Nikon 1 J2 vs. Panasonic Lumix DMC-LX7
Comparison
change cameras » | |||||
|
vs |
|
|||
Nikon 1 J2 | Panasonic Lumix DMC-LX7 | ||||
check price » | check price » |
Megapixels
10.10
10.10
Max. image resolution
3872 x 2592
3648 x 2736
Sensor
Sensor type
CMOS
CMOS
Sensor size
13.2 x 8.8 mm
1/1.7" (~ 7.53 x 5.64 mm)
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera.
Sensors can vary greatly in size. As a general rule, the bigger the
sensor, the better the image quality.
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Actual sensor size
Note: Actual size is set to screen → change »
|
vs |
|
2.74 | : | 1 |
(ratio) | ||
Nikon 1 J2 | Panasonic Lumix DMC-LX7 |
Surface area:
116.16 mm² | vs | 42.47 mm² |
Difference: 73.69 mm² (174%)
1 J2 sensor is approx. 2.74x bigger than LX7 sensor.
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Pixel or photosite area affects how much light per pixel can be gathered.
The larger it is the more light can be collected by a single pixel.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 7.29 µm² (174%)
A pixel on Nikon 1 J2 sensor is approx. 174% bigger than a pixel on Panasonic LX7.
Pixel density tells you how many million pixels fit or would fit in one
square cm of the sensor.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
To learn about the accuracy of these numbers,
click here.
Specs
Nikon 1 J2
Panasonic LX7
Total megapixels
12.00
12.80
Effective megapixels
10.10
10.10
Optical zoom
3.8x
Digital zoom
No
Yes
ISO sensitivity
100-3200, 6400
Auto, 80, 100, 200, 400, 800, 1600, 3200, 6400, (12800 with boost)
RAW
Manual focus
Normal focus range
50 cm
Macro focus range
1 cm
Focal length (35mm equiv.)
24 - 90 mm
Aperture priority
Yes
Yes
Max. aperture
f1.4 - f2.3
Metering
Multi, Center-weighted, Spot
Multi, Center-weighted, Spot
Exposure compensation
±3 EV (in 1/3 EV steps)
±3 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
30 sec
60 sec
Max. shutter speed
1/16000 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
None
Electronic (optional)
White balance presets
7
5
Screen size
3"
3"
Screen resolution
921,000 dots
920,000 dots
Video capture
Max. video resolution
1920x1080 (60p/60i/30p)
Storage types
SD/SDHC/SDXC
SD/SDHC/SDXC, Internal
USB
USB 2.0 (480 Mbit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Lithium-Ion EN-EL20 rechargeable battery
Lithium-Ion rechargeable battery
Weight
238 g
298 g
Dimensions
106 x 61 x 29.8 mm
111 x 68 x 46 mm
Year
2012
2012
Choose cameras to compare
Popular comparisons:
- Nikon 1 J2 vs. Nikon 1 J3
- Nikon 1 J2 vs. Olympus PEN E-PL3
- Nikon 1 J2 vs. Canon EOS M
- Nikon 1 J2 vs. Canon PowerShot G15
- Nikon 1 J2 vs. Sony Cyber-shot DSC-RX100
- Nikon 1 J2 vs. Panasonic Lumix DMC-LX7
- Nikon 1 J2 vs. Olympus PEN E-PM1
- Nikon 1 J2 vs. Nikon Coolpix P330
- Nikon 1 J2 vs. Olympus PEN E-PM2
- Nikon 1 J2 vs. Panasonic Lumix DMC-GX1
- Nikon 1 J2 vs. Canon PowerShot S110
Diagonal
Diagonal is calculated by the use of Pythagorean theorem:
where w = sensor width and h = sensor height
Diagonal = √ | w² + h² |
Nikon 1 J2 diagonal
w = 13.20 mm
h = 8.80 mm
h = 8.80 mm
Diagonal = √ | 13.20² + 8.80² | = 15.86 mm |
Panasonic LX7 diagonal
The diagonal of LX7 sensor is not 1/1.7 or 0.59" (14.9 mm) as you might expect, but approximately two thirds of
that value - 9.41 mm. If you want to know why, see
sensor sizes.
w = 7.53 mm
h = 5.64 mm
w = 7.53 mm
h = 5.64 mm
Diagonal = √ | 7.53² + 5.64² | = 9.41 mm |
Surface area
Surface area is calculated by multiplying the width and the height of a sensor.
1 J2 sensor area
Width = 13.20 mm
Height = 8.80 mm
Surface area = 13.20 × 8.80 = 116.16 mm²
Height = 8.80 mm
Surface area = 13.20 × 8.80 = 116.16 mm²
LX7 sensor area
Width = 7.53 mm
Height = 5.64 mm
Surface area = 7.53 × 5.64 = 42.47 mm²
Height = 5.64 mm
Surface area = 7.53 × 5.64 = 42.47 mm²
Pixel pitch
Pixel pitch is the distance from the center of one pixel to the center of the
next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch = | sensor width in mm | × 1000 |
sensor resolution width in pixels |
1 J2 pixel pitch
Sensor width = 13.20 mm
Sensor resolution width = 3893 pixels
Sensor resolution width = 3893 pixels
Pixel pitch = | 13.20 | × 1000 | = 3.39 µm |
3893 |
LX7 pixel pitch
Sensor width = 7.53 mm
Sensor resolution width = 3678 pixels
Sensor resolution width = 3678 pixels
Pixel pitch = | 7.53 | × 1000 | = 2.05 µm |
3678 |
Pixel area
The area of one pixel can be calculated by simply squaring the pixel pitch:
You could also divide sensor surface area with effective megapixels:
Pixel area = pixel pitch²
You could also divide sensor surface area with effective megapixels:
Pixel area = | sensor surface area in mm² |
effective megapixels |
1 J2 pixel area
Pixel pitch = 3.39 µm
Pixel area = 3.39² = 11.49 µm²
Pixel area = 3.39² = 11.49 µm²
LX7 pixel area
Pixel pitch = 2.05 µm
Pixel area = 2.05² = 4.2 µm²
Pixel area = 2.05² = 4.2 µm²
Pixel density
Pixel density can be calculated with the following formula:
One could also use this formula:
Pixel density = ( | sensor resolution width in pixels | )² / 1000000 |
sensor width in cm |
One could also use this formula:
Pixel density = | effective megapixels × 1000000 | / 10000 |
sensor surface area in mm² |
1 J2 pixel density
Sensor resolution width = 3893 pixels
Sensor width = 1.32 cm
Pixel density = (3893 / 1.32)² / 1000000 = 8.7 MP/cm²
Sensor width = 1.32 cm
Pixel density = (3893 / 1.32)² / 1000000 = 8.7 MP/cm²
LX7 pixel density
Sensor resolution width = 3678 pixels
Sensor width = 0.753 cm
Pixel density = (3678 / 0.753)² / 1000000 = 23.86 MP/cm²
Sensor width = 0.753 cm
Pixel density = (3678 / 0.753)² / 1000000 = 23.86 MP/cm²
Sensor resolution
Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher
than maximum (not interpolated) image resolution which is usually stated on camera specifications.
Sensor resolution is used in pixel pitch, pixel area, and pixel density formula.
For sake of simplicity, we're going to calculate it in 3 stages.
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
3. To get sensor resolution we then multiply X with the corresponding ratio:
Resolution horizontal: X × r
Resolution vertical: X
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000 → |
|
Resolution horizontal: X × r
Resolution vertical: X
1 J2 sensor resolution
Sensor width = 13.20 mm
Sensor height = 8.80 mm
Effective megapixels = 10.10
Resolution horizontal: X × r = 2595 × 1.5 = 3893
Resolution vertical: X = 2595
Sensor resolution = 3893 x 2595
Sensor height = 8.80 mm
Effective megapixels = 10.10
r = 13.20/8.80 = 1.5 |
|
Resolution vertical: X = 2595
Sensor resolution = 3893 x 2595
LX7 sensor resolution
Sensor width = 7.53 mm
Sensor height = 5.64 mm
Effective megapixels = 10.10
Resolution horizontal: X × r = 2745 × 1.34 = 3678
Resolution vertical: X = 2745
Sensor resolution = 3678 x 2745
Sensor height = 5.64 mm
Effective megapixels = 10.10
r = 7.53/5.64 = 1.34 |
|
Resolution vertical: X = 2745
Sensor resolution = 3678 x 2745
Crop factor
Crop factor or focal length multiplier is calculated by dividing the diagonal
of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor = | 43.27 mm |
sensor diagonal in mm |
1 J2 crop factor
Sensor diagonal in mm = 15.86 mm
Crop factor = | 43.27 | = 2.73 |
15.86 |
LX7 crop factor
Sensor diagonal in mm = 9.41 mm
Crop factor = | 43.27 | = 4.6 |
9.41 |
35 mm equivalent aperture
Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture
with crop factor (a.k.a. focal length multiplier).
1 J2 equivalent aperture
Aperture is a lens characteristic, so it's calculated only for
fixed lens cameras. If you want to know the equivalent aperture for
Nikon 1 J2, take the aperture of the lens
you're using and multiply it with crop factor.
Crop factor for Nikon 1 J2 is 2.73
Crop factor for Nikon 1 J2 is 2.73
LX7 equivalent aperture
Crop factor = 4.6
Aperture = f1.4 - f2.3
35-mm equivalent aperture = (f1.4 - f2.3) × 4.6 = f6.4 - f10.6
Aperture = f1.4 - f2.3
35-mm equivalent aperture = (f1.4 - f2.3) × 4.6 = f6.4 - f10.6
Enter your screen size (diagonal)
My screen size is
inches
Actual size is currently adjusted to screen.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.