Kodak EasyShare DX6490 vs. Kodak EasyShare Z981

Comparison

change cameras »
EasyShare DX6490 image
vs
EasyShare Z981 image
Kodak EasyShare DX6490 Kodak EasyShare Z981
check price » check price »
Megapixels
4.00
14.00
Max. image resolution
2304 x 1728
4288 x 3216

Sensor

Sensor type
CCD
CCD
Sensor size
1/2.5" (~ 5.75 x 4.32 mm)
1/2.33" (~ 6.08 x 4.56 mm)
Sensor resolution
2306 x 1734
4315 x 3244
Diagonal
7.19 mm
7.60 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1.12
(ratio)
Kodak EasyShare DX6490 Kodak EasyShare Z981
Surface area:
24.84 mm² vs 27.72 mm²
Difference: 2.88 mm² (12%)
Z981 sensor is approx. 1.12x bigger than DX6490 sensor.
Note: You are comparing sensors of very different generations. There is a gap of 7 years between Kodak DX6490 (2003) and Kodak Z981 (2010). Seven years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.
Pixel pitch
2.49 µm
1.41 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 1.08 µm (77%)
Pixel pitch of DX6490 is approx. 77% higher than pixel pitch of Z981.
Pixel area
6.2 µm²
1.99 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 4.21 µm² (212%)
A pixel on Kodak DX6490 sensor is approx. 212% bigger than a pixel on Kodak Z981.
Pixel density
16.08 MP/cm²
50.37 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 34.29 µm (213%)
Kodak Z981 has approx. 213% higher pixel density than Kodak DX6490.
To learn about the accuracy of these numbers, click here.



Specs

Kodak DX6490
Kodak Z981
Crop factor
6.02
5.69
Total megapixels
4.20
Effective megapixels
4.00
14.00
Optical zoom
10x
26x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 80, 100, 200, 400, 800
Auto, 64, 100, 200, 400, 800, 1600, 3200, 6400
RAW
Manual focus
Normal focus range
60 cm
70 cm
Macro focus range
12 cm
1 cm
Focal length (35mm equiv.)
38 - 380 mm
26 - 676 mm
Aperture priority
Yes
Yes
Max. aperture
f2.8 - f3.7
f2.8 - f5
Max. aperture (35mm equiv.)
f16.9 - f22.3
f15.9 - f28.5
Metering
Multi, Center-weighted, Spot
Centre weighted, Multi-segment
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
16 sec
16 sec
Max. shutter speed
1/1700 sec
1/2000 sec
Built-in flash
External flash
Viewfinder
Electronic
Electronic
White balance presets
4
5
Screen size
2.2"
3"
Screen resolution
153,000 dots
230,000 dots
Video capture
Max. video resolution
Storage types
SD/MMC card, Internal
SDHC, Secure Digital
USB
USB 1.0
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Kodak Lithium-Ion, dock (optional)
AA (4) batteries (NiMH Rechargeable batteries)
Weight
380 g
519 g
Dimensions
100 x 80 x 81 mm
123.7 x 84.8 x 105.0 mm
Year
2003
2010




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Kodak DX6490 diagonal

The diagonal of DX6490 sensor is not 1/2.5 or 0.4" (10.2 mm) as you might expect, but approximately two thirds of that value - 7.19 mm. If you want to know why, see sensor sizes.

w = 5.75 mm
h = 4.32 mm
Diagonal =  5.75² + 4.32²   = 7.19 mm

Kodak Z981 diagonal

The diagonal of Z981 sensor is not 1/2.33 or 0.43" (10.9 mm) as you might expect, but approximately two thirds of that value - 7.6 mm. If you want to know why, see sensor sizes.

w = 6.08 mm
h = 4.56 mm
Diagonal =  6.08² + 4.56²   = 7.60 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

DX6490 sensor area

Width = 5.75 mm
Height = 4.32 mm

Surface area = 5.75 × 4.32 = 24.84 mm²

Z981 sensor area

Width = 6.08 mm
Height = 4.56 mm

Surface area = 6.08 × 4.56 = 27.72 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

DX6490 pixel pitch

Sensor width = 5.75 mm
Sensor resolution width = 2306 pixels
Pixel pitch =   5.75  × 1000  = 2.49 µm
2306

Z981 pixel pitch

Sensor width = 6.08 mm
Sensor resolution width = 4315 pixels
Pixel pitch =   6.08  × 1000  = 1.41 µm
4315


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

DX6490 pixel area

Pixel pitch = 2.49 µm

Pixel area = 2.49² = 6.2 µm²

Z981 pixel area

Pixel pitch = 1.41 µm

Pixel area = 1.41² = 1.99 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

DX6490 pixel density

Sensor resolution width = 2306 pixels
Sensor width = 0.575 cm

Pixel density = (2306 / 0.575)² / 1000000 = 16.08 MP/cm²

Z981 pixel density

Sensor resolution width = 4315 pixels
Sensor width = 0.608 cm

Pixel density = (4315 / 0.608)² / 1000000 = 50.37 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

DX6490 sensor resolution

Sensor width = 5.75 mm
Sensor height = 4.32 mm
Effective megapixels = 4.00
r = 5.75/4.32 = 1.33
X =  4.00 × 1000000  = 1734
1.33
Resolution horizontal: X × r = 1734 × 1.33 = 2306
Resolution vertical: X = 1734

Sensor resolution = 2306 x 1734

Z981 sensor resolution

Sensor width = 6.08 mm
Sensor height = 4.56 mm
Effective megapixels = 14.00
r = 6.08/4.56 = 1.33
X =  14.00 × 1000000  = 3244
1.33
Resolution horizontal: X × r = 3244 × 1.33 = 4315
Resolution vertical: X = 3244

Sensor resolution = 4315 x 3244


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


DX6490 crop factor

Sensor diagonal in mm = 7.19 mm
Crop factor =   43.27  = 6.02
7.19

Z981 crop factor

Sensor diagonal in mm = 7.60 mm
Crop factor =   43.27  = 5.69
7.60

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

DX6490 equivalent aperture

Crop factor = 6.02
Aperture = f2.8 - f3.7

35-mm equivalent aperture = (f2.8 - f3.7) × 6.02 = f16.9 - f22.3

Z981 equivalent aperture

Crop factor = 5.69
Aperture = f2.8 - f5

35-mm equivalent aperture = (f2.8 - f5) × 5.69 = f15.9 - f28.5

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.