » check price »
Megapixels
2.20
12.20
Max. image resolution
1800 x 1200
4000 x 3000

Sensor

Sensor type
CCD
CMOS
Sensor size
1/2" (~ 6.4 x 4.8 mm)
1/1.7" (~ 7.53 x 5.64 mm)
Sensor resolution
1710 x 1286
4043 x 3017
Diagonal
8.00 mm
9.41 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1.38
(ratio)
Kodak EasyShare DX3500 Nikon Coolpix P330
Surface area:
30.72 mm² vs 42.47 mm²
Difference: 11.75 mm² (38%)
P330 sensor is approx. 1.38x bigger than DX3500 sensor.
Note: You are comparing sensors of vastly different generations. There is a gap of 12 years between Kodak DX3500 (2001) and Nikon P330 (2013). Twelve years is a huge amount of time, technology wise, resulting in newer sensor being much more efficient than the older one.
Pixel pitch
3.74 µm
1.86 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 1.88 µm (101%)
Pixel pitch of DX3500 is approx. 101% higher than pixel pitch of P330.
Pixel area
13.99 µm²
3.46 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 10.53 µm² (304%)
A pixel on Kodak DX3500 sensor is approx. 304% bigger than a pixel on Nikon P330.
Pixel density
7.14 MP/cm²
28.83 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 21.69 µm (304%)
Nikon P330 has approx. 304% higher pixel density than Kodak DX3500.
To learn about the accuracy of these numbers, click here.



Specs

Kodak DX3500
Nikon P330
Crop factor
5.41
4.6
Total megapixels
2.30
12.76
Effective megapixels
2.20
12.20
Optical zoom
1x
5x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, (100 - 200)
Auto, 100, 200, 400, 800, 1600, 2000, 3200, 6400, 12800
RAW
Manual focus
Normal focus range
75 cm
30 cm
Macro focus range
22 cm
3 cm
Focal length (35mm equiv.)
38 mm
24 - 120 mm
Aperture priority
No
Yes
Max. aperture
f3.3 - f4.5
f1.8 - f5.6
Max. aperture (35mm equiv.)
f17.9 - f24.3
f8.3 - f25.8
Metering
Multi, Center-weighted, Spot
Multi, Center-weighted, Spot
Exposure compensation
±3 EV (in 1/3 EV, 1/2 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
Yes
Min. shutter speed
1/8 sec
60 sec
Max. shutter speed
1/1200 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
Optical (tunnel)
None
White balance presets
4
5
Screen size
1.8"
3"
Screen resolution
72,000 dots
921,000 dots
Video capture
Max. video resolution
1920x1080 (60i/50i/30p/25p/24p)
Storage types
Compact Flash Type I, Internal
SD/SDHC/SDXC
USB
USB 1.0
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
AA (2) batteries (NiMH recommended)
Rechargeable Li-ion Battery EN-EL12
Weight
225 g
200 g
Dimensions
120 x 74 x 50 mm
103 x 58.3 x 32 mm
Year
2001
2013




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal = √  w² + h²
where w = sensor width and h = sensor height

Kodak DX3500 diagonal

The diagonal of DX3500 sensor is not 1/2 or 0.5" (12.7 mm) as you might expect, but approximately two thirds of that value - 8 mm. If you want to know why, see sensor sizes.

w = 6.40 mm
h = 4.80 mm
Diagonal = √  6.40² + 4.80²   = 8.00 mm

Nikon P330 diagonal

The diagonal of P330 sensor is not 1/1.7 or 0.59" (14.9 mm) as you might expect, but approximately two thirds of that value - 9.41 mm. If you want to know why, see sensor sizes.

w = 7.53 mm
h = 5.64 mm
Diagonal = √  7.53² + 5.64²   = 9.41 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

DX3500 sensor area

Width = 6.40 mm
Height = 4.80 mm

Surface area = 6.40 × 4.80 = 30.72 mm²

P330 sensor area

Width = 7.53 mm
Height = 5.64 mm

Surface area = 7.53 × 5.64 = 42.47 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

DX3500 pixel pitch

Sensor width = 6.40 mm
Sensor resolution width = 1710 pixels
Pixel pitch =   6.40  × 1000  = 3.74 µm
1710

P330 pixel pitch

Sensor width = 7.53 mm
Sensor resolution width = 4043 pixels
Pixel pitch =   7.53  × 1000  = 1.86 µm
4043


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

DX3500 pixel area

Pixel pitch = 3.74 µm

Pixel area = 3.74² = 13.99 µm²

P330 pixel area

Pixel pitch = 1.86 µm

Pixel area = 1.86² = 3.46 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

DX3500 pixel density

Sensor resolution width = 1710 pixels
Sensor width = 0.64 cm

Pixel density = (1710 / 0.64)² / 1000000 = 7.14 MP/cm²

P330 pixel density

Sensor resolution width = 4043 pixels
Sensor width = 0.753 cm

Pixel density = (4043 / 0.753)² / 1000000 = 28.83 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X = √  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

DX3500 sensor resolution

Sensor width = 6.40 mm
Sensor height = 4.80 mm
Effective megapixels = 2.20
r = 6.40/4.80 = 1.33
X = √  2.20 × 1000000  = 1286
1.33
Resolution horizontal: X × r = 1286 × 1.33 = 1710
Resolution vertical: X = 1286

Sensor resolution = 1710 x 1286

P330 sensor resolution

Sensor width = 7.53 mm
Sensor height = 5.64 mm
Effective megapixels = 12.20
r = 7.53/5.64 = 1.34
X = √  12.20 × 1000000  = 3017
1.34
Resolution horizontal: X × r = 3017 × 1.34 = 4043
Resolution vertical: X = 3017

Sensor resolution = 4043 x 3017


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


DX3500 crop factor

Sensor diagonal in mm = 8.00 mm
Crop factor =   43.27  = 5.41
8.00

P330 crop factor

Sensor diagonal in mm = 9.41 mm
Crop factor =   43.27  = 4.6
9.41

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

DX3500 equivalent aperture

Crop factor = 5.41
Aperture = f3.3 - f4.5

35-mm equivalent aperture = (f3.3 - f4.5) × 5.41 = f17.9 - f24.3

P330 equivalent aperture

Crop factor = 4.6
Aperture = f1.8 - f5.6

35-mm equivalent aperture = (f1.8 - f5.6) × 4.6 = f8.3 - f25.8

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.