Olympus E-10 vs. Olympus C-8080 Wide Zoom

Comparison

change cameras »
E-10 image
vs
C-8080 Wide Zoom image
Olympus E-10 Olympus C-8080 Wide Zoom
check price » check price »
Megapixels
3.70
8.00
Max. image resolution
2240 x 1680
3264 x 2448

Sensor

Sensor type
CCD
CCD
Sensor size
2/3" (~ 8.8 x 6.6 mm)
2/3" (~ 8.8 x 6.6 mm)
Sensor resolution
2218 x 1668
3262 x 2453
Diagonal
11.00 mm
11.00 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1
(ratio)
Olympus E-10 Olympus C-8080 Wide Zoom
Surface area:
58.08 mm² vs 58.08 mm²
Difference: 0 mm² (0%)
E-10 and C-8080 Wide Zoom sensors are the same size.
Note: You are comparing cameras of different generations. There is a 4 year gap between Olympus E-10 (2000) and Olympus C-8080 Wide Zoom (2004). All things being equal, newer sensor generations generally outperform the older.
Pixel pitch
3.97 µm
2.7 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 1.27 µm (47%)
Pixel pitch of E-10 is approx. 47% higher than pixel pitch of C-8080 Wide Zoom.
Pixel area
15.76 µm²
7.29 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 8.47 µm² (116%)
A pixel on Olympus E-10 sensor is approx. 116% bigger than a pixel on Olympus C-8080 Wide Zoom.
Pixel density
6.35 MP/cm²
13.74 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 7.39 µm (116%)
Olympus C-8080 Wide Zoom has approx. 116% higher pixel density than Olympus E-10.
To learn about the accuracy of these numbers, click here.



Specs

Olympus E-10
Olympus C-8080 Wide Zoom
Crop factor
3.93
3.93
Total megapixels
4.00
8.30
Effective megapixels
3.70
8.00
Optical zoom
4x
5x
Digital zoom
Yes
Yes
ISO sensitivity
80, 160, 320
50, 80, 100, 125, 160, 200, 250, 320, 400
RAW
Manual focus
Normal focus range
60 cm
80 cm
Macro focus range
20 cm
5 cm
Focal length (35mm equiv.)
35 - 140 mm
28 - 140 mm
Aperture priority
Yes
Yes
Max. aperture
f2.0 - f2.4
f2.4 - f3.5
Max. aperture (35mm equiv.)
f7.9 - f9.4
f9.4 - f13.8
Metering
Centre weighted, ESP Digital, Spot
Centre weighted, ESP Digital, Multi Spot, Spot
Exposure compensation
±3 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV, 1/2 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
30 sec
B+480 sec
Max. shutter speed
1/640 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
Optical (tunnel)
Electronic
White balance presets
7
6
Screen size
1.8"
1.8"
Screen resolution
114,000 dots
134,000 dots
Video capture
Max. video resolution
Storage types
CompactFlash type I, CompactFlash type II, Microdrive, SmartMedia
CompactFlash type I, CompactFlash type II, Microdrive, xD Picture
USB
USB 1.0
USB 1.0
HDMI
Wireless
GPS
Battery
AA NiMH (4) batteries (supplied)
Lithium-Ion rechargeable
Weight
1190 g
660 g
Dimensions
129 x 104 x 161 mm
124 x 84.5 x 99 mm
Year
2000
2004




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Olympus E-10 diagonal

The diagonal of E-10 sensor is not 2/3 or 0.67" (16.9 mm) as you might expect, but approximately two thirds of that value - 11 mm. If you want to know why, see sensor sizes.

w = 8.80 mm
h = 6.60 mm
Diagonal =  8.80² + 6.60²   = 11.00 mm

Olympus C-8080 Wide Zoom diagonal

The diagonal of C-8080 Wide Zoom sensor is not 2/3 or 0.67" (16.9 mm) as you might expect, but approximately two thirds of that value - 11 mm. If you want to know why, see sensor sizes.

w = 8.80 mm
h = 6.60 mm
Diagonal =  8.80² + 6.60²   = 11.00 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

E-10 sensor area

Width = 8.80 mm
Height = 6.60 mm

Surface area = 8.80 × 6.60 = 58.08 mm²

C-8080 Wide Zoom sensor area

Width = 8.80 mm
Height = 6.60 mm

Surface area = 8.80 × 6.60 = 58.08 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

E-10 pixel pitch

Sensor width = 8.80 mm
Sensor resolution width = 2218 pixels
Pixel pitch =   8.80  × 1000  = 3.97 µm
2218

C-8080 Wide Zoom pixel pitch

Sensor width = 8.80 mm
Sensor resolution width = 3262 pixels
Pixel pitch =   8.80  × 1000  = 2.7 µm
3262


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

E-10 pixel area

Pixel pitch = 3.97 µm

Pixel area = 3.97² = 15.76 µm²

C-8080 Wide Zoom pixel area

Pixel pitch = 2.7 µm

Pixel area = 2.7² = 7.29 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

E-10 pixel density

Sensor resolution width = 2218 pixels
Sensor width = 0.88 cm

Pixel density = (2218 / 0.88)² / 1000000 = 6.35 MP/cm²

C-8080 Wide Zoom pixel density

Sensor resolution width = 3262 pixels
Sensor width = 0.88 cm

Pixel density = (3262 / 0.88)² / 1000000 = 13.74 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

E-10 sensor resolution

Sensor width = 8.80 mm
Sensor height = 6.60 mm
Effective megapixels = 3.70
r = 8.80/6.60 = 1.33
X =  3.70 × 1000000  = 1668
1.33
Resolution horizontal: X × r = 1668 × 1.33 = 2218
Resolution vertical: X = 1668

Sensor resolution = 2218 x 1668

C-8080 Wide Zoom sensor resolution

Sensor width = 8.80 mm
Sensor height = 6.60 mm
Effective megapixels = 8.00
r = 8.80/6.60 = 1.33
X =  8.00 × 1000000  = 2453
1.33
Resolution horizontal: X × r = 2453 × 1.33 = 3262
Resolution vertical: X = 2453

Sensor resolution = 3262 x 2453


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


E-10 crop factor

Sensor diagonal in mm = 11.00 mm
Crop factor =   43.27  = 3.93
11.00

C-8080 Wide Zoom crop factor

Sensor diagonal in mm = 11.00 mm
Crop factor =   43.27  = 3.93
11.00

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

E-10 equivalent aperture

Crop factor = 3.93
Aperture = f2.0 - f2.4

35-mm equivalent aperture = (f2.0 - f2.4) × 3.93 = f7.9 - f9.4

C-8080 Wide Zoom equivalent aperture

Crop factor = 3.93
Aperture = f2.4 - f3.5

35-mm equivalent aperture = (f2.4 - f3.5) × 3.93 = f9.4 - f13.8

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.