Olympus C-4040 Zoom vs. Olympus XZ-1

Comparison

change cameras »
C-4040 Zoom image
vs
XZ-1 image
Olympus C-4040 Zoom Olympus XZ-1
check price » check price »
Megapixels
3.90
10.00
Max. image resolution
3200 x 2400
3648 x 2736

Sensor

Sensor type
CCD
CCD
Sensor size
1/1.8" (~ 7.11 x 5.33 mm)
1/1.63" (~ 7.85 x 5.89 mm)
Sensor resolution
2277 x 1712
3647 x 2742
Diagonal
8.89 mm
9.81 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1.22
(ratio)
Olympus C-4040 Zoom Olympus XZ-1
Surface area:
37.90 mm² vs 46.24 mm²
Difference: 8.34 mm² (22%)
XZ-1 sensor is approx. 1.22x bigger than C-4040 Zoom sensor.
Note: You are comparing sensors of very different generations. There is a gap of 10 years between Olympus C-4040 Zoom (2001) and Olympus XZ-1 (2011). Ten years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.
Pixel pitch
3.12 µm
2.15 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.97 µm (45%)
Pixel pitch of C-4040 Zoom is approx. 45% higher than pixel pitch of XZ-1.
Pixel area
9.73 µm²
4.62 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 5.11 µm² (111%)
A pixel on Olympus C-4040 Zoom sensor is approx. 111% bigger than a pixel on Olympus XZ-1.
Pixel density
10.26 MP/cm²
21.58 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 11.32 µm (110%)
Olympus XZ-1 has approx. 110% higher pixel density than Olympus C-4040 Zoom.
To learn about the accuracy of these numbers, click here.



Specs

Olympus C-4040 Zoom
Olympus XZ-1
Crop factor
4.87
4.41
Total megapixels
4.10
Effective megapixels
3.90
10.00
Optical zoom
3x
4x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 100, 200, 400
Auto, 100 - 6400
RAW
Manual focus
Normal focus range
80 cm
60 cm
Macro focus range
20 cm
1 cm
Focal length (35mm equiv.)
35 - 105 mm
28 - 112 mm
Aperture priority
Yes
Yes
Max. aperture
f1.8 - f2.6
f1.8 - f2.5
Max. aperture (35mm equiv.)
f8.8 - f12.7
f7.9 - f11
Metering
Centre weighted, ESP Digital, Multi Spot, Spot
Centre weighted, ESP Digital, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
16 sec
Bulb+16min sec
Max. shutter speed
1/800 sec
1/2000 sec
Built-in flash
External flash
Viewfinder
Optical (tunnel)
Electronic (optional)
White balance presets
6
7
Screen size
1.8"
3"
Screen resolution
114,000 dots
610,000 dots
Video capture
Max. video resolution
Storage types
SmartMedia
SDHC, SDXC, Secure Digital
USB
USB 1.0
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
AA (4) batteries (NiMH recommended)
Lithium-Ion Li-50B rechargeable battery
Weight
430 g
275 g
Dimensions
110 x 76 x 70 mm
110.6 x 64.8 x 42.3 mm
Year
2001
2011




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Olympus C-4040 Zoom diagonal

The diagonal of C-4040 Zoom sensor is not 1/1.8 or 0.56" (14.1 mm) as you might expect, but approximately two thirds of that value - 8.89 mm. If you want to know why, see sensor sizes.

w = 7.11 mm
h = 5.33 mm
Diagonal =  7.11² + 5.33²   = 8.89 mm

Olympus XZ-1 diagonal

The diagonal of XZ-1 sensor is not 1/1.63 or 0.61" (15.6 mm) as you might expect, but approximately two thirds of that value - 9.81 mm. If you want to know why, see sensor sizes.

w = 7.85 mm
h = 5.89 mm
Diagonal =  7.85² + 5.89²   = 9.81 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

C-4040 Zoom sensor area

Width = 7.11 mm
Height = 5.33 mm

Surface area = 7.11 × 5.33 = 37.90 mm²

XZ-1 sensor area

Width = 7.85 mm
Height = 5.89 mm

Surface area = 7.85 × 5.89 = 46.24 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

C-4040 Zoom pixel pitch

Sensor width = 7.11 mm
Sensor resolution width = 2277 pixels
Pixel pitch =   7.11  × 1000  = 3.12 µm
2277

XZ-1 pixel pitch

Sensor width = 7.85 mm
Sensor resolution width = 3647 pixels
Pixel pitch =   7.85  × 1000  = 2.15 µm
3647


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

C-4040 Zoom pixel area

Pixel pitch = 3.12 µm

Pixel area = 3.12² = 9.73 µm²

XZ-1 pixel area

Pixel pitch = 2.15 µm

Pixel area = 2.15² = 4.62 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

C-4040 Zoom pixel density

Sensor resolution width = 2277 pixels
Sensor width = 0.711 cm

Pixel density = (2277 / 0.711)² / 1000000 = 10.26 MP/cm²

XZ-1 pixel density

Sensor resolution width = 3647 pixels
Sensor width = 0.785 cm

Pixel density = (3647 / 0.785)² / 1000000 = 21.58 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

C-4040 Zoom sensor resolution

Sensor width = 7.11 mm
Sensor height = 5.33 mm
Effective megapixels = 3.90
r = 7.11/5.33 = 1.33
X =  3.90 × 1000000  = 1712
1.33
Resolution horizontal: X × r = 1712 × 1.33 = 2277
Resolution vertical: X = 1712

Sensor resolution = 2277 x 1712

XZ-1 sensor resolution

Sensor width = 7.85 mm
Sensor height = 5.89 mm
Effective megapixels = 10.00
r = 7.85/5.89 = 1.33
X =  10.00 × 1000000  = 2742
1.33
Resolution horizontal: X × r = 2742 × 1.33 = 3647
Resolution vertical: X = 2742

Sensor resolution = 3647 x 2742


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


C-4040 Zoom crop factor

Sensor diagonal in mm = 8.89 mm
Crop factor =   43.27  = 4.87
8.89

XZ-1 crop factor

Sensor diagonal in mm = 9.81 mm
Crop factor =   43.27  = 4.41
9.81

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

C-4040 Zoom equivalent aperture

Crop factor = 4.87
Aperture = f1.8 - f2.6

35-mm equivalent aperture = (f1.8 - f2.6) × 4.87 = f8.8 - f12.7

XZ-1 equivalent aperture

Crop factor = 4.41
Aperture = f1.8 - f2.5

35-mm equivalent aperture = (f1.8 - f2.5) × 4.41 = f7.9 - f11

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.