Praktica Luxmedia 16-Z24S vs. Fujifilm X10

Comparison

change cameras »
Luxmedia 16-Z24S image
vs
X10 image
Praktica Luxmedia 16-Z24S Fujifilm X10
check price » check price »
Megapixels
16.10
12.00
Max. image resolution
4608 x 3456
4000 x 3000

Sensor

Sensor type
CCD
CMOS
Sensor size
1/2.3" (~ 6.16 x 4.62 mm)
2/3" (~ 8.8 x 6.6 mm)
Sensor resolution
4627 x 3479
3995 x 3004
Diagonal
7.70 mm
11.00 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 2.04
(ratio)
Praktica Luxmedia 16-Z24S Fujifilm X10
Surface area:
28.46 mm² vs 58.08 mm²
Difference: 29.62 mm² (104%)
X10 sensor is approx. 2.04x bigger than Luxmedia 16-Z24S sensor.
Pixel pitch
1.33 µm
2.2 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.87 µm (65%)
Pixel pitch of X10 is approx. 65% higher than pixel pitch of Luxmedia 16-Z24S.
Pixel area
1.77 µm²
4.84 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 3.07 µm² (173%)
A pixel on Fujifilm X10 sensor is approx. 173% bigger than a pixel on Praktica Luxmedia 16-Z24S.
Pixel density
56.42 MP/cm²
20.61 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 35.81 µm (174%)
Praktica Luxmedia 16-Z24S has approx. 174% higher pixel density than Fujifilm X10.
To learn about the accuracy of these numbers, click here.



Specs

Praktica Luxmedia 16-Z24S
Fujifilm X10
Crop factor
5.62
3.93
Total megapixels
Effective megapixels
16.10
12.00
Optical zoom
24x
4x
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 100, 200, 400, 800, 1600
Auto, 100, 200, 250, 320, 400, 500, 640, 800, 1000, 1250, 1600
RAW
Manual focus
Normal focus range
50 cm
Macro focus range
1 cm
Focal length (35mm equiv.)
25 - 600 mm
28 - 112 mm
Aperture priority
No
Yes
Max. aperture
f3 - f6.9
f2.0 - f2.8
Max. aperture (35mm equiv.)
f16.9 - f38.8
f7.9 - f11
Metering
Wide, center
Multi, Average, Spot
Exposure compensation
±2 EV (in 1/3 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
Yes
Min. shutter speed
4 sec
30 sec
Max. shutter speed
1/2000 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
None
Optical (tunnel)
White balance presets
6
7
Screen size
3"
2.8"
Screen resolution
460,800 dots
460,000 dots
Video capture
Max. video resolution
1920x1080 (30p)
Storage types
64 internal memory, compatible with memory cards
SD/SDHC/SDXC
USB
USB 2.0 (480 Mbit/sec)
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
Rechargeable Li-Ion battery
Lithium-Ion NP-50 rechargeable battery
Weight
120 g
350 g
Dimensions
93 x 55 x 20 mm
117 x 70 x 57 mm
Year
2012
2011




Choose cameras to compare

vs

Popular comparisons:

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal = √  w² + h²
where w = sensor width and h = sensor height

Praktica Luxmedia 16-Z24S diagonal

The diagonal of Luxmedia 16-Z24S sensor is not 1/2.3 or 0.43" (11 mm) as you might expect, but approximately two thirds of that value - 7.7 mm. If you want to know why, see sensor sizes.

w = 6.16 mm
h = 4.62 mm
Diagonal = √  6.16² + 4.62²   = 7.70 mm

Fujifilm X10 diagonal

The diagonal of X10 sensor is not 2/3 or 0.67" (16.9 mm) as you might expect, but approximately two thirds of that value - 11 mm. If you want to know why, see sensor sizes.

w = 8.80 mm
h = 6.60 mm
Diagonal = √  8.80² + 6.60²   = 11.00 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

Luxmedia 16-Z24S sensor area

Width = 6.16 mm
Height = 4.62 mm

Surface area = 6.16 × 4.62 = 28.46 mm²

X10 sensor area

Width = 8.80 mm
Height = 6.60 mm

Surface area = 8.80 × 6.60 = 58.08 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

Luxmedia 16-Z24S pixel pitch

Sensor width = 6.16 mm
Sensor resolution width = 4627 pixels
Pixel pitch =   6.16  × 1000  = 1.33 µm
4627

X10 pixel pitch

Sensor width = 8.80 mm
Sensor resolution width = 3995 pixels
Pixel pitch =   8.80  × 1000  = 2.2 µm
3995


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

Luxmedia 16-Z24S pixel area

Pixel pitch = 1.33 µm

Pixel area = 1.33² = 1.77 µm²

X10 pixel area

Pixel pitch = 2.2 µm

Pixel area = 2.2² = 4.84 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

Luxmedia 16-Z24S pixel density

Sensor resolution width = 4627 pixels
Sensor width = 0.616 cm

Pixel density = (4627 / 0.616)² / 1000000 = 56.42 MP/cm²

X10 pixel density

Sensor resolution width = 3995 pixels
Sensor width = 0.88 cm

Pixel density = (3995 / 0.88)² / 1000000 = 20.61 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X = √  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

Luxmedia 16-Z24S sensor resolution

Sensor width = 6.16 mm
Sensor height = 4.62 mm
Effective megapixels = 16.10
r = 6.16/4.62 = 1.33
X = √  16.10 × 1000000  = 3479
1.33
Resolution horizontal: X × r = 3479 × 1.33 = 4627
Resolution vertical: X = 3479

Sensor resolution = 4627 x 3479

X10 sensor resolution

Sensor width = 8.80 mm
Sensor height = 6.60 mm
Effective megapixels = 12.00
r = 8.80/6.60 = 1.33
X = √  12.00 × 1000000  = 3004
1.33
Resolution horizontal: X × r = 3004 × 1.33 = 3995
Resolution vertical: X = 3004

Sensor resolution = 3995 x 3004


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


Luxmedia 16-Z24S crop factor

Sensor diagonal in mm = 7.70 mm
Crop factor =   43.27  = 5.62
7.70

X10 crop factor

Sensor diagonal in mm = 11.00 mm
Crop factor =   43.27  = 3.93
11.00

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

Luxmedia 16-Z24S equivalent aperture

Crop factor = 5.62
Aperture = f3 - f6.9

35-mm equivalent aperture = (f3 - f6.9) × 5.62 = f16.9 - f38.8

X10 equivalent aperture

Crop factor = 3.93
Aperture = f2.0 - f2.8

35-mm equivalent aperture = (f2.0 - f2.8) × 3.93 = f7.9 - f11

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.