Panasonic Lumix DMC-FX7 vs. Panasonic Lumix DMC-TZ60

Comparison

change cameras »
Lumix DMC-FX7 image
vs
Lumix DMC-TZ60 image
Panasonic Lumix DMC-FX7 Panasonic Lumix DMC-TZ60
check price » check price »
Megapixels
4.90
18.10
Max. image resolution
2560 x 1920
4896 x 3672

Sensor

Sensor type
CCD
CMOS
Sensor size
1/2.5" (~ 5.75 x 4.32 mm)
1/2.3" (~ 6.16 x 4.62 mm)
Sensor resolution
2552 x 1919
4906 x 3689
Diagonal
7.19 mm
7.70 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 1.15
(ratio)
Panasonic Lumix DMC-FX7 Panasonic Lumix DMC-TZ60
Surface area:
24.84 mm² vs 28.46 mm²
Difference: 3.62 mm² (15%)
TZ60 sensor is approx. 1.15x bigger than FX7 sensor.
Note: You are comparing sensors of very different generations. There is a gap of 10 years between Panasonic FX7 (2004) and Panasonic TZ60 (2014). Ten years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.
Pixel pitch
2.25 µm
1.26 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.99 µm (79%)
Pixel pitch of FX7 is approx. 79% higher than pixel pitch of TZ60.
Pixel area
5.06 µm²
1.59 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 3.47 µm² (218%)
A pixel on Panasonic FX7 sensor is approx. 218% bigger than a pixel on Panasonic TZ60.
Pixel density
19.7 MP/cm²
63.43 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 43.73 µm (222%)
Panasonic TZ60 has approx. 222% higher pixel density than Panasonic FX7.
To learn about the accuracy of these numbers, click here.



Specs

Panasonic FX7
Panasonic TZ60
Crop factor
6.02
5.62
Total megapixels
5.40
18.90
Effective megapixels
4.90
18.10
Optical zoom
3x
30x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 80, 100, 200, 400
Auto, 100, 200, 400, 800, 1600, 3200 (6400 with boost)
RAW
Manual focus
Normal focus range
50 cm
50 cm
Macro focus range
5 cm
3 cm
Focal length (35mm equiv.)
35 - 105 mm
24 - 720 mm
Aperture priority
Yes
Yes
Max. aperture
f2.8 - f5
f3.3 - f6.4
Max. aperture (35mm equiv.)
f16.9 - f30.1
f18.5 - f36
Metering
Centre weighted
Multi, Center-weighted, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
Yes
Min. shutter speed
8 sec
4 sec
Max. shutter speed
1/2000 sec
1/2000 sec
Built-in flash
External flash
Viewfinder
None
Electronic
White balance presets
6
4
Screen size
2.5"
3"
Screen resolution
114,000 dots
920,000 dots
Video capture
Max. video resolution
1920x1080 (60p/60i/30p)
Storage types
Secure Digital
SD/SDHC/SDXC
USB
USB 1.0
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Lithium-Ion rechargeable
Li-ion Battery Pack (3.6V, 1250mAh, 4.5 Wh)
Weight
135 g
240 g
Dimensions
94 x 50 x 24 mm
110.6 x 64.3 x 34.4 mm
Year
2004
2014




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Panasonic FX7 diagonal

The diagonal of FX7 sensor is not 1/2.5 or 0.4" (10.2 mm) as you might expect, but approximately two thirds of that value - 7.19 mm. If you want to know why, see sensor sizes.

w = 5.75 mm
h = 4.32 mm
Diagonal =  5.75² + 4.32²   = 7.19 mm

Panasonic TZ60 diagonal

The diagonal of TZ60 sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm
Diagonal =  6.16² + 4.62²   = 7.70 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

FX7 sensor area

Width = 5.75 mm
Height = 4.32 mm

Surface area = 5.75 × 4.32 = 24.84 mm²

TZ60 sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

FX7 pixel pitch

Sensor width = 5.75 mm
Sensor resolution width = 2552 pixels
Pixel pitch =   5.75  × 1000  = 2.25 µm
2552

TZ60 pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 4906 pixels
Pixel pitch =   6.16  × 1000  = 1.26 µm
4906


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

FX7 pixel area

Pixel pitch = 2.25 µm

Pixel area = 2.25² = 5.06 µm²

TZ60 pixel area

Pixel pitch = 1.26 µm

Pixel area = 1.26² = 1.59 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

FX7 pixel density

Sensor resolution width = 2552 pixels
Sensor width = 0.575 cm

Pixel density = (2552 / 0.575)² / 1000000 = 19.7 MP/cm²

TZ60 pixel density

Sensor resolution width = 4906 pixels
Sensor width = 0.616 cm

Pixel density = (4906 / 0.616)² / 1000000 = 63.43 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

FX7 sensor resolution

Sensor width = 5.75 mm
Sensor height = 4.32 mm
Effective megapixels = 4.90
r = 5.75/4.32 = 1.33
X =  4.90 × 1000000  = 1919
1.33
Resolution horizontal: X × r = 1919 × 1.33 = 2552
Resolution vertical: X = 1919

Sensor resolution = 2552 x 1919

TZ60 sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 18.10
r = 6.16/4.62 = 1.33
X =  18.10 × 1000000  = 3689
1.33
Resolution horizontal: X × r = 3689 × 1.33 = 4906
Resolution vertical: X = 3689

Sensor resolution = 4906 x 3689


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


FX7 crop factor

Sensor diagonal in mm = 7.19 mm
Crop factor =   43.27  = 6.02
7.19

TZ60 crop factor

Sensor diagonal in mm = 7.70 mm
Crop factor =   43.27  = 5.62
7.70

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

FX7 equivalent aperture

Crop factor = 6.02
Aperture = f2.8 - f5

35-mm equivalent aperture = (f2.8 - f5) × 6.02 = f16.9 - f30.1

TZ60 equivalent aperture

Crop factor = 5.62
Aperture = f3.3 - f6.4

35-mm equivalent aperture = (f3.3 - f6.4) × 5.62 = f18.5 - f36

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.