Samsung Digimax V50 vs. Ricoh Caplio R1
Comparison
| change cameras » | |||||
|
vs |
|
|||
| Samsung Digimax V50 | Ricoh Caplio R1 | ||||
| check price » | check price » | ||||
Megapixels
5.00
4.90
Max. image resolution
2592 x 1944
2304 x 1728
Sensor
Sensor type
CCD
CCD
Sensor size
1/1.8" (~ 7.11 x 5.33 mm)
1/1.8" (~ 7.11 x 5.33 mm)
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera.
Sensors can vary greatly in size. As a general rule, the bigger the
sensor, the better the image quality.
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.
Learn more about sensor sizes »
Actual sensor size
Note: Actual size is set to screen → change »
|
|
vs |
|
| 1 | : | 1 |
| (ratio) | ||
| Samsung Digimax V50 | Ricoh Caplio R1 | |
Surface area:
| 37.90 mm² | vs | 37.90 mm² |
Difference: 0 mm² (0%)
V50 and R1 sensors are the same size.
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Pixel or photosite area affects how much light per pixel can be gathered.
The larger it is the more light can be collected by a single pixel.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 0.16 µm² (2%)
A pixel on Ricoh R1 sensor is approx. 2% bigger than a pixel on Samsung V50.
Pixel density tells you how many million pixels fit or would fit in one
square cm of the sensor.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Higher pixel density means smaller pixels and lower pixel density means larger pixels.
To learn about the accuracy of these numbers,
click here.
Specs
Samsung V50
Ricoh R1
Total megapixels
5.30
5.20
Effective megapixels
5.00
4.90
Optical zoom
3.2x
4.8x
Digital zoom
Yes
Yes
ISO sensitivity
50, 100, 200, 400
Auto, 64, 100, 200, 400, 800
RAW
Manual focus
Normal focus range
80 cm
30 cm
Macro focus range
5 cm
1 cm
Focal length (35mm equiv.)
35 - 113 mm
28 - 135 mm
Aperture priority
No
No
Max. aperture
f2.8 - f4.9
f3.3 - f4.8
Metering
Centre weighted
Centre weighted, Evaluative, Spot
Exposure compensation
±2 EV (in 1/2 EV steps)
±2 EV (in 1/3 EV steps)
Shutter priority
No
No
Min. shutter speed
15 sec
8 sec
Max. shutter speed
1/2000 sec
1/2000 sec
Built-in flash
External flash
Viewfinder
Optical (tunnel)
Optical (tunnel)
White balance presets
6
6
Screen size
2"
1.8"
Screen resolution
117,000 dots
110,000 dots
Video capture
Max. video resolution
Storage types
Memory Stick Pro, Memory Stick Pro Duo, MultiMedia, Secure Digital
MultiMedia, Secure Digital
USB
USB 1.0
USB 1.0
HDMI
Wireless
GPS
Battery
3.7V Li-ion or 3V Lithium battery
Lithium-Ion rechargeable
Weight
230 g
150 g
Dimensions
106 x 56 x 37 mm
102 x 57 x 25 mm
Year
2004
2005
Choose cameras to compare
Popular comparisons:
- Samsung Digimax V50 vs. Olympus C-2100 UZ
- Samsung Digimax V50 vs. Nikon D780
- Samsung Digimax V50 vs. Samsung Digimax V600
- Samsung Digimax V50 vs. Samsung Digimax V70
- Samsung Digimax V50 vs. Sony Cyber-shot DSC-W800
- Samsung Digimax V50 vs. Ricoh Caplio R1
- Canon EOS 200D vs. Canon EOS 750D
- Canon EOS 1300D vs. Canon EOS 700D
- Canon EOS 600D vs. Canon EOS 1300D
- Canon EOS 800D vs. Canon EOS 750D
- Canon EOS 1300D vs. Canon EOS 1200D
Diagonal
Diagonal is calculated by the use of Pythagorean theorem:
where w = sensor width and h = sensor height
| Diagonal = √ | w² + h² |
Samsung V50 diagonal
The diagonal of V50 sensor is not 1/1.8 or 0.56" (14.1 mm) as you might expect, but approximately two thirds of
that value - 8.89 mm. If you want to know why, see
sensor sizes.
w = 7.11 mm
h = 5.33 mm
w = 7.11 mm
h = 5.33 mm
| Diagonal = √ | 7.11² + 5.33² | = 8.89 mm |
Ricoh R1 diagonal
The diagonal of R1 sensor is not 1/1.8 or 0.56" (14.1 mm) as you might expect, but approximately two thirds of
that value - 8.89 mm. If you want to know why, see
sensor sizes.
w = 7.11 mm
h = 5.33 mm
w = 7.11 mm
h = 5.33 mm
| Diagonal = √ | 7.11² + 5.33² | = 8.89 mm |
Surface area
Surface area is calculated by multiplying the width and the height of a sensor.
V50 sensor area
Width = 7.11 mm
Height = 5.33 mm
Surface area = 7.11 × 5.33 = 37.90 mm²
Height = 5.33 mm
Surface area = 7.11 × 5.33 = 37.90 mm²
R1 sensor area
Width = 7.11 mm
Height = 5.33 mm
Surface area = 7.11 × 5.33 = 37.90 mm²
Height = 5.33 mm
Surface area = 7.11 × 5.33 = 37.90 mm²
Pixel pitch
Pixel pitch is the distance from the center of one pixel to the center of the
next measured in micrometers (µm). It can be calculated with the following formula:
| Pixel pitch = | sensor width in mm | × 1000 |
| sensor resolution width in pixels |
V50 pixel pitch
Sensor width = 7.11 mm
Sensor resolution width = 2579 pixels
Sensor resolution width = 2579 pixels
| Pixel pitch = | 7.11 | × 1000 | = 2.76 µm |
| 2579 |
R1 pixel pitch
Sensor width = 7.11 mm
Sensor resolution width = 2552 pixels
Sensor resolution width = 2552 pixels
| Pixel pitch = | 7.11 | × 1000 | = 2.79 µm |
| 2552 |
Pixel area
The area of one pixel can be calculated by simply squaring the pixel pitch:
You could also divide sensor surface area with effective megapixels:
Pixel area = pixel pitch²
You could also divide sensor surface area with effective megapixels:
| Pixel area = | sensor surface area in mm² |
| effective megapixels |
V50 pixel area
Pixel pitch = 2.76 µm
Pixel area = 2.76² = 7.62 µm²
Pixel area = 2.76² = 7.62 µm²
R1 pixel area
Pixel pitch = 2.79 µm
Pixel area = 2.79² = 7.78 µm²
Pixel area = 2.79² = 7.78 µm²
Pixel density
Pixel density can be calculated with the following formula:
One could also use this formula:
| Pixel density = ( | sensor resolution width in pixels | )² / 1000000 |
| sensor width in cm |
One could also use this formula:
| Pixel density = | effective megapixels × 1000000 | / 10000 |
| sensor surface area in mm² |
V50 pixel density
Sensor resolution width = 2579 pixels
Sensor width = 0.711 cm
Pixel density = (2579 / 0.711)² / 1000000 = 13.16 MP/cm²
Sensor width = 0.711 cm
Pixel density = (2579 / 0.711)² / 1000000 = 13.16 MP/cm²
R1 pixel density
Sensor resolution width = 2552 pixels
Sensor width = 0.711 cm
Pixel density = (2552 / 0.711)² / 1000000 = 12.88 MP/cm²
Sensor width = 0.711 cm
Pixel density = (2552 / 0.711)² / 1000000 = 12.88 MP/cm²
Sensor resolution
Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher
than maximum (not interpolated) image resolution which is usually stated on camera specifications.
Sensor resolution is used in pixel pitch, pixel area, and pixel density formula.
For sake of simplicity, we're going to calculate it in 3 stages.
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
3. To get sensor resolution we then multiply X with the corresponding ratio:
Resolution horizontal: X × r
Resolution vertical: X
1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.
2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
| (X × r) × X = effective megapixels × 1000000 → |
|
Resolution horizontal: X × r
Resolution vertical: X
V50 sensor resolution
Sensor width = 7.11 mm
Sensor height = 5.33 mm
Effective megapixels = 5.00
Resolution horizontal: X × r = 1939 × 1.33 = 2579
Resolution vertical: X = 1939
Sensor resolution = 2579 x 1939
Sensor height = 5.33 mm
Effective megapixels = 5.00
| r = 7.11/5.33 = 1.33 |
|
Resolution vertical: X = 1939
Sensor resolution = 2579 x 1939
R1 sensor resolution
Sensor width = 7.11 mm
Sensor height = 5.33 mm
Effective megapixels = 4.90
Resolution horizontal: X × r = 1919 × 1.33 = 2552
Resolution vertical: X = 1919
Sensor resolution = 2552 x 1919
Sensor height = 5.33 mm
Effective megapixels = 4.90
| r = 7.11/5.33 = 1.33 |
|
Resolution vertical: X = 1919
Sensor resolution = 2552 x 1919
Crop factor
Crop factor or focal length multiplier is calculated by dividing the diagonal
of 35 mm film (43.27 mm) with the diagonal of the sensor.
| Crop factor = | 43.27 mm |
| sensor diagonal in mm |
V50 crop factor
Sensor diagonal in mm = 8.89 mm
| Crop factor = | 43.27 | = 4.87 |
| 8.89 |
R1 crop factor
Sensor diagonal in mm = 8.89 mm
| Crop factor = | 43.27 | = 4.87 |
| 8.89 |
35 mm equivalent aperture
Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture
with crop factor (a.k.a. focal length multiplier).
V50 equivalent aperture
Crop factor = 4.87
Aperture = f2.8 - f4.9
35-mm equivalent aperture = (f2.8 - f4.9) × 4.87 = f13.6 - f23.9
Aperture = f2.8 - f4.9
35-mm equivalent aperture = (f2.8 - f4.9) × 4.87 = f13.6 - f23.9
R1 equivalent aperture
Crop factor = 4.87
Aperture = f3.3 - f4.8
35-mm equivalent aperture = (f3.3 - f4.8) × 4.87 = f16.1 - f23.4
Aperture = f3.3 - f4.8
35-mm equivalent aperture = (f3.3 - f4.8) × 4.87 = f16.1 - f23.4
Enter your screen size (diagonal)
My screen size is
inches
Actual size is currently adjusted to screen.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.
If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.