Olympus VG-120 vs. Nikon Coolpix S2600
Comparison
| change cameras » | |||||
|
vs |
|
|||
| Olympus VG-120 | Nikon Coolpix S2600 | ||||
| check price » | check price » | ||||
Megapixels
14.00
14.48
Max. image resolution
4288 x 3216
4320 x 3240
Sensor
Sensor type
CCD
CCD
Sensor size
1/2.3" (~ 6.16 x 4.62 mm)
1/2.3" (~ 6.16 x 4.62 mm)
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera.
Sensors can vary greatly in size. As a general rule, the bigger the
sensor, the better the image quality.
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Actual sensor size
Note: Actual size is set to screen → change »
|
|
vs |
|
| 1 | : | 1 |
| (ratio) | ||
| Olympus VG-120 | Nikon Coolpix S2600 | |
Surface area:
| 28.46 mm² | vs | 28.46 mm² |
Difference: 0 mm² (0%)
VG-120 and S2600 sensors are the same size.
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Pixel or photosite area affects how much light per pixel can be gathered.
The larger it is the more light can be collected by a single pixel.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 0.08 µm² (4%)
A pixel on Olympus VG-120 sensor is approx. 4% bigger than a pixel on Nikon S2600.
Pixel density tells you how many million pixels fit or would fit in one
square cm of the sensor.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
To learn about the accuracy of these numbers,
click here.
Specs
Olympus VG-120
Nikon S2600
Total megapixels
Effective megapixels
14.00
Optical zoom
5x
Yes
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 100, 200, 400, 800, 1600
Auto, 80 - 3200
RAW
Manual focus
Normal focus range
60 cm
50 cm
Macro focus range
7 cm
10 cm
Focal length (35mm equiv.)
26 - 130 mm
26 - 130 mm
Aperture priority
No
No
Max. aperture
f2.8 - f6.5
f3.2 - f6.5
Metering
ESP Digital
Centre weighted, Matrix, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
No
Min. shutter speed
4 sec
Max. shutter speed
1/2000 sec
Built-in flash
External flash
Viewfinder
None
None
White balance presets
5
Screen size
3"
2.7"
Screen resolution
230,400 dots
230,000 dots
Video capture
Max. video resolution
Storage types
SDHC, Secure Digital
SDHC, SDXC, Secure Digital
USB
USB 2.0 (480 Mbit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Lithium-ion rechargeable LI-70B battery
Li-Ion
Weight
120 g
121 g
Dimensions
96 x 57 x 19 mm
93.8 x 58.4 x 19.5 mm
Year
2011
2011
Choose cameras to compare
Popular comparisons:
- Olympus VG-120 vs. Sony Cyber-shot DSC-T5
- Olympus VG-120 vs. Olympus VG-130
- Olympus VG-120 vs. Nikon Coolpix S2800
- Olympus VG-120 vs. Samsung ST77
- Olympus VG-120 vs. Olympus VR-310
- Olympus VG-120 vs. Olympus VG-150
- Olympus VG-120 vs. Sony Cyber-shot DSC-W690
- Olympus VG-120 vs. Nikon Coolpix S2600
- Olympus VG-120 vs. Canon PowerShot A30
- Olympus VG-120 vs. Olympus Stylus 1040
- Olympus VG-120 vs. Olympus XZ-1
Diagonal
Diagonal is calculated by the use of Pythagorean theorem:
where w = sensor width and h = sensor height
| Diagonal = √ | w² + h² |
Olympus VG-120 diagonal
The diagonal of VG-120 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of
that value - 7.7 mm. If you want to know why, see
sensor sizes.
w = 6.16 mm
h = 4.62 mm
w = 6.16 mm
h = 4.62 mm
| Diagonal = √ | 6.16² + 4.62² | = 7.70 mm |
Nikon S2600 diagonal
The diagonal of S2600 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of
that value - 7.7 mm. If you want to know why, see
sensor sizes.
w = 6.16 mm
h = 4.62 mm
w = 6.16 mm
h = 4.62 mm
| Diagonal = √ | 6.16² + 4.62² | = 7.70 mm |
Surface area
Surface area is calculated by multiplying the width and the height of a sensor.
VG-120 sensor area
Width = 6.16 mm
Height = 4.62 mm
Surface area = 6.16 × 4.62 = 28.46 mm²
Height = 4.62 mm
Surface area = 6.16 × 4.62 = 28.46 mm²
S2600 sensor area
Width = 6.16 mm
Height = 4.62 mm
Surface area = 6.16 × 4.62 = 28.46 mm²
Height = 4.62 mm
Surface area = 6.16 × 4.62 = 28.46 mm²
Pixel pitch
Pixel pitch is the distance from the center of one pixel to the center of the
next measured in micrometers (µm). It can be calculated with the following formula:
| Pixel pitch = | sensor width in mm | × 1000 |
| sensor resolution width in pixels |
VG-120 pixel pitch
Sensor width = 6.16 mm
Sensor resolution width = 4315 pixels
Sensor resolution width = 4315 pixels
| Pixel pitch = | 6.16 | × 1000 | = 1.43 µm |
| 4315 |
S2600 pixel pitch
Sensor width = 6.16 mm
Sensor resolution width = 4389 pixels
Sensor resolution width = 4389 pixels
| Pixel pitch = | 6.16 | × 1000 | = 1.4 µm |
| 4389 |
Pixel area
The area of one pixel can be calculated by simply squaring the pixel pitch:
You could also divide sensor surface area with effective megapixels:
Pixel area = pixel pitch²
You could also divide sensor surface area with effective megapixels:
| Pixel area = | sensor surface area in mm² |
| effective megapixels |
VG-120 pixel area
Pixel pitch = 1.43 µm
Pixel area = 1.43² = 2.04 µm²
Pixel area = 1.43² = 2.04 µm²
S2600 pixel area
Pixel pitch = 1.4 µm
Pixel area = 1.4² = 1.96 µm²
Pixel area = 1.4² = 1.96 µm²
Pixel density
Pixel density can be calculated with the following formula:
One could also use this formula:
| Pixel density = ( | sensor resolution width in pixels | )² / 1000000 |
| sensor width in cm |
One could also use this formula:
| Pixel density = | effective megapixels × 1000000 | / 10000 |
| sensor surface area in mm² |
VG-120 pixel density
Sensor resolution width = 4315 pixels
Sensor width = 0.616 cm
Pixel density = (4315 / 0.616)² / 1000000 = 49.07 MP/cm²
Sensor width = 0.616 cm
Pixel density = (4315 / 0.616)² / 1000000 = 49.07 MP/cm²
S2600 pixel density
Sensor resolution width = 4389 pixels
Sensor width = 0.616 cm
Pixel density = (4389 / 0.616)² / 1000000 = 50.77 MP/cm²
Sensor width = 0.616 cm
Pixel density = (4389 / 0.616)² / 1000000 = 50.77 MP/cm²
Sensor resolution
Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher
than maximum (not interpolated) image resolution which is usually stated on camera specifications.
Sensor resolution is used in pixel pitch, pixel area, and pixel density formula.
For sake of simplicity, we're going to calculate it in 3 stages.
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
3. To get sensor resolution we then multiply X with the corresponding ratio:
Resolution horizontal: X × r
Resolution vertical: X
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
| (X × r) × X = effective megapixels × 1000000 → |
|
Resolution horizontal: X × r
Resolution vertical: X
VG-120 sensor resolution
Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 14.00
Resolution horizontal: X × r = 3244 × 1.33 = 4315
Resolution vertical: X = 3244
Sensor resolution = 4315 x 3244
Sensor height = 4.62 mm
Effective megapixels = 14.00
| r = 6.16/4.62 = 1.33 |
|
Resolution vertical: X = 3244
Sensor resolution = 4315 x 3244
S2600 sensor resolution
Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 14.48
Resolution horizontal: X × r = 3300 × 1.33 = 4389
Resolution vertical: X = 3300
Sensor resolution = 4389 x 3300
Sensor height = 4.62 mm
Effective megapixels = 14.48
| r = 6.16/4.62 = 1.33 |
|
Resolution vertical: X = 3300
Sensor resolution = 4389 x 3300
Crop factor
Crop factor or focal length multiplier is calculated by dividing the diagonal
of 35 mm film (43.27 mm) with the diagonal of the sensor.
| Crop factor = | 43.27 mm |
| sensor diagonal in mm |
VG-120 crop factor
Sensor diagonal in mm = 7.70 mm
| Crop factor = | 43.27 | = 5.62 |
| 7.70 |
S2600 crop factor
Sensor diagonal in mm = 7.70 mm
| Crop factor = | 43.27 | = 5.62 |
| 7.70 |
35 mm equivalent aperture
Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture
with crop factor (a.k.a. focal length multiplier).
VG-120 equivalent aperture
Crop factor = 5.62
Aperture = f2.8 - f6.5
35-mm equivalent aperture = (f2.8 - f6.5) × 5.62 = f15.7 - f36.5
Aperture = f2.8 - f6.5
35-mm equivalent aperture = (f2.8 - f6.5) × 5.62 = f15.7 - f36.5
S2600 equivalent aperture
Crop factor = 5.62
Aperture = f3.2 - f6.5
35-mm equivalent aperture = (f3.2 - f6.5) × 5.62 = f18 - f36.5
Aperture = f3.2 - f6.5
35-mm equivalent aperture = (f3.2 - f6.5) × 5.62 = f18 - f36.5
Enter your screen size (diagonal)
My screen size is
inches
Actual size is currently adjusted to screen.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.