Yakumo Mega Image 55cx vs. Olympus OM-D E-M10

Comparison

change cameras »
Mega Image 55cx image
vs
OM-D E-M10 image
Yakumo Mega Image 55cx Olympus OM-D E-M10
check price » check price »
Megapixels
5.00
16.10
Max. image resolution
2592 x 1944
4608 x 3456

Sensor

Sensor type
CCD
CMOS
Sensor size
1/1.8" (~ 7.11 x 5.33 mm)
Four Thirds (17.3 x 13 mm)
Sensor resolution
2579 x 1939
4627 x 3479
Diagonal
8.89 mm
21.64 mm
Sensor size comparison
Sensor size is generally a good indicator of the quality of the camera. Sensors can vary greatly in size. As a general rule, the bigger the sensor, the better the image quality.

Bigger sensors are more effective because they have more surface area to capture light. An important factor when comparing digital cameras is also camera generation. Generally, newer sensors will outperform the older.

Learn more about sensor sizes »

Actual sensor size

Note: Actual size is set to screen → change »
vs
1 : 5.93
(ratio)
Yakumo Mega Image 55cx Olympus OM-D E-M10
Surface area:
37.90 mm² vs 224.90 mm²
Difference: 187 mm² (493%)
OM-D E-M10 sensor is approx. 5.93x bigger than 55cx sensor.
Note: You are comparing sensors of very different generations. There is a gap of 9 years between Yakumo 55cx (2005) and Olympus OM-D E-M10 (2014). Nine years is a lot of time in terms of technology, meaning newer sensors are overall much more efficient than the older ones.
Pixel pitch
2.76 µm
3.74 µm
Pixel pitch tells you the distance from the center of one pixel (photosite) to the center of the next. It tells you how close the pixels are to each other.

The bigger the pixel pitch, the further apart they are and the bigger each pixel is. Bigger pixels tend to have better signal to noise ratio and greater dynamic range.
Difference: 0.98 µm (36%)
Pixel pitch of OM-D E-M10 is approx. 36% higher than pixel pitch of 55cx.
Pixel area
7.62 µm²
13.99 µm²
Pixel or photosite area affects how much light per pixel can be gathered. The larger it is the more light can be collected by a single pixel.

Larger pixels have the potential to collect more photons, resulting in greater dynamic range, while smaller pixels provide higher resolutions (more detail) for a given sensor size.
Relative pixel sizes:
vs
Pixel area difference: 6.37 µm² (84%)
A pixel on Olympus OM-D E-M10 sensor is approx. 84% bigger than a pixel on Yakumo 55cx.
Pixel density
13.16 MP/cm²
7.15 MP/cm²
Pixel density tells you how many million pixels fit or would fit in one square cm of the sensor.

Higher pixel density means smaller pixels and lower pixel density means larger pixels.
Difference: 6.01 µm (84%)
Yakumo 55cx has approx. 84% higher pixel density than Olympus OM-D E-M10.
To learn about the accuracy of these numbers, click here.



Specs

Yakumo 55cx
Olympus OM-D E-M10
Crop factor
4.87
2
Total megapixels
17.20
Effective megapixels
16.10
Optical zoom
Yes
Digital zoom
Yes
Yes
ISO sensitivity
Auto, 50, 100, 200, 400, 800
Auto, 200 - 25600
RAW
Manual focus
Normal focus range
23 cm
Macro focus range
10 cm
Focal length (35mm equiv.)
34 - 102 mm
Aperture priority
No
Yes
Max. aperture
f2.6 - f3.4
Max. aperture (35mm equiv.)
f12.7 - f16.6
n/a
Metering
Centre weighted
Multi, Center-weighted, Spot
Exposure compensation
±2 EV (in 1/2 EV steps)
±5 EV (in 1/3 EV, 1/2 EV, 1 EV steps)
Shutter priority
No
Yes
Min. shutter speed
1 sec
60 sec
Max. shutter speed
1/2000 sec
1/4000 sec
Built-in flash
External flash
Viewfinder
Optical
Electronic
White balance presets
7
Screen size
1.6"
3"
Screen resolution
85,000 dots
1,037,000 dots
Video capture
Max. video resolution
1920x1080 (30p)
Storage types
CompactFlash type I
SD/SDHC/SDXC
USB
USB 1.1
USB 2.0 (480 Mbit/sec)
HDMI
Wireless
GPS
Battery
4x AA
BLS-5 Li-ion battery
Weight
367 g
396 g
Dimensions
108 x 67 x 46 mm
119.1 x 82.3 x 45.9 mm
Year
2005
2014




Choose cameras to compare

vs

Diagonal

Diagonal is calculated by the use of Pythagorean theorem:
Diagonal =  w² + h²
where w = sensor width and h = sensor height

Yakumo 55cx diagonal

The diagonal of 55cx sensor is not 1/1.8 or 0.56" (14.1 mm) as you might expect, but approximately two thirds of that value - 8.89 mm. If you want to know why, see sensor sizes.

w = 7.11 mm
h = 5.33 mm
Diagonal =  7.11² + 5.33²   = 8.89 mm

Olympus OM-D E-M10 diagonal

w = 17.30 mm
h = 13.00 mm
Diagonal =  17.30² + 13.00²   = 21.64 mm


Surface area

Surface area is calculated by multiplying the width and the height of a sensor.

55cx sensor area

Width = 7.11 mm
Height = 5.33 mm

Surface area = 7.11 × 5.33 = 37.90 mm²

OM-D E-M10 sensor area

Width = 17.30 mm
Height = 13.00 mm

Surface area = 17.30 × 13.00 = 224.90 mm²


Pixel pitch

Pixel pitch is the distance from the center of one pixel to the center of the next measured in micrometers (µm). It can be calculated with the following formula:
Pixel pitch =   sensor width in mm  × 1000
sensor resolution width in pixels

55cx pixel pitch

Sensor width = 7.11 mm
Sensor resolution width = 2579 pixels
Pixel pitch =   7.11  × 1000  = 2.76 µm
2579

OM-D E-M10 pixel pitch

Sensor width = 17.30 mm
Sensor resolution width = 4627 pixels
Pixel pitch =   17.30  × 1000  = 3.74 µm
4627


Pixel area

The area of one pixel can be calculated by simply squaring the pixel pitch:
Pixel area = pixel pitch²

You could also divide sensor surface area with effective megapixels:
Pixel area =   sensor surface area in mm²
effective megapixels

55cx pixel area

Pixel pitch = 2.76 µm

Pixel area = 2.76² = 7.62 µm²

OM-D E-M10 pixel area

Pixel pitch = 3.74 µm

Pixel area = 3.74² = 13.99 µm²


Pixel density

Pixel density can be calculated with the following formula:
Pixel density =  ( sensor resolution width in pixels )² / 1000000
sensor width in cm

One could also use this formula:
Pixel density =   effective megapixels × 1000000  / 10000
sensor surface area in mm²

55cx pixel density

Sensor resolution width = 2579 pixels
Sensor width = 0.711 cm

Pixel density = (2579 / 0.711)² / 1000000 = 13.16 MP/cm²

OM-D E-M10 pixel density

Sensor resolution width = 4627 pixels
Sensor width = 1.73 cm

Pixel density = (4627 / 1.73)² / 1000000 = 7.15 MP/cm²


Sensor resolution

Sensor resolution is calculated from sensor size and effective megapixels. It's slightly higher than maximum (not interpolated) image resolution which is usually stated on camera specifications. Sensor resolution is used in pixel pitch, pixel area, and pixel density formula. For sake of simplicity, we're going to calculate it in 3 stages.

1. First we need to find the ratio between horizontal and vertical length by dividing the former with the latter (aspect ratio). It's usually 1.33 (4:3) or 1.5 (3:2), but not always.

2. With the ratio (r) known we can calculate the X from the formula below, where X is a vertical number of pixels:
(X × r) × X = effective megapixels × 1000000    →   
X =  effective megapixels × 1000000
r
3. To get sensor resolution we then multiply X with the corresponding ratio:

Resolution horizontal: X × r
Resolution vertical: X

55cx sensor resolution

Sensor width = 7.11 mm
Sensor height = 5.33 mm
Effective megapixels = 5.00
r = 7.11/5.33 = 1.33
X =  5.00 × 1000000  = 1939
1.33
Resolution horizontal: X × r = 1939 × 1.33 = 2579
Resolution vertical: X = 1939

Sensor resolution = 2579 x 1939

OM-D E-M10 sensor resolution

Sensor width = 17.30 mm
Sensor height = 13.00 mm
Effective megapixels = 16.10
r = 17.30/13.00 = 1.33
X =  16.10 × 1000000  = 3479
1.33
Resolution horizontal: X × r = 3479 × 1.33 = 4627
Resolution vertical: X = 3479

Sensor resolution = 4627 x 3479


Crop factor

Crop factor or focal length multiplier is calculated by dividing the diagonal of 35 mm film (43.27 mm) with the diagonal of the sensor.
Crop factor =   43.27 mm
sensor diagonal in mm


55cx crop factor

Sensor diagonal in mm = 8.89 mm
Crop factor =   43.27  = 4.87
8.89

OM-D E-M10 crop factor

Sensor diagonal in mm = 21.64 mm
Crop factor =   43.27  = 2
21.64

35 mm equivalent aperture

Equivalent aperture (in 135 film terms) is calculated by multiplying lens aperture with crop factor (a.k.a. focal length multiplier).

55cx equivalent aperture

Crop factor = 4.87
Aperture = f2.6 - f3.4

35-mm equivalent aperture = (f2.6 - f3.4) × 4.87 = f12.7 - f16.6

OM-D E-M10 equivalent aperture

Aperture is a lens characteristic, so it's calculated only for fixed lens cameras. If you want to know the equivalent aperture for Olympus OM-D E-M10, take the aperture of the lens you're using and multiply it with crop factor.

Crop factor for Olympus OM-D E-M10 is 2

Enter your screen size (diagonal)

My screen size is  inches



Actual size is currently adjusted to screen.

If your screen (phone, tablet, or monitor) is not in diagonal, then the actual size of a sensor won't be shown correctly.