Olympus PEN E-PL5 vs. Panasonic Lumix DMC-LX7

Comparison

change cameras »
PEN E-PL5 image
vs
Lumix DMC-LX7 image
Olympus PEN E-PL5 Panasonic Lumix DMC-LX7
check price » check price »
Megapixels
16.10
10.10
Max. image resolution
4608 x 3456
3648 x 2736

Sensor

Sensor type
CMOS
CMOS
Sensor size
Four Thirds (17.3 x 13 mm)
1/1.7" (~ 7.53 x 5.64 mm)
Sensor resolution
4627 x 3479
3678 x 2745
Diagonal
21.64 mm
9.41 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
5.3 : 1
(ratio)
Olympus PEN E-PL5 Panasonic Lumix DMC-LX7
Surface area:
224.90 mm² vs 42.47 mm²
Difference: 182.43 mm² (430%)
PEN E-PL5 sensor is approx. 5.3x bigger than LX7 sensor.
Pixel pitch
3.74 µm
2.05 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 1.69 µm (82%)
Pixel pitch of PEN E-PL5 is approx. 82% higher than pixel pitch of LX7.
Pixel area
13.99 µm²
4.2 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 9.79 µm² (233%)
A pixel on Olympus PEN E-PL5 sensor is approx. 233% bigger than a pixel on Panasonic LX7.
Pixel density
7.15 MP/cm²
23.86 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 16.71 µm (234%)
Panasonic LX7 has approx. 234% higher pixel density than Olympus PEN E-PL5.
To learn about the accuracy of these numbers, click here.



Specs

Olympus PEN E-PL5
Panasonic LX7
Crop factor
2
4.6
Total megapixels
17.20
12.80
Effective megapixels
16.10
10.10
Optical zoom
3.8x
Digital zoom
No
Yes
ISO sensitivity
Auto, 200 - 25600
Auto, 80, 100, 200, 400, 800, 1600, 3200, 6400, (12800 with boost)
RAW
Manual focus
Normal focus range
50 cm
Macro focus range
1 cm
Focal length (35mm equiv.)
24 - 90 mm
Aperture priority
Yes
Yes
Max. aperture
f1.4 - f2.3
Max. aperture (35mm equiv.)
n/a
f6.4 - f10.6
Metering
Multi, Center-weighted, Spot
Multi, Center-weighted, Spot
Exposure compensation
±3 EV (in 1/3 EV, 1/2 EV, 1 EV steps)
±3 EV (in 1/3 EV steps)
Shutter priority
Yes
Yes
Min. shutter speed
60 sec
60 sec
Max. shutter speed
1/4000 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
Electronic (optional)
Electronic (optional)
White balance presets
8
5
Screen size
3"
3"
Screen resolution
460,000 dots
920,000 dots
Video capture
Max. video resolution
1920x1080 (30p)
1920x1080 (60p/60i/30p)
Storage types
SD/SDHC/SDXC
SD/SDHC/SDXC, Internal
USB
USB 2.0 (480 Mbit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Lithium-Ion BLS-5 rechargeable battery
Lithium-Ion rechargeable battery
Weight
325 g
298 g
Dimensions
110.5 x 63.7 x 38.2 mm
111 x 68 x 46 mm
Year
2012
2012




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Olympus PEN E-PL5 diagonal

w = 17.30 mm
h = 13.00 mm
Diagonal =  17.30² + 13.00²   = 21.64 mm

Panasonic LX7 diagonal

The diagonal of LX7 sensor is not 1/1.7 or 0.59" (14.9 mm) as you might expect, but approximately two thirds of that value - 9.41 mm. If you want to know why, see sensor sizes.

w = 7.53 mm
h = 5.64 mm
Diagonal =  7.53² + 5.64²   = 9.41 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

PEN E-PL5 sensor area

Width = 17.30 mm
Height = 13.00 mm

Surface area = 17.30 × 13.00 = 224.90 mm²

LX7 sensor area

Width = 7.53 mm
Height = 5.64 mm

Surface area = 7.53 × 5.64 = 42.47 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

PEN E-PL5 pixel pitch

Sensor width = 17.30 mm
Sensor resolution width = 4627 pixels
Pixel pitch =   17.30  × 1000  = 3.74 µm
4627

LX7 pixel pitch

Sensor width = 7.53 mm
Sensor resolution width = 3678 pixels
Pixel pitch =   7.53  × 1000  = 2.05 µm
3678


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

PEN E-PL5 pixel area

Pixel pitch = 3.74 µm

Pixel area = 3.74² = 13.99 µm²

LX7 pixel area

Pixel pitch = 2.05 µm

Pixel area = 2.05² = 4.2 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

PEN E-PL5 pixel density

Sensor resolution width = 4627 pixels
Sensor width = 1.73 cm

Pixel density = (4627 / 1.73)² / 1000000 = 7.15 MP/cm²

LX7 pixel density

Sensor resolution width = 3678 pixels
Sensor width = 0.753 cm

Pixel density = (3678 / 0.753)² / 1000000 = 23.86 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

PEN E-PL5 sensor resolution

Sensor width = 17.30 mm
Sensor height = 13.00 mm
Effective megapixels = 16.10
r = 17.30/13.00 = 1.33
X =  16.10 × 1000000  = 3479
1.33
Resolution horizontal: X × r = 3479 × 1.33 = 4627
Resolution vertical: X = 3479

Sensor resolution = 4627 x 3479

LX7 sensor resolution

Sensor width = 7.53 mm
Sensor height = 5.64 mm
Effective megapixels = 10.10
r = 7.53/5.64 = 1.34
X =  10.10 × 1000000  = 2745
1.34
Resolution horizontal: X × r = 2745 × 1.34 = 3678
Resolution vertical: X = 2745

Sensor resolution = 3678 x 2745


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


PEN E-PL5 crop factor

Sensor diagonal in mm = 21.64 mm
Crop factor =   43.27  = 2
21.64

LX7 crop factor

Sensor diagonal in mm = 9.41 mm
Crop factor =   43.27  = 4.6
9.41

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

PEN E-PL5 equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Olympus PEN E-PL5, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Olympus PEN E-PL5 is 2

LX7 equivalent aperture

Crop factor = 4.6
Aperture = f1.4 - f2.3

35-mm equivalent aperture = (f1.4 - f2.3) × 4.6 = f6.4 - f10.6

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.