Olympus D-340R vs. Fujifilm FinePix F10 Zoom

Comparison

change cameras »

Olympus D-340R

Fujifilm FinePix F10 Zoom

check price »

Megapixels

1.20

6.10

Max. image resolution

1280 x 960

2848 x 2136

Sensor

Sensor type

CCD

Sensor size

1/2" (~ 6.4 x 4.8 mm)

1/1.7" (~ 7.53 x 5.64 mm)

Sensor resolution

1264 x 950

2860 x 2134

Diagonal

8.00 mm

9.41 mm

Sensor size comparison

Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »

	vs
1	:	1.38
(ratio)

Olympus D-340R		Fujifilm FinePix F10 Zoom

Surface area:

30.72 mm²

42.47 mm²

Difference: 11.75 mm² (38%)

F10 Zoom sensor is approx. 1.38x bigger than D-340R sensor.

Note: You are comparing sensors of very different generations. There is a gap of 6 years between Olympus D-340R (1999) and Fujifilm F10 Zoom (2005). Six years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.

Pixel pitch

5.06 µm

2.63 µm

Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.

Difference: 2.43 µm (92%)

Pixel pitch of D-340R is approx. 92% higher than pixel pitch of F10 Zoom.

Pixel area

25.6 µm²

6.92 µm²

Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.

Relative pixel sizes:

Pixel area difference: 18.68 µm² (270%)

A pixel on Olympus D-340R sensor is approx. 270% bigger than a pixel on Fujifilm F10 Zoom.

Pixel density

3.9 MP/cm²

14.43 MP/cm²

Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.

Difference: 10.53 µm (270%)

Fujifilm F10 Zoom has approx. 270% higher pixel density than Olympus D-340R.

To learn about the accuracy of these numbers, click here.

Specs

Olympus D-340R

Fujifilm F10 Zoom

Crop factor

5.41

4.6

Total megapixels

1.30

6.30

Effective megapixels

1.20

6.10

Optical zoom

Digital zoom

Yes

ISO sensitivity

100, 200

Auto, 80, 100, 200, 400, 800, 1600

RAW

Manual focus

Normal focus range

70 cm

60 cm

Macro focus range

10 cm

8 cm

Focal length (35mm equiv.)

36 mm

36 - 108 mm

Aperture priority

Max. aperture

f2.8 - f5.6

f2.8 - f5.0

Max. aperture (35mm equiv.)

f15.1 - f30.3

f12.9 - f23

Metering

Multi, Center-weighted, Spot

Multi, Average, Spot

Exposure compensation

-2.1 - +1.5 EV (in 1/3 EV steps)

Shutter priority

Min. shutter speed

1/2 sec

3 sec

Max. shutter speed

1/500 sec

1/2000 sec

Built-in flash

External flash

Viewfinder

Optical (tunnel)

None

White balance presets

Screen size

1.8"

2.5"

Screen resolution

114,000 dots

115,000 dots

Video capture

Max. video resolution

Storage types

SmartMedia

xD Picture Card

USB

USB 1.0

HDMI

Wireless

GPS

Battery

AA (4) batteries (NiMH recommended)

Lithium-Ion (NP-120)

Weight

320 g

190 g

Dimensions

128 x 65 x 45 mm

92 x 58 x 27 mm

Year

1999

2005

Choose cameras to compare

Popular comparisons:

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:

Diagonal = √

w² + h²

where w = sensor width and h = sensor height

Olympus D-340R diagonal

The diagonal of D-340R sensor is not 1/2 or 0.5" (12.7 mm) as you might expect, but approximately two thirds of that value - 8 mm. If you want to know why, see sensor sizes.

w = 6.40 mm
h = 4.80 mm

Diagonal = √

6.40² + 4.80²

= 8.00 mm

Fujifilm F10 Zoom diagonal

The diagonal of F10 Zoom sensor is not 1/1.7 or 0.59" (14.9 mm) as you might expect, but approximately two thirds of that value - 9.41 mm. If you want to know why, see sensor sizes.

w = 7.53 mm
h = 5.64 mm

Diagonal = √

7.53² + 5.64²

= 9.41 mm

Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

D-340R sensor area

Width = 6.40 mm
Height = 4.80 mm

Surface area = 6.40 × 4.80 = 30.72 mm²

F10 Zoom sensor area

Width = 7.53 mm
Height = 5.64 mm

Surface area = 7.53 × 5.64 = 42.47 mm²

Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:

Pixel pitch =	sensor width in mm	× 1000
	sensor resolution width in pixels

D-340R pixel pitch

Sensor width = 6.40 mm
Sensor resolution width = 1264 pixels

Pixel pitch =	6.40	× 1000	= 5.06 µm
	1264

F10 Zoom pixel pitch

Sensor width = 7.53 mm
Sensor resolution width = 2860 pixels

Pixel pitch =	7.53	× 1000	= 2.63 µm
	2860

Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:

Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:

Pixel area =	sensor surface area in mm²
	effective megapixels

D-340R pixel area

Pixel pitch = 5.06 µm

Pixel area = 5.06² = 25.6 µm²

F10 Zoom pixel area

Pixel pitch = 2.63 µm

Pixel area = 2.63² = 6.92 µm²

Pixel density

Pixel density can be calculated with the following formula:

Pixel density = (	sensor resolution width in pixels	)² / 1000000
	sensor width in cm

One could also use this formula:

Pixel density =	effective megapixels × 1000000	/ 10000
	sensor surface area in mm²

D-340R pixel density

Sensor resolution width = 1264 pixels
Sensor width = 0.64 cm

Pixel density = (1264 / 0.64)² / 1000000 = 3.9 MP/cm²

F10 Zoom pixel density

Sensor resolution width = 2860 pixels
Sensor width = 0.753 cm

Pixel density = (2860 / 0.753)² / 1000000 = 14.43 MP/cm²

Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:

(X × r) × X = effective megapixels × 1000000 →

X = √	effective megapixels × 1000000
	r

3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

D-340R sensor resolution

Sensor width = 6.40 mm
Sensor height = 4.80 mm
Effective megapixels = 1.20

r = 6.40/4.80 = 1.33

X = √	1.20 × 1000000	= 950
	1.33

Resolution horizontal: X × r = 950 × 1.33 = 1264
Resolution vertical: X = 950

Sensor resolution = 1264 x 950

F10 Zoom sensor resolution

Sensor width = 7.53 mm
Sensor height = 5.64 mm
Effective megapixels = 6.10

r = 7.53/5.64 = 1.34

X = √	6.10 × 1000000	= 2134
	1.34

Resolution horizontal: X × r = 2134 × 1.34 = 2860
Resolution vertical: X = 2134

Sensor resolution = 2860 x 2134

Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.

Crop factor =	43.27 mm
	sensor diagonal in mm

D-340R crop factor

Sensor diagonal in mm = 8.00 mm

Crop factor =	43.27	= 5.41
	8.00

F10 Zoom crop factor

Sensor diagonal in mm = 9.41 mm

Crop factor =	43.27	= 4.6
	9.41

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

D-340R equivalent aperture

Crop factor = 5.41
Aperture = f2.8 - f5.6

35-mm equivalent aperture = (f2.8 - f5.6) × 5.41 = f15.1 - f30.3

F10 Zoom equivalent aperture

Crop factor = 4.6
Aperture = f2.8 - f5.0

35-mm equivalent aperture = (f2.8 - f5.0) × 4.6 = f12.9 - f23

Enter your screen size (diagonal)

My screen size is inches

Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.