Nikon Z fc vs. Olympus OM-D E-M10 Mark IV

Comparison

change cameras »
Z fc image
vs
OM-D E-M10 Mark IV image
Nikon Z fc Olympus OM-D E-M10 Mark IV
check price » check price »
Megapixels
20.90
20.30
Max. image resolution
5568 x 3712
5184 x 3888

Sensor

Sensor type
CMOS
CMOS
Sensor size
23.5 x 15.7 mm
Four Thirds (17.3 x 13 mm)
Sensor resolution
5600 x 3733
5196 x 3907
Diagonal
28.26 mm
21.64 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1.64 : 1
(ratio)
Nikon Z fc Olympus OM-D E-M10 Mark IV
Surface area:
368.95 mm² vs 224.90 mm²
Difference: 144.05 mm² (64%)
Z fc sensor is approx. 1.64x bigger than OM-D E-M10 Mark IV sensor.
Pixel pitch
4.2 µm
3.33 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.87 µm (26%)
Pixel pitch of Z fc is approx. 26% higher than pixel pitch of OM-D E-M10 Mark IV.
Pixel area
17.64 µm²
11.09 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 6.55 µm² (59%)
A pixel on Nikon Z fc sensor is approx. 59% bigger than a pixel on Olympus OM-D E-M10 Mark IV.
Pixel density
5.68 MP/cm²
9.02 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 3.34 µm (59%)
Olympus OM-D E-M10 Mark IV has approx. 59% higher pixel density than Nikon Z fc.
To learn about the accuracy of these numbers, click here.



Specs

Nikon Z fc
Olympus OM-D E-M10 Mark IV
Crop factor
1.53
2
Total megapixels
21.51
21.80
Effective megapixels
20.90
20.30
Optical zoom
Digital zoom
Yes
ISO sensitivity
Auto, 100-51200 (extends to 204800)
Auto, 200-25600 (extends to 100-25600)
RAW
Manual focus
Normal focus range
Macro focus range
Focal length (35mm equiv.)
Aperture priority
Yes
Yes
Max. aperture
Max. aperture (35mm equiv.)
n/a
n/a
Metering
Multi, Center-weighted, Highlight-weighted, Spot
Multi, Center-weighted, Highlight-weighted, Spot
Exposure compensation
±5 EV (in 1/3 EV steps)
±5 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
30 sec
60 sec
Max. shutter speed
1/4000 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
Electronic
Electronic
White balance presets
8
7
Screen size
3"
3"
Screen resolution
1,036,800 dots
1,037,000 dots
Video capture
Max. video resolution
3840x2160 (30p/​25p/​24p)
3840x2160 (30p/​25p/​24p)
Storage types
SD/SDHC/SDXC
SD/SDHC/SDXC
USB
USB 3.0 (5 GBit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
EN-EL25 lithium-ion battery
BLS-50 lithium-ion battery
Weight
390 g
383 g
Dimensions
134.5 x 93.5 x 43.5 mm
121.7 x 84.4 x 49 mm
Year
2021
2020




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Nikon Z fc diagonal

w = 23.50 mm
h = 15.70 mm
Diagonal =  23.50² + 15.70²   = 28.26 mm

Olympus OM-D E-M10 Mark IV diagonal

w = 17.30 mm
h = 13.00 mm
Diagonal =  17.30² + 13.00²   = 21.64 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

Z fc sensor area

Width = 23.50 mm
Height = 15.70 mm

Surface area = 23.50 × 15.70 = 368.95 mm²

OM-D E-M10 Mark IV sensor area

Width = 17.30 mm
Height = 13.00 mm

Surface area = 17.30 × 13.00 = 224.90 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

Z fc pixel pitch

Sensor width = 23.50 mm
Sensor resolution width = 5600 pixels
Pixel pitch =   23.50  × 1000  = 4.2 µm
5600

OM-D E-M10 Mark IV pixel pitch

Sensor width = 17.30 mm
Sensor resolution width = 5196 pixels
Pixel pitch =   17.30  × 1000  = 3.33 µm
5196


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

Z fc pixel area

Pixel pitch = 4.2 µm

Pixel area = 4.2² = 17.64 µm²

OM-D E-M10 Mark IV pixel area

Pixel pitch = 3.33 µm

Pixel area = 3.33² = 11.09 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

Z fc pixel density

Sensor resolution width = 5600 pixels
Sensor width = 2.35 cm

Pixel density = (5600 / 2.35)² / 1000000 = 5.68 MP/cm²

OM-D E-M10 Mark IV pixel density

Sensor resolution width = 5196 pixels
Sensor width = 1.73 cm

Pixel density = (5196 / 1.73)² / 1000000 = 9.02 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

Z fc sensor resolution

Sensor width = 23.50 mm
Sensor height = 15.70 mm
Effective megapixels = 20.90
r = 23.50/15.70 = 1.5
X =  20.90 × 1000000  = 3733
1.5
Resolution horizontal: X × r = 3733 × 1.5 = 5600
Resolution vertical: X = 3733

Sensor resolution = 5600 x 3733

OM-D E-M10 Mark IV sensor resolution

Sensor width = 17.30 mm
Sensor height = 13.00 mm
Effective megapixels = 20.30
r = 17.30/13.00 = 1.33
X =  20.30 × 1000000  = 3907
1.33
Resolution horizontal: X × r = 3907 × 1.33 = 5196
Resolution vertical: X = 3907

Sensor resolution = 5196 x 3907


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


Z fc crop factor

Sensor diagonal in mm = 28.26 mm
Crop factor =   43.27  = 1.53
28.26

OM-D E-M10 Mark IV crop factor

Sensor diagonal in mm = 21.64 mm
Crop factor =   43.27  = 2
21.64

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

Z fc equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Nikon Z fc, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Nikon Z fc is 1.53

OM-D E-M10 Mark IV equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Olympus OM-D E-M10 Mark IV, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Olympus OM-D E-M10 Mark IV is 2

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.