Leica C-LUX 3 vs. Panasonic Lumix DMC-LF1

Comparison

change cameras »
C-LUX 3 image
vs
Lumix DMC-LF1 image
Leica C-LUX 3 Panasonic Lumix DMC-LF1
check price » check price »
Megapixels
10.10
12.10
Max. image resolution
3648 x 2736
4000 x 3000

Sensor

Sensor type
CCD
CMOS
Sensor size
1/2.33" (~ 6.08 x 4.56 mm)
1/1.7" (~ 7.53 x 5.64 mm)
Sensor resolution
3665 x 2756
4027 x 3005
Diagonal
7.60 mm
9.41 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1.53
(ratio)
Leica C-LUX 3 Panasonic Lumix DMC-LF1
Surface area:
27.72 mm² vs 42.47 mm²
Difference: 14.75 mm² (53%)
LF1 sensor is approx. 1.53x bigger than C-LUX 3 sensor.
Note: You are comparing cameras of different generations. There is a 5 year gap between Leica C-LUX 3 (2008) and Panasonic LF1 (2013). All things being equal, newer sensor generations generally outperform the older.
Pixel pitch
1.66 µm
1.87 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.21 µm (13%)
Pixel pitch of LF1 is approx. 13% higher than pixel pitch of C-LUX 3.
Pixel area
2.76 µm²
3.5 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 0.74 µm² (27%)
A pixel on Panasonic LF1 sensor is approx. 27% bigger than a pixel on Leica C-LUX 3.
Pixel density
36.34 MP/cm²
28.6 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 7.74 µm (27%)
Leica C-LUX 3 has approx. 27% higher pixel density than Panasonic LF1.
To learn about the accuracy of these numbers, click here.



Specs

Leica C-LUX 3
Panasonic LF1
Crop factor
5.69
4.6
Total megapixels
10.70
12.80
Effective megapixels
10.10
12.10
Optical zoom
5x
7.1x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 100, 200, 400, 800, 1600
Auto, 80, 100, 200, 400, 800, 1600, 3200, 6400, (12800 with boost)
RAW
Manual focus
Normal focus range
60 cm
50 cm
Macro focus range
30 cm
3 cm
Focal length (35mm equiv.)
25 - 125 mm
28 - 200 mm
Aperture priority
No
Yes
Max. aperture
f2.8 - f5.9
f2 - f5.9
Max. aperture (35mm equiv.)
f15.9 - f33.6
f9.2 - f27.1
Metering
Multi, Center-weighted, Spot
Multi, Center-weighted, Spot
Exposure compensation
±3 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
Yes
Min. shutter speed
8 sec
250 sec
Max. shutter speed
1/2000 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
None
Electronic
White balance presets
5
4
Screen size
2.5"
3"
Screen resolution
230,000 dots
920,000 dots
Video capture
Max. video resolution
Storage types
SD/MMC/SDHC card, Internal
SD/SDHC/SDXC
USB
USB 2.0 (480 Mbit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Lithium-Ion rechargeable battery
Lithium-Ion
Weight
146 g
192 g
Dimensions
96 x 52 x 22 mm
102.5 x 62.1 x 27.9 mm
Year
2008
2013




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Leica C-LUX 3 diagonal

The diagonal of C-LUX 3 sensor is not 1/2.33 or 0.43" (10.9 mm) as you might expect, but approximately two thirds of that value - 7.6 mm. If you want to know why, see sensor sizes.

w = 6.08 mm
h = 4.56 mm
Diagonal =  6.08² + 4.56²   = 7.60 mm

Panasonic LF1 diagonal

The diagonal of LF1 sensor is not 1/1.7 or 0.59" (14.9 mm) as you might expect, but approximately two thirds of that value - 9.41 mm. If you want to know why, see sensor sizes.

w = 7.53 mm
h = 5.64 mm
Diagonal =  7.53² + 5.64²   = 9.41 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

C-LUX 3 sensor area

Width = 6.08 mm
Height = 4.56 mm

Surface area = 6.08 × 4.56 = 27.72 mm²

LF1 sensor area

Width = 7.53 mm
Height = 5.64 mm

Surface area = 7.53 × 5.64 = 42.47 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

C-LUX 3 pixel pitch

Sensor width = 6.08 mm
Sensor resolution width = 3665 pixels
Pixel pitch =   6.08  × 1000  = 1.66 µm
3665

LF1 pixel pitch

Sensor width = 7.53 mm
Sensor resolution width = 4027 pixels
Pixel pitch =   7.53  × 1000  = 1.87 µm
4027


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

C-LUX 3 pixel area

Pixel pitch = 1.66 µm

Pixel area = 1.66² = 2.76 µm²

LF1 pixel area

Pixel pitch = 1.87 µm

Pixel area = 1.87² = 3.5 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

C-LUX 3 pixel density

Sensor resolution width = 3665 pixels
Sensor width = 0.608 cm

Pixel density = (3665 / 0.608)² / 1000000 = 36.34 MP/cm²

LF1 pixel density

Sensor resolution width = 4027 pixels
Sensor width = 0.753 cm

Pixel density = (4027 / 0.753)² / 1000000 = 28.6 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

C-LUX 3 sensor resolution

Sensor width = 6.08 mm
Sensor height = 4.56 mm
Effective megapixels = 10.10
r = 6.08/4.56 = 1.33
X =  10.10 × 1000000  = 2756
1.33
Resolution horizontal: X × r = 2756 × 1.33 = 3665
Resolution vertical: X = 2756

Sensor resolution = 3665 x 2756

LF1 sensor resolution

Sensor width = 7.53 mm
Sensor height = 5.64 mm
Effective megapixels = 12.10
r = 7.53/5.64 = 1.34
X =  12.10 × 1000000  = 3005
1.34
Resolution horizontal: X × r = 3005 × 1.34 = 4027
Resolution vertical: X = 3005

Sensor resolution = 4027 x 3005


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


C-LUX 3 crop factor

Sensor diagonal in mm = 7.60 mm
Crop factor =   43.27  = 5.69
7.60

LF1 crop factor

Sensor diagonal in mm = 9.41 mm
Crop factor =   43.27  = 4.6
9.41

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

C-LUX 3 equivalent aperture

Crop factor = 5.69
Aperture = f2.8 - f5.9

35-mm equivalent aperture = (f2.8 - f5.9) × 5.69 = f15.9 - f33.6

LF1 equivalent aperture

Crop factor = 4.6
Aperture = f2 - f5.9

35-mm equivalent aperture = (f2 - f5.9) × 4.6 = f9.2 - f27.1

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.