Olympus E-500 / EVOLT E-500 vs. Olympus E-520

Comparison

change cameras »
E-500 / EVOLT E-500 image
vs
E-520 image
Olympus E-500 / EVOLT E-500 Olympus E-520
check price » check price »
Megapixels
8.00
10.00
Max. image resolution
3264 x 2448
3648 x 2736

Sensor

Sensor type
CCD
CMOS
Sensor size
Four Thirds (17.3 x 13 mm)
Four Thirds (17.3 x 13 mm)
Sensor resolution
3262 x 2453
3647 x 2742
Diagonal
21.64 mm
21.64 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1
(ratio)
Olympus E-500 / EVOLT E-500 Olympus E-520
Surface area:
224.90 mm² vs 224.90 mm²
Difference: 0 mm² (0%)
E-500 / EVOLT E-500 and E-520 sensors are the same size.
Note: You are comparing cameras of different generations. There is a 3 year gap between Olympus E-500 / EVOLT E-500 (2005) and Olympus E-520 (2008). All things being equal, newer sensor generations generally outperform the older.
Pixel pitch
5.3 µm
4.74 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.56 µm (12%)
Pixel pitch of E-500 / EVOLT E-500 is approx. 12% higher than pixel pitch of E-520.
Pixel area
28.09 µm²
22.47 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 5.62 µm² (25%)
A pixel on Olympus E-500 / EVOLT E-500 sensor is approx. 25% bigger than a pixel on Olympus E-520.
Pixel density
3.56 MP/cm²
4.44 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 0.88 µm (25%)
Olympus E-520 has approx. 25% higher pixel density than Olympus E-500 / EVOLT E-500.
To learn about the accuracy of these numbers, click here.



Specs

Olympus E-500 / EVOLT E-500
Olympus E-520
Crop factor
2
2
Total megapixels
8.90
11.80
Effective megapixels
8.00
10.00
Optical zoom
Digital zoom
No
No
ISO sensitivity
Auto, 100, 125, 160, 200, 250, 320, 400, 500, 640, 800, 50, 1600, 2000, 2500, 3200, 4000, 5000, 6400, 8000, 10000, 12800
Auto, 100, 200, 400, 800, 1600
RAW
Manual focus
Normal focus range
Macro focus range
Focal length (35mm equiv.)
Aperture priority
Yes
Yes
Max. aperture
Max. aperture (35mm equiv.)
n/a
n/a
Metering
Centre weighted, ESP Digital, Spot
Multi, Center-weighted, Spot
Exposure compensation
±5 EV (in 1/3 EV, 1/2 EV, 1 EV steps)
±5 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
B+60 sec
60 sec
Max. shutter speed
1/4000 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
Optical
Optical (pentamirror)
White balance presets
3
8
Screen size
2.5"
2.7"
Screen resolution
215,250 dots
230,000 dots
Video capture
Max. video resolution
Storage types
CompactFlash type I, CompactFlash type II, Microdrive, xD Picture
Compact Flash (Type I or II), xD Picture Card
USB
USB 2.0 (480 Mbit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Li-Ion
Lithium-Ion rechargeable
Weight
479 g
552 g
Dimensions
129.5 x 94.5 x 66 mm
136 x 92 x 68 mm
Year
2005
2008




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Olympus E-500 / EVOLT E-500 diagonal

w = 17.30 mm
h = 13.00 mm
Diagonal =  17.30² + 13.00²   = 21.64 mm

Olympus E-520 diagonal

w = 17.30 mm
h = 13.00 mm
Diagonal =  17.30² + 13.00²   = 21.64 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

E-500 / EVOLT E-500 sensor area

Width = 17.30 mm
Height = 13.00 mm

Surface area = 17.30 × 13.00 = 224.90 mm²

E-520 sensor area

Width = 17.30 mm
Height = 13.00 mm

Surface area = 17.30 × 13.00 = 224.90 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

E-500 / EVOLT E-500 pixel pitch

Sensor width = 17.30 mm
Sensor resolution width = 3262 pixels
Pixel pitch =   17.30  × 1000  = 5.3 µm
3262

E-520 pixel pitch

Sensor width = 17.30 mm
Sensor resolution width = 3647 pixels
Pixel pitch =   17.30  × 1000  = 4.74 µm
3647


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

E-500 / EVOLT E-500 pixel area

Pixel pitch = 5.3 µm

Pixel area = 5.3² = 28.09 µm²

E-520 pixel area

Pixel pitch = 4.74 µm

Pixel area = 4.74² = 22.47 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

E-500 / EVOLT E-500 pixel density

Sensor resolution width = 3262 pixels
Sensor width = 1.73 cm

Pixel density = (3262 / 1.73)² / 1000000 = 3.56 MP/cm²

E-520 pixel density

Sensor resolution width = 3647 pixels
Sensor width = 1.73 cm

Pixel density = (3647 / 1.73)² / 1000000 = 4.44 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

E-500 / EVOLT E-500 sensor resolution

Sensor width = 17.30 mm
Sensor height = 13.00 mm
Effective megapixels = 8.00
r = 17.30/13.00 = 1.33
X =  8.00 × 1000000  = 2453
1.33
Resolution horizontal: X × r = 2453 × 1.33 = 3262
Resolution vertical: X = 2453

Sensor resolution = 3262 x 2453

E-520 sensor resolution

Sensor width = 17.30 mm
Sensor height = 13.00 mm
Effective megapixels = 10.00
r = 17.30/13.00 = 1.33
X =  10.00 × 1000000  = 2742
1.33
Resolution horizontal: X × r = 2742 × 1.33 = 3647
Resolution vertical: X = 2742

Sensor resolution = 3647 x 2742


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


E-500 / EVOLT E-500 crop factor

Sensor diagonal in mm = 21.64 mm
Crop factor =   43.27  = 2
21.64

E-520 crop factor

Sensor diagonal in mm = 21.64 mm
Crop factor =   43.27  = 2
21.64

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

E-500 / EVOLT E-500 equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Olympus E-500 / EVOLT E-500, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Olympus E-500 / EVOLT E-500 is 2

E-520 equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Olympus E-520, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Olympus E-520 is 2

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.